1997 TOYOTA SUPRA oil filter

S00866
No.3 Timing Belt cover
Crankshaft Position Sensor
Oil Level Sensor ConnectorOil Filter Cap
Generator
Oil Strainer Oil Pump
 O-Ring
Turbo Oil Outlet Pipe Timing Belt
Plate
Crankshaft Timing Pulley
 Crankshaft Front Oil SealNo.1 Oil Pan Idler Pulley
 O-Ring

Drive Belt Tensioner
Bracket (M/T)
Timing Belt GuideOil Level Sensor
 Gasket
Timing Belt Tensioner No.1 Timing
Belt Cover
Crankshaft PulleyDust BootDrain Plug
 GasketNo.2 Oil Pan
Non-reusable part

Precoated part O-Ring
 Gasket
Timing Belt x 10
Oil Pan Baffle Plate Oil Dipstick
and Guide
Gasket
No.2 Timing
Belt Cover
Drive Belt
Tensionerx 6
x 5
x 14 x 16 2JZ-GTE
Gasket x 9
 Gasket
- LUBRICATIONOIL PUMP
LU-7
1454 Author
: Date
:
1997 SUPRA (RM502U)

LU04Q-01
B02884
Water Bypass HosePS Oil Reservoir
Engine Wire Protector

O-Ring
Oil Cooler
Plate Washer
Relief Valve
Oil Filter

Non-reusable part
- LUBRICATIONOIL COOLER (2JZ-GTE)
LU-19
1466 Author
: Date
:
1997 SUPRA (RM502U)
OIL COOLER (2JZ-GTE)
COMPONENTS

LU04R-01
P11555
P12215
30 mm
Socket
Wrench LU-20
- LUBRICATIONOIL COOLER (2JZ-GTE)
1467 Author
: Date
:
1997 SUPRA (RM502U)
REMOVAL
1. DISCONNECT PS OIL RESERVOIR WITHOUT
DISCONNECTING HOSES
(a) Disconnect the 2 clamps of the engine wire protector from
the bracket.
(b) Remove the 3 bolts and disconnect the reservoir.
2. DRAIN ENGINE COOLANT
3. REMOVE OIL FILTER
(See page LU-4)
4. DISCONNECT WATER BYPASS HOSES FROM OIL
COOLER
5. REMOVE OIL COOLER
(a) Remove the relief valve, plate washer and oil cooler.
(b) Remove the 2 O-rings from the oil cooler.

LU04T-02
P11208
New O-Ring LU-22
- LUBRICATIONOIL COOLER (2JZ-GTE)
1469 Author
: Date
:
1997 SUPRA (RM502U)
INSTALLATION
1. INSTALL OIL COOLER
(a) Install 2 new O-rings to the oil cooler.
(b) Apply a light coat of engine oil on the threads and under
the head of the relief valve.
(c) Temporarily install the oil cooler with the plate washer and
relief valve.
(d) Tighten the relief valve.
Torque: 78 N´m (800 kgf´cm, 58 ft´lbf)
2. CONNECT WATER BYPASS HOSES TO OIL
COOLER
3. CONNECT PS OIL RESERVOIR
4. INSTALL OIL FILTER
5. FILL WITH ENGINE COOLANT
6. START ENGINE AND CHECK FOR LEAKS
7. CHECK ENGINE OIL LEVEL

MA0688
MA01G-01
- MAINTENANCEENGINE
MA-5
42 Author
: Date
:
1997 SUPRA (RM502U)
ENGINE
INSPECTION
1. REPLACE TIMING BELT
(2JZ-GE: See page EM-17)
(2JZ-GTE: See page EM-19)
2. INSPECT DRIVE BELT
(See page CH-2)
3. REPLACE SPARK PLUGS
(2JZ-GE: See page IG-1)
(2JZ-GTE: See page IG-1)
4. INSPECT AIR FILTER
(a) Remove the air filter.
(b) Visually check that the air filter is not excessively dam-
aged or oily.
If necessary, replace the air filter.
(c) Clean the filter with compressed air.
First blow from the inside thoroughly, then blow off the
outside of the filter.
(d) Reinstall the air filter and air cleaner case.
5. REPLACE AIR FILTER
Replace the air filter with a new one.
6. REPLACE ENGINE OIL AND OIL FILTER
(See page LU-4)
7. REPLACE ENGINE COOLANT
(See page CO-2)
8. INSPECT CHARCOAL CANISTER
(2JZ-GE: See page EC-5)
(2JZ-GTE: See page EC-5)
9. REPLACE GASKET IN FUEL TANK CAP
(2JZ-GE: See page EC-5)
(2JZ-GTE: See page EC-5)
10. INSPECT FUEL LINES AND CONNECTIONS
(2JZ-GE: See page SF-32)
(2JZ-GTE: See page SF-34)
11. INSPECT EXHAUST PIPES AND MOUNTINGS
Visually check the pipes, hangers and connections for severe
corrosion, leaks or damages.
12. ADJUST VALVE CLEARANCE
(2JZ-GE: See page EM-4)
(2JZ-GTE: See page EM-4)

