1997 TOYOTA SUPRA key

N08953
N08954
BE6219
Junction Block Side
Connector ºAº
- BODY ELECTRICALCOMBINATION METER
BE-51
2029 Author
: Date
:
1997 SUPRA (RM502U)
26. INSPECT INTEGRATION RELAY OPERATION
(a) Connect the positive (+) lead from the battery to terminals
1 and 7.
(b) Connect the positive (+) lead from the battery to terminal
9 through a 3.4 W test bulb.
(c) Check that the test bulb lights up and buzzer sounds for
4 - 8 seconds when the negative (-) lead from the battery
is connected to terminal 10.
(d) Check that the buzzer sounding in (c) stops when the
negative (-) lead from the battery is connected to terminl
8.
If operation is not as specified, replace the integration relay.
27. INSPECT RELAY CIRCUIT
Remove the relay from the junction block No. 1 and inspect the
connectors on the junction block side.
Tester connectionConditionSpecified condition
4 - GroundDriver's door openContinuity
4 - GroundDriver's door closeNo continuity
5 - GroundIgnition key SetContinuity
5 - GroundIgnition key removeNo continuity
8 - GroundDriver's seat belt fastenContinuity
8 - GroundDriver's seat belt unfastenNo continuity
10 - GroundConstantContinuity
1 - GroundConstantBattery positive voltage
9 - GroundIgnition switch position ONBattery positive voltage
9 - GroundIgnition switch position LOCK or ACCNo Voltage
If circuit is not as specified, tray replacing the relay with a new
one.

V08418
Turn ignition Key from LOCK position to ACC position.
Troubleshooting for ANTI-THEFT SYSTEM
Display A:
ID Number is set.Display E:
ANTI-THEFT SYSTEM opera-
tion condition. (ID number input
error 10 times or more.)Display B
ºSEC display disappears after 1
second.Radio switch ON.
Take to designated radio
service station.Display BDisplay D
Refer to each
malfunction item.Normal
operation.
Radio switch ON. Normal operation.
Cancel ID number, refer to each malfunction item.
Ye s
No
OK
NG
ANTI-THEFT SYSTEM operation condition. (ID number input error 9 times or less.)
Input ID number to cancel ANTI-THEFT SYSTEM, and check display.
Display A"B Display B Display E
Display C"A
Radio switch ON.Refer to each
malfunction item.Take to designated
radio service station.ANTI-THEFT SYSTEM not can-
celled. (ID number input error 10
times or less.)
Display D
ANTI-THEFT SYSTEM cancelled.
Check audio system again.Normal operation.
OK
NG
Cancel ID number, refer to each malfunction item.
Liquid Crystal Display (LCD) or VFD for Audio System
Display ºAº Display ºBº Display ºCº
Display ºDº Example:Display ºEº
2 DIN Type
1 DIN TypeBlank
No Illumination
2 DIN Type
1 DIN Type 2 DIN Type
1 DIN Type Error Times2 DIN Type 1 DIN Type
Radio Display
1 DIN Type 2 DIN Type
HINT:

Refer to Owner's Manual for operation details of ANTI-THEFT SYSTEM.

When the ID number has been cancelled, reset the same number after completing the operation, or
inform the customer that it has been cancelled.
BE-76
- BODY ELECTRICALAUDIO SYSTEM
2054 Author
: Date
:
1997 SUPRA (RM502U)

N19395
Instrument Panel Side No.3 Bracket
Instrument Panel
Reinforcement
AAAA
A N
LL
LLL A
Instrument Panel No.1 Brace
Steering
ColumnFinish Panel Mounting
No.5 Bracket
Instrument Panel Lower Mounting
No.1 Bracket
Instrument Panel
Side Defroster
No.2 Nozzle
Front Passenger
Assembly M
D
FF
FF
F
F
Instrument Panel Mounting
No.1 Bracket Instrument Panel
Lower Mounting
No.1 Bracket
Glove Box LampB
E B
E
Glove Compartment
Door Finish Plate
Instrument Panel
Box Finish Panel Mounting
No.4 Bracket Finish Panel
Mounting
No.3 BracketD
J
CJ
CD
Cluster Finish Panel
JJJJJ
Combination
Meter
Audio Receiver
Assembly
Cluster Finish
Center Panel
Cluster Finish Panel LHComputer Cover
Cluster Finish Panel RH
Key Cylinder Lamp H
J HH
H JF
25 (260, 19)
N´m (kgf´cm, ft´lbf): Specified torque
- BODYINSTRUMENT PANEL
BO-51
2131 Author
: Date
:
1997 SUPRA (RM502U)

FOR THE TOYOTA DEALER
COLLISION REPAIR INFORMATION
TITLE: SRS AIRBAG COMPONENT REPLACEMENT PAGE 1 of 6
SECTION: ELECTRICAL BULLETIN #79
MODELS: ALL
DATE: AUGUST 1997
After an airbag has been deployed during a collision, it will be necessary to replace certain
components of the airbag system. Technicians can identify these parts by using the
attached matrix.
If the airbag does not deploy, yet the combination meter (airbag warning light) stays on for
more that 10 seconds after the key is turned to the ªACCº or ªONº position, it is necessary
to perform a diagnostic test. Always refer to the Toyota repair manual for the correct repair
procedure.
The attached information includes:

A matrix indicating components requiring replacement (pages 2±4).

Parts replacement note (page 5).

An example repair manual page outlining the diagnostic procedure available in
each model specific repair manual (page 6).
Toyota recommends the use of electrical repair kit (P/N 00002±04200±01) for any wiring
repairs. This kit includes a selection of numerous repair connectors, terminal ends, a repair
procedures manual and special tools specific to Toyota. The
replacement electrical wire
and connector (from the wire harness to the front sensors) is P/N 82988±24010.
Toyota also offers a video package which shows the operation of the SRS airbag system
(P/N 00401±42994).
CAUTION: SRS Airbag service work can be performed only AFTER 90 SECONDS
from the time the ignition switch is turned to the ªlockº position and the
negative (±) terminal cable is disconnected from the battery.
NOTE: PLEASE ROUTE THIS BULLETIN TO YOUR COLLISION REPAIR