10. Install bush in housing.
Position a steel plate over the bush, ensuring the plate is
large enough to cover the rubber flange.
Operate the press to install the bush.
11. Ensure bush is fully seated in subframe.
The clearance between the bush flange and subframe
must not exceed 1.5 mm.
12. Ensure bush is aligned correctly in subframe as detailed in
Step 8 or 9 as appropriate.
13. Wipe off all excess adhesive from subframe and bush, and
remove masking tape.
14. NOTE: Allow adhesive at leas t 30 minutes to cure, before
installing subframe on vehicle.
Install suspension subframe on vehicle. Refer to 64..25.20.
