E a bulb is burned out, replace it to help avoid itr~
accident. If the mows don’t go on at all when you
signal a turn, check the €use (see “‘Fuses md Circuit
Breakers” in the Index) and f~r burned-out bulbs.
If you have a trailer towing option with added wiring for
the trailer lamps, the signal indicator will flash even if a
turn signal bulb is burned aut. Check the front and rea
turn signal lamps regularly to make sure they are
workirzg. Note: You do not need to add a
different Basher.
If your turn signal is left on ~CZ more than 3/4 of a mile
(1.2 h), a chime will sound ai each flash of the turn
signal. To turn df the chime, move the turn signal lever
to the dTposition.
When the high beams are
on, a light the instrdment
panel wiil ~SQ be on. if
This feztuse lets you use your high-beam headlamps to
signal a driver in front of you that you want to pass. It
works even if your headamps xe 3ff.
To use it, pull the turn signal lever toward you, but not
so far that you hear a click.
If your headlamps are off or on low beam, your
high-beam headlamps will turn on. They’ll stay QPI as
long as you hold the Iever toward you and the
high-beam indicator on the dash will come on. Release
the Iever to turn the high-beam headlamps off.
ProCarManuals.com
5. Reverse the above steeps to reassemble ahe Bamp
assembly. The
fiont turn signal bulbs can be accessed by
removing
the headlamp assembly as described in
the previous procedure.
Once
the headlamp
assembly
has been removed,
reach
down from the top
of the vehicle and, while
pressing the
lock tab on the
socket,
turn the socket
onequarter
of a turn and
pull it out.
When reassembling the lamp, make sure
to align
the pin at the outboapd edge of the headlamp
assembly to
the plastic retainer at the outboard
edge
of the vehicle. Remove the
old bulb
by pulling it straight out of the
socket. Replace the bulb
md turn the bulb assembly
back into place.
ProCarManuals.com
4. Beneath the trim panel are three nuts that secure the
taillamp assembly. Remove these nuts with
a BO mm
wrench. Remove the nuts from only the side you
want
to access. The turn signal and a stoplamp can
now be accessed.
5. Pull the t~illmp assembly away from the vehicle.
6. Remove the bulb socket
assembly by turning
the
socket one-quarter of a
tun to the lek and
ProCarManuals.com
