1998 BUICK PARK AVENUE Owners Manual

For the type of buib to use, see "Replacement Bulbs"
in the Index.
2. Unhook the cargo net
from the cargo net
retainer and remove the
retainer by turning it tc
the left.
3. Pull back the trunk trim panel.
ProCarManuals.com

4. Beneath the trim panel are three nuts that secure the
taillamp assembly. Remove these nuts with
a BO mm
wrench. Remove the nuts from only the side you
want
to access. The turn signal and a stoplamp can
now be accessed.
5. Pull the t~illmp assembly away from the vehicle.
6. Remove the bulb socket
assembly by turning
the
socket one-quarter of a
tun to the lek and
ProCarManuals.com

7. Once the socket has
been removed,
pull
the bulb straight out
to remove
it from
the socket.
8. Reverse the above steps to replace the
taiUamp assembly.
Turn
lamps, stoplamps and back-up bulbs are located
bekind the taillamp assembly along the trunk lid. The
following instructions explain how to access these bulbs.
ProCarManuals.com

1. There are four studs
located at the edge of the
trunk lid. Remove the
protective
vinyl caps
from the studs.
3. Next, there are eight fasteners along the top of tame
trunk lid (four on each side), holding the trunk trim
in place. Remove these fasteners.
6-42
ProCarManuals.com

. ..
4. Hold the treEnk trim back to expose the three mnaining
nuts holding the taillamp assembly in place.
5. From inside the tmnk compment, use a 10 mppl
wrench to remove the nuts from the studs.
ProCarManuals.com

IC.,. . - -.- .
9. Reverse the above steps
taillamp assembly.
7.
8. Once the socket has
been removed, pull
the bulb straight out
to remove it from
the socket.
to replace the
-44
ProCarManuals.com

Xeplacement blades come in digerent types and are
removed in different ways.
To replace the wiper blade assembly:
1. Position the wipers on the windshield in the “mid’’
wipe position.
windshield. Note:
The windshieid wiper does not
have a ’;ocking upright positior~ feature.
2. Lift the windshield wiper m away from the
3.
4.
5.
Push the tab OR the wiper biade assembly 2nd pull
the assembly dcwn enough to release it from the “U”
hooked end of the wiper m. Slide the assembly
away from the am.
Replace the blade.
TQ reinstall the wiper blade assembly, slide it, over
the wiper m to engage the “U” hooked end QII the
wiper
blade assembly. Full up on the assembly to
lock it into place.
For the correct windshield wiper blade replacement
length and type, see “Nomal Maintenance Replacement
Parts’’ in the Index.
ProCarManuals.com

77; I. .:. ._ $.Q-..l, li- Lfa
Your new vehicle comes with high-quality tires made by
a leading tire manufacturer. If you ever Rave questions
about YQW tire warranty md where to obtain service, see
your Buick Wmmty booklet for details.
Q
8
The Tire-Loading Infamation label, which is located on
the rear edge of the driver’s door shows the correct
inflation pressures for your tires when they’re cold.
“CoId” means your vehicle has been sitting for at least
three hours
OH driven no more than 1 mile (1.6 km).
ProCarManuals.com