F04167
SST Fulcrum
Length
R06400
SR4664
R07474
Clip
Clamp SR-50
- STEERINGPOWER STEERING GEAR
1934 Author: Date:
1997 SUPRA (RM502U)
(b) Using a spanner (22 mm) to hold the steering rack steady,
and using SST, torque the rack end.
SST 09922-10010
Torque: 77 N´m (782 kgf´cm, 57 ft´lbf)
NOTICE:
Use SST 09922-10010 in the direction shown in the illustra-
tion.
HINT:
Use a torque wrench with a fulcrum length of 380 mm (14.96
in.).
(c) Using a brass bar and a hammer, stake the washer.
NOTICE:
Avoid any impact to the rack.
16. INSTALL RH AND LH RACK BOOTS, CLAMPS AND
CLIPS
(a) Make sure that the steering rack hole is not clogged with
grease.
HINT:
If the hole is clogged, the pressure inside the boot will change
after it is assembled and the steering wheel turned.
(b) Install the boot.
NOTICE:
Be careful not to damage or twist the boot.
(c) Install the clamp and clip to the boot.
HINT:
When the rack guide spring cap is toward you, install the clip
and clamp in the positions shown in the illustration.
17. INSTALL RH AND LH TIE ROD ENDS AND LOCK NUTS
(a) Screw the lock nut and tie rod end onto the rack end until
the matchmarks are aligned.
(b) After adjusting toe-in, torque the nut (See page
SA-2).
Torque: 56 N´m (570 kgf´cm, 41 ft´lbf)
