1999 GMC C-SERIES tire pressure

yellowblue
4-8
If there's a problem with the anti-lock brake system, the
anti
-lock brake system warning light will stay on. See
ªAnti
-Lock Brake System Warning Lightº in the Index.
Here's how anti-lock works. Let's say the road is wet.
You're driving safely. Suddenly an animal jumps out in
front of you.
You slam on the brakes. Here's what happens with ABS.A computer senses that wheels are slowing down. If one
of the wheels is about to stop rolling, the computer will
separately work the brakes at each wheel.
The anti
-lock system can change the brake pressure
faster than any driver could. The computer is
programmed to make the most of available tire and
road conditions.
You can steer around the obstacle while braking hard.
ProCarManuals.com

yellowblue
4-14
Loss of Control
Let's review what driving experts say about what
happens when the three control systems (brakes, steering
and acceleration) don't have enough friction where the
tires meet the road to do what the driver has asked.
In any emergency, don't give up. Keep trying to steer and
constantly seek an escape route or area of less danger.
Skidding
In a skid, a driver can lose control of the vehicle.
Defensive drivers avoid most skids by taking reasonable
care suited to existing conditions, and by not ªoverdrivingº
those conditions. But skids are always possible.
The three types of skids correspond to your vehicle's
three control systems. In the braking skid, your wheels
aren't rolling. In the steering or cornering skid, too
much speed or steering in a curve causes tires to slip and
lose cornering force. And in the acceleration skid, too
much throttle causes the driving wheels to spin.
A cornering skid and an acceleration skid are
usually best handled by easing your foot off the
accelerator pedal.Of course, traction is reduced when water, snow, ice,
gravel or other material is on the road. For safety, you'll
want to slow down and adjust your driving to these
conditions. It is important to slow down on slippery
surfaces because stopping distance will be longer and
vehicle control more limited.
While driving on a surface with reduced traction, try
your best to avoid sudden steering, acceleration or
braking (including engine braking by shifting to a lower
gear). See ªDiesel Engine Exhaust Brakeº in the Index
for information about using the exhaust brake on
slippery surfaces. Any sudden changes could cause the
tires to slide. You may not realize the surface is slippery
until your vehicle is skidding. Learn to recognize
warning clues
-- such as enough water, ice or packed
snow on the road to make a ªmirrored surfaceº
-- and
slow down when you have any doubt.
If you have the anti
-lock braking system, remember: It
helps avoid only the braking skid. If you do not have
anti
-lock, then in a braking skid (where the wheels are
no longer rolling), release enough pressure on the brakes
to get the wheels rolling again. This restores steering
control. Push the brake pedal down steadily when you
have to stop suddenly. As long as the wheels are rolling,
you will have steering control.
ProCarManuals.com

yellowblue
4-18 Hydroplaning
Hydroplaning is dangerous. So much water can build up
under your tires that they can actually ride on the water.
This can happen if the road is wet enough and you're
going fast enough. When your vehicle is hydroplaning,
it has little or no contact with the road.
Hydroplaning doesn't happen often. But it can if your
tires do not have much tread or if the pressure in one or
more is low. It can happen if a lot of water is standing on
the road. If you can see reflections from trees, telephone
poles or other vehicles, and raindrops ªdimpleº the
water's surface, there could be hydroplaning.
Hydroplaning usually happens at higher speeds. There
just isn't a hard and fast rule about hydroplaning. The
best advice is to slow down when it is raining.
Driving Through Deep Standing Water
NOTICE:
If you drive too quickly through deep puddles or
standing water, water can come in through your
engine's air intake and badly damage your
engine. Never drive through water that is slightly
lower than the underbody of your vehicle. If you
can't avoid deep puddles or standing water, drive
through them very slowly.
Some Other Rainy Weather Tips

Turn on your low-beam headlamps and your marker
and clearance lamps, if your vehicle has them
-- not
just your parking lamps
-- to help make you more
visible to others.

Besides slowing down, allow some extra following
distance. And be especially careful when you pass
another vehicle. Allow yourself more clear room
ahead, and be prepared to have your view restricted
by road spray.

Have good tires with proper tread depth.
(See ªTiresº in the Index.)
ProCarManuals.com

yellowblue
4-28
If you have a diesel engine, you may have to run it at a
higher speed to get enough heat. Then, shut the engine
off and close the window almost all the way to preserve
the heat. Start the engine again and repeat this only
when you feel really uncomfortable from the cold. But
do it as little as possible. Preserve the fuel as long as you
can. To help keep warm, you can get out of the vehicle
and do some fairly vigorous exercises every half hour or
so until help comes.Loading Your Vehicle
The GVW/Tire Information label is found on the rear
edge of the driver's door. The label shows the size of
your original tires and the inflation pressures needed to
obtain the gross weight capacity of your vehicle.
This is called the Gross Vehicle Weight Rating
(GVWR). The GVWR includes the weight of the
vehicle, all occupants, fuel and cargo.
ProCarManuals.com

