1999 GMC C-SERIES engine

yellowblue
4-23
CAUTION:
Coasting downhill in NEUTRAL (N) or with the
ignition off is dangerous. Your brakes will have to
do all the work of slowing down. They could get
so hot that they wouldn't work well. You would
then have poor braking or even none going down
a hill. You could crash. Always have your engine
running and your vehicle in gear when you
go downhill.

Know how to go uphill. Use lower gears. They help
cool your engine and transmission, and you can
climb the hill better.
Stay in your own lane when driving on two
-lane
roads in hills or mountains. Don't swing wide or cut
across the center of the road. Drive at speeds that let
you stay in your own lane.

As you go over the top of a hill, be alert. There
could be something in your lane, like a stalled car
or an accident.

You may see highway signs on mountains that warn
of special problems. Examples are long grades,
passing or no
-passing zones, a falling rocks area,
winding roads and special truck lanes. Be alert to
these and take appropriate action.
ProCarManuals.com

yellowblue
4-27

Tie a red cloth to your mirror arm to alert police that
you've been stopped by the snow.

Put on extra clothing or wrap a blanket around you.
If you have no blankets or extra clothing, make body
insulators from newspapers, burlap bags, rags, floor
mats
-- anything you can wrap around yourself or
tuck under your clothing to keep warm.
You can run the engine to keep warm, but be careful.
CAUTION:
Snow can trap exhaust gases under your vehicle.
This can cause deadly CO (carbon monoxide) gas
to get inside. CO could overcome you and kill
you. You can't see it or smell it, so you might not
know it is in your vehicle. Clear away snow from
around the base of your vehicle if any is blocking
your exhaust pipe. And check around again from
time to time to be sure snow doesn't collect there.
Open a window just a little on the side of the
vehicle that's away from the wind. This will help
keep CO out.
Run your engine only as long as you must. This saves
fuel. When you run the engine, make it go a little faster
than just idle. That is, push the accelerator slightly. This
uses less fuel for the heat that you get and it keeps the
battery (or batteries) charged. You will need a
well
-charged battery (or batteries) to restart the vehicle,
and possibly for signaling later on with your headlamps.
Let the heater run for a while.
ProCarManuals.com

yellowblue
4-28
If you have a diesel engine, you may have to run it at a
higher speed to get enough heat. Then, shut the engine
off and close the window almost all the way to preserve
the heat. Start the engine again and repeat this only
when you feel really uncomfortable from the cold. But
do it as little as possible. Preserve the fuel as long as you
can. To help keep warm, you can get out of the vehicle
and do some fairly vigorous exercises every half hour or
so until help comes.Loading Your Vehicle
The GVW/Tire Information label is found on the rear
edge of the driver's door. The label shows the size of
your original tires and the inflation pressures needed to
obtain the gross weight capacity of your vehicle.
This is called the Gross Vehicle Weight Rating
(GVWR). The GVWR includes the weight of the
vehicle, all occupants, fuel and cargo.
ProCarManuals.com

yellowblue
4-31
Power Take-Off (PTO) (If Equipped)
Before using a PTO, refer to the body builder's or
operator's instructions.
To engage a PTO:
1. Make sure the vehicle is stopped.
2. Shift the transmission into NEUTRAL (N) or
PARK (P), if equipped.
3. The brake or clutch pedal must be pressed and
released once before PTO can be enabled. Do not
hold the brake or clutch pedal down.4. The cruise control switch must be in ON prior to
engaging the PTO switch to enable PTO operation.
This sets the PTO base engine idle at 1200 rpm.
5. Use SET/COAST to change the engine speed to the
lower preset value of 1400 rpm. Use
RESUME/ACCEL to change the engine speed to the
upper preset value of 1800 rpm. You may toggle
between upper and lower by moving the switch
between SET/COAST and RESUME/ACCEL.
The PTO will become inoperative when any of the
conditions are changed or the CHECK GAGES light
comes on.
ProCarManuals.com

5-
yellowblue
5-1
Section 5 Problems on the Road
Here you'll find what to do about some problems that can occur on the road.
5
-2 Hazard Warning Flashers
5
-3 Other Warning Devices
5
-5 Jump Starting
5
-9 Towing Your Vehicle
5
-18 Engine Overheating
5
-20 Cooling System (Gasoline Engine)5
-27 Cooling System (Diesel Engine)
5
-33 Engine Fan Noise
5
-34 If a Tire Goes Flat
5
-34 Changing a Flat Tire
5
-37 If You're Stuck: In Sand, Mud, Ice or Snow
ProCarManuals.com

yellowblue
5-6
If you have a diesel engine vehicle with two batteries
(or more), you should know before you begin that,
especially in cold weather, you may not be able to
get enough power from a single battery in another
vehicle to start your diesel engine.
If your vehicle has more than one battery, use the
battery that's closest to the starter
-- this will reduce
electrical resistance.
CAUTION:
If your vehicle has air conditioning, the auxiliary
electric fan under the hood can start up even
when the engine is not running and can injure
you. Keep hands, clothing and tools away from
any underhood electric fan.
2. Get the vehicles close enough so the jumper cables
can reach, but be sure the vehicles aren't touching
each other. You wouldn't be able to start your
vehicle, and the bad grounding could damage the
electrical systems.
3. Turn off the ignition on both vehicles. Turn off all
lamps that aren't needed, as well as radios. This willavoid sparks and help save both batteries, and it
could save your radio.
4. Locate the batteries on each vehicle. Find the
positive (+) and negative (
-) terminals on
each battery.
CAUTION:
Using a match near a battery can cause battery
gas to explode. People have been hurt doing this,
and some have been blinded. Use a flashlight if
you need more light.
Be sure the batteries have enough water. You
don't need to add water to the ACDelco
Freedom

battery (or batteries) installed in
every new GM vehicle. But if a battery has filler
caps, be sure the right amount of fluid is there.
If it is low, add water to take care of that first.
If you don't, explosive gas could be present.
Battery fluid contains acid that can burn you.
Don't get it on you. If you accidentally get it in
your eyes or on your skin, flush the place with
water and get medical help immediately.
ProCarManuals.com

yellowblue
5-7
5. Check that the jumper cables don't have loose or
missing insulation. If they do, you could get a shock.
The vehicles could be damaged, too.
Before you connect the cables, here are some basic
things you should know. Positive (+) will go to
positive (+) and negative (
-) will go to a metal
engine part or some other well
-grounded part. Don't
connect positive (+) to negative (
-) or you'll get a
short that would damage the battery and maybe
other parts, too.
CAUTION:
Fans or other moving engine parts can injure you
badly. Keep your hands away from moving parts
once the engine is running.
6. Connect the red
positive (+) cable to the
positive (+) terminal of
the vehicle with the
dead battery.
7. Don't let the other end
touch metal. Connect it to
the positive (+) terminal
of the good battery.
ProCarManuals.com

yellowblue
5-8
8. Now connect the black
negative (
-) cable to
the good battery's
negative (
-) terminal.
Don't let the other end touch anything until the next
step. The other end of the negative (
-) cable doesn't go
to the dead battery. It goes to a heavy, unpainted, metal
part on the engine, or some other well
-grounded part of
the vehicle with the dead battery.
9. Attach the cable at least
18 inches (45 cm) away
from the dead battery,
but not near engine parts
that move. The electrical
connection is just as
good there, but the
chance of sparks getting
back to the battery is
much less.
10. Now start the vehicle with the good battery and run
the engine for one to two minutes. If your vehicle
has the high idle option, use it.
11. Try to start the vehicle with the dead battery.
If it won't start after a few tries, it probably
needs service.
12. Remove the cables in reverse order to prevent
electrical shorting. Take care that they don't touch
each other or any other metal.
ProCarManuals.com