1998 TOYOTA LAND CRUISER brake

SA15C-02
F05438
123 (1,250, 91)

Oil Seal

O-Ring
Parking Brake Assembly
Disc
103 (1,050, 76)
Brake Caliper

Bearing Retainer

ABS Speed Sensor Rotor

Snap Ring
Bearing Case
Backing Plate
Serration Bolt

Oil Seal

Hub Bolt
Oil Deflector

Gasket
Axle Shaft
N´m (kgf´cm, ft´lbf): Specified torque

Non-reusable partx5
15 (150, 11)

Hub Bolt
Clip

Bearing Retainer

Plate Washer

Bearing
- SUSPENSION AND AXLEREAR AXLE SHAFT
SA-83
2033 Author
: Date
:
2004 LAND CRUISER (RM1071U)
REAR AXLE SHAFT
COMPONENTS

SA15I-06
SA-92
- SUSPENSION AND AXLEREAR AXLE SHAFT
2042 Author
: Date
:
2004 LAND CRUISER (RM1071U)
INSTALLATION
Installation is in the reverse order of removal (See page SA-84).
HINT:
After installation, fill the brake reservoir with brake fluid, bleed the brake system (See page BR-4), check
for leaks and check the ABS speed sensor signal (See page DI-505).

SA15D-02
F04386
SST
F04387
F04388
SA-84
- SUSPENSION AND AXLEREAR AXLE SHAFT
2034 Author
: Date
:
2004 LAND CRUISER (RM1071U)
REMOVAL
1. REMOVE REAR WHEEL
Torque: 131 N´m (1,340 kgf´cm, 97 ft´lbf)
2. DISCONNECT BRAKE LINE
Using SST, disconnect the brake line and remove the clip.
SST 09023-00100
Torque: 15 N´m (150 kgf´cm, 11 ft´lbf)
3. REMOVE BRAKE CALIPER AND DISC
Remove the 2 bolts, washers, brake caliper and disc.
Torque: 103 N´m (1,050 kgf´cm, 76 ft´lbf)
4. CHECK BEARING BACKLASH AND AXLE SHAFT
DEVIATION
(a) Using a dial indicator, check the backlash in the bearing
shaft direction.
Maximum: 0.6 mm (0.024 in.)
If the backlash exceeds the maximum, replace the bearing.
(b) Using a dial indicator, check the deviation at the surface
of the axle shaft outside the hub bolt.
Maximum: 0.05 mm (0.0020 in.)
If the deviation exceeds the maximum, replace the axle shaft.
5. REMOVE PARKING BRAKE ASSEMBLY
(See page BR-33)

SA15M-03
F05218
Pin
Clip
ClipParking Brake Cable
 Gasket
123 (1,250, 91)
Clip
 O-Ring
49 (500, 36)
Axle Shaft (RH)
Differential Carrier
 Gasket
Axle Shaft (LH)
72 (740, 53)
106 (1,080, 78)
x10
N´m (kgf´cm, ft´lbf): Specified torque
 Non-reusable part Gasket
15 (150, 11)
Propeller Shaft
Drain Plug

Filler Plug
49 (500, 36)
SA-98
- SUSPENSION AND AXLEREAR DIFFERENTIAL CARRIER
2048 Author
: Date
:
2004 LAND CRUISER (RM1071U)
REAR DIFFERENTIAL CARRIER
COMPONENTS

SA15R-1 1
SA-1 16
- SUSPENSION AND AXLEREAR DIFFERENTIAL CARRIER
2066 Author
: Date
:
2004 LAND CRUISER (RM1071U)
INSTALLATION
Installation is in the reverse order of removal (See page SA-100).
HINT:
After installation, fill the differential with hypoid gear oil (See page SA-95), fill the brake reservoir with brake
fluid, bleed the brake system (See page BR-4), check for leaks and check the ABS speed sensor signal (See
page DI-505).

SA15N-04
F04386
SST
F05217
F05080
Matchmarks
SA-100
- SUSPENSION AND AXLEREAR DIFFERENTIAL CARRIER
2050 Author
: Date
:
2004 LAND CRUISER (RM1071U)
REMOVAL
1. REMOVE 2 REAR WHEELS
Torque: 131 N´m (1,340 kgf´cm, 97 ft´lbf)
2. DRAIN HYPOID GEAR OIL
Torque: 49 N´m (500 kgf´cm, 36 ft´lbf)
3. DISCONNECT BRAKE LINES
(a) Using SST, disconnect the brake line and remove the clip.
SST 09023-00100
Torque: 15 N´m (150 kgf´cm, 11 ft´lbf)
(b) Employ the same manner described above to the other
side.
4. DISCONNECT PARKING BRAKE CABLES
(a) Remove the 2 clips, pin and disconnect the parking brake
cable from the bellcrank.
(b) Employ the same manner described above to the other
side.
5. REMOVE AXLE SHAFTS
(a) Remove the 4 nuts.
Torque: 123 N´m (1,250 kgf´cm, 90 ft´lbf)
(b) Pull out the axle shaft and remove the O-ring.
NOTICE:
Be careful not to damage the oil seal.
(c) Employ the same manner described above to the other
side.
6. DISCONNECT REAR PROPELLER SHAFT
(a) Place matchmarks on the propeller shaft and differential
flange.
(b) Remove the 4 nuts, bolts, washers and disconnect the
propeller shaft.
Torque: 106 N´m (1,080 kgf´cm, 78 ft´lbf)
(c) Support the propeller shaft securely.

SA15S-04
F05171
49 (500, 36)
 GasketFiller PlugPin
Clip
Clip
 Gasket
Drain Plug
49 (500, 36)
15 (150, 11)
Clip
 O-Ring
123 (1,250, 91)
 Gasket
106 (1,080, 78)
Axle Shaft (RH)
No. 1
Actuator
ProtectorDifferential
Carrier
Axle Shaft (LH)
72 (740, 53)
x10
N´m (kgf´cm, ft´lbf) : Specified torque
 Non-reusable partPropeller Shaft
15 (150, 11)
15 (150, 11)
36 (367, 27)

No. 2
Actuator
Protector
Parking Brake Cable
- SUSPENSION AND AXLEREAR DIFFERENTIAL CARRIER (w/ Diff. Lock)
SA-1 17
2067 Author
: Date
:
2004 LAND CRUISER (RM1071U)
REAR DIFFERENTIAL CARRIER (w/ Diff. Lock)
COMPONENTS

SA15X-09
SA-138
- SUSPENSION AND AXLEREAR DIFFERENTIAL CARRIER (w/ Diff. Lock)
2088 Author
: Date
:
2004 LAND CRUISER (RM1071U)
INSTALLATION
Installation is in the reverse order of removal (See page SA-100).
AFTER INSTALLATION, FILL DIFFERENTIAL WITH HYPOID GEAR OIL (See page SA-95)
HINT:
After installation, fill the differential with hypoid gear oil (See page SA-95), fill the brake reservoir with brake
fluid, bleed the brake system (See page BR-4), check for leaks and check the ABS speed sensor signal (See
page DI-505).