yellowblue
5-15 Towing Your Vehicle From the Rear
(Rear Wheels Off the Ground)
Before Towing
Secure the steering wheel to maintain a straight
-ahead
position. Make certain that the front axle is not loaded
above the front axle Gross Axle Weight Rating (GAWR)
as indicated on the vehicle's Certification/Tire label.
After Towing
Block the rear wheels and release the steering. Apply the
parking brake system before disconnecting from the
towing vehicle.
Refer to the transmission shift label for
additional information.
Releasing Air-Operated Parking Brakes
If your vehicle has air brakes, you could have a special
towing problem. If your vehicle has to be towed because
you had a complete loss of air pressure from both
systems, the parking brakes may have applied. The tow
operator can release the brakes manually by using the
following steps. Then your vehicle can be towed with all
wheels or just the rear wheels on the ground.
ProCarManuals.com

yellowblue
5-34
If a Tire Goes Flat
It's unusual for a tire to ªblow outº while you're driving,
especially if you maintain your tires properly. If air goes
out of a tire, it's much more likely to leak out slowly.
But if you should ever have a ªblowout,º here are a few
tips about what to expect and what to do:
If a front tire fails, the flat tire will create a drag that
pulls the vehicle toward that side. Take your foot off the
accelerator pedal and grip the steering wheel firmly.
Steer to maintain lane position, and then gently brake to
a stop well out of the traffic lane.
A rear blowout, particularly on a curve, acts much like a
skid and may require the same correction you'd use in a
skid. In any rear blowout, remove your foot from the
accelerator pedal. Get the vehicle under control by
steering the way you want the vehicle to go. It may be
very bumpy and noisy, but you can still steer. Gently
brake to a stop
-- well off the road if possible.
If a tire goes flat, the next part tells you what to do.
Changing a Flat Tire
A flat or damaged tire can be a major roadside problem.
You're very likely to have to go for help. Few drivers of
these vehicles have the necessary equipment aboard to
be able to change a flat tire safely. For example, youhave to have a truck jack that can lift several thousand
pounds and a torque wrench that can generate several
hundred foot
-pounds (newton-meters) of twisting force.
So if you're stopped somewhere by a flat or damaged
tire or wheel, you should get expert help right then.
If the correct equipment is available, though, here is the
procedure to follow.

Does the tire still seem to have air under pressure in
it? If so, stand to the side and look at the wheel. See
if it looks like another wheel on the vehicle. If so, go
on to the next step. If it doesn't, or even if you can't
be sure, stop and get expert help.
CAUTION:
Tire-rim assemblies can explode. If you work on
a pressurized tire mounted on a damaged wheel,
the assembly can expand with explosive force
without warning. You and others nearby can be
badly injured. Don't work around a tire that has
air under pressure in it when its wheel is or might
be damaged.
ProCarManuals.com

yellowblue
5-35

If the wheel looks normal, see if the wheel has side
rings and a lock ring around the wheel rim. If so,
they must be seated properly. You can compare with
another wheel on the vehicle as you check for this.
For dual wheels, you have to look between the tires
to make this check. You may not be able to tell
if the side rings or lock rings are seated properly
by looking. If you can't be sure, stop and get
expert help.
CAUTION:
If you work on a pressurized tire mounted on a
damaged wheel, the assembly can expand with
explosive force without warning. You and others
nearby can be badly injured. Don't work around
a tire that has air under pressure in it when its
lock ring or side ring might not be
properly seated.
CAUTION:
Rust or dirt on the wheel, or on the parts to
which it is fastened, can make the wheel nuts
become loose after a time. The wheel could come
off and cause an accident. When you change a
wheel, remove any rust or dirt from the places
where the wheel attaches to the vehicle. In an
emergency, you can use a cloth or a paper towel
to do this; but be sure to use a scraper or wire
brush later, if you need to, to get all the rust or
dirt off.

If the lock ring and side rings seem to be seated
properly (or if the wheel doesn't have these), let the
air out of the tire. You can do this by taking out the
valve core.

If the flat or damaged tire is one of a dual set, let the
air out of both tires of the dual before you take off
the damaged tire and rim assembly.

If you have the correct equipment, put on the spare
wheel and tire assembly.
ProCarManuals.com

yellowblue
5-36
CAUTION:
Never use oil or grease on studs or nuts. If you
do, the nuts might come loose. Your wheel could
fall off, causing a serious accident.
CAUTION:

There are many ways to be hurt badly, or
be killed, while you are trying to change a
truck tire and rim. Follow all of the safety
precautions on the truck jack and
other equipment.
CAUTION: (Continued)
CAUTION: (Continued)

If you try to put air back into a tire that has
run flat, or even a tire that was quite low on
air, without first finding out why it was low
or flat, the tire can have a sudden air
-out.
This could cause you to lose control of the
vehicle and have a serious crash. Don't
refill a flat or very low tire with air without
first having the tire taken off the wheel and
checked for damage.

Use a clip-on chuck and hose extension when you
add air to your tires. You'll need an accurate truck
tire pressure gage. Stand to one side and add the air.
Be sure you don't go over the top inflation pressure
for the tire.
ProCarManuals.com