SS-8
- SERVICE SPECIFICATIONSENGINE MECHANICAL (2JZ-GE)
165 Author
: Date
:
1997 SUPRA (RM502U) Fuel pipe support x Cylinder block
2829021
Oil filter bracket x Cylinder block8890065
No.2 water bypass pipe x Water pump, Cylinder block2121015
Flywheel (M/T) x x Crankshaft 1st
2nd49
Turn 90°500
Turn 90°36
Turn 90°
Drive plate (A/T) x Crankshaft8385061
Clutch cover x Flywheel M/T1919514
Cylinder block x Transmission 14 mm head
17 mm head39
72400
73029
43
Drive plate x Torque converter clutch A/T3334025
Oil cooler tube x Union for transmission A/T3435025
Rear support member x Body2526019
Rear support member x Engine rear mounting insulator1313510
Front suspension crossmember x Engine mounting insulator5960043
Transmission shift lever x Shift lever retainer M/T1919514
Transmission control rod x Shift lever A/T131309
No.2 front exhaust pipe x Exhaust manifold6263046
Pipe support bracket x Transmission4344032
No.2 front exhaust pipe x Front exhaust pipe5859043
Clutch release cylinder x Transmission M/T131309
Ground strap (M/T) x Transmission3738027
A/C compressor x Cylinder block Stud bolt
Bolt and nut26
52265
53019
38
PS pump bracket x A/C compressor5859043
PS pump bracket x Cylinder block3940029
Fuel inlet hose x Fuel pipe support2930022
Front exhaust pipe x Center exhaust pipe5859043
Center exhaust pipe x Tailpipe1919514
Heated oxygen sensor x Front exhaust pipe2020014

SS0DN-02
SS-12
- SERVICE SPECIFICATIONSENGINE MECHANICAL (2JZ-GTE)
169 Author
: Date
:
1997 SUPRA (RM502U)
TORQUE SPECIFICATION
Part tightenedN´mkgf´cmft´lbf
Cylinder head cover x Cylinder head5.45548 in.´lbf
Timing belt plate x Oil pump7.88069in.´lbf
Idler pulley x Oil pump3435025
Crankshaft pulley x Crankshaft3243,300239
Camshaft timing pulley x Camshaft7981059
Timing belt tensioner x Oil pump2627020
PS pump front bracket (2JZ-GE) x PS vane pump5859043
PS pump front bracket (2JZ-GE) x A/C compressor5253038
PS pump pulley x PS vane pump4343032
Drive belt tensioner x Cylinder head2121015
Drive belt tensioner damper (M/T) x Tensioner arm2020014
Drive belt tensioner damper (M/T) x Tensioner bracket2020014
EGR cooler x Cylinder head8.89078 in.´lbf
Engine hanger x Cylinder head3940029
Camshaft position sensor x Cylinder head8.89078 in.´lbf
Cylinder head x Cylinder block 1st
2nd
3rd34
Turn 90°
Turn 90°350
Turn 90°
Turn 90°25
Turn 90°
Turn 90°
Camshaft bearing cap x Cylinder head2020014
No.4 timing belt cover x Cylinder head7.88069 in.´lbf
Intake manifold x Cylinder head2728020
Fuel input pipe x Delivery pipe4242030
Intake manifold stay x Intake manifold, Cylinder block3940029
Water outlet x Cylinder head2121015
Air intake chamber x Intake manifold2728020
PS pump rear stay x PS pump bracket3940029
PS vane pump x PS pump bracket5859043
Exhaust manifold x Cylinder head3940029
Pressure tank x Intake manifold2121015
Main bearing cap x Cylinder block 1st
2nd44
Turn 90°450
Turn 90°33
Turn 90°
Connecting rod cap x Connecting rod 1st
2nd29
Turn 90°300
Turn 90°22
Turn 90°
Oil nozzle x Cylinder block8.89078 in.´lbf
Rear oil seal retainer x Cylinder block5.96052 in.´lbf
Crankshaft position sensor x Cylinder block8.89078 in.´lbf
Engine mounting bracket x Cylinder block5859043
Engine coolant drain plug x Cylinder block2930022
Union for oil cooler x Cylinder block3940029
Union nut x Cylinder block5555041
Oil pressure switch x Cylinder block1415011
Knock sensor x Cylinder block4445033
Fuel pipe support x Cylinder block2829021
Oil filter bracket x Cylinder block8890065

SS0DZ-07
SS-26
- SERVICE SPECIFICATIONSLUBRICATION
183 Author
: Date
:
1997 SUPRA (RM502U)
TORQUE SPECIFICATION
Part tightenedN´mkgf´cmft´lbf
A/C compressor x Cylinder block Stud bolt
Bolt and nut26
52265
53019
38
Oil pressure switch x Cylinder block1415011
Drive belt tensioner Damper x Tensioner arm 2JZ-GTE M/T2020014
Drive belt tensioner Damper x Drive belt tensioner bracket
2JZ-GTE M/T
2020014
Oil drain plug x No.2 oil pan3837527
Oil pump body cover x Oil pump body101058
Plug x Oil pump body2JZ-GE
2JZ-GTE49
29500
30036
22
Oil pump x Cylinder block2121015
No.1 oil pan x Cylinder block 12 mm head
14 mm head21
39210
40015
29
Turbo oil outlet pipe (2JZ-GTE) x No.1 oil pan2728020
Oil pan baffle plate x No.1 oil pan8.89078 in.´lbf
Oil strainer x No.1 oil pan8.89078 in.´lbf
No.2 oil pan x No.1 oil pan8.89078 in.´lbf
Oil level sensor x No.1 oil pan5.45548 in.´lbf
Drive belt tensioner bracket (2JZ-GTE M/T) x Oil pump2728020
Crankshaft position sensor x Oil pump8.89078 in.´lbf
Oil cooler (2JZ-GTE) x Oil filter bracket7880058
Oil nozzle (2JZ-GTE) x Cylinder block8.89078 in.´lbf