6
Radio
POOR RECEPTION
Is the condition bad in comparison with other vehicle?
Are there any additional installation parts?
(Sun shade film, telephone antenna, etc.)
Check if there is any scratch and breaking of a wire on
the glass antenna and the defogger pattern.
(visual check. tester)
(See page BE-56)
Is the contact of the plug jack of the radio OK?
Does the condition get better by using the outer
antenna (such as pillar antenna)?
Is the contact of the antenna terminal on the glass
surface and the defogger terminal?
Is the continuity of the antenna cord OK?
Check the grounding of the antenna, antenna cord,
choke coil, and noise filter. (See page BE-72)
Does the condition get better by exchanging
the choke coil?
Does the condition get better by exchanging the
antenna cord?Take a measure for contact. An electric wave environment.
Does the condition get better if removing
them?
Influence of additional installation parts.
Influence of the sun shade film.
Repair. (See page BE-56)
Check the radio.
Take a measure for contact.
Grounding failure. Exchange the antenna cord.
Exchange the choke coil.
Exchange the antenna cord. Ye s
No
Exchange the glass.Ye s
Ye s
Ye s
Ye s
Ye s
Ye s
Ye s
Ye s No
No
No
NoNo
No
No
No
NG
OK
- BODY ELECTRICALAUDIO SYSTEM
BE-81
2059 Author: Date:
1997 SUPRA (RM502U)
Z16467
FIPG
R07455
SA-86
- SUSPENSION AND AXLEREAR DIFFERENTIAL CARRIER
1776 Author: Date:
1997 SUPRA (RM502U)
31. RECHECK BACKLASH, TOTAL PRELOAD AND
TOOTH CONTACT PATTERN (See page SA-74)
32. REMOVE DIFFERENTIAL CARRIER FROM OVER-
HAUL STAND, ETC.
33. INSTALL DIFFERENTIAL CARRIER COVER
(a) Clean the contact surfaces of the carrier and cover of any
residual FIPG material using cleaner.
(b) Coat FIPG to the carrier or cover.
FIPG:
Part No. 08826-00090, THREE BOND 1281 or equiva-
lent
NOTICE:
After installing the cover, wait at least 1 hour before filling
it with oil or running the vehicle.
(c) Install the carrier cover to the carrier with the 8 bolts.
Torque
2JZ-GTE M/T78 N´m (800 kgf´cm, 58 ft´lbf)
Others47 N´m (475 kgf´cm, 34 ft´lbf)
(d) Install the breather plug.
Torque: 21 N´m (210 kgf´cm, 15 ft´lbf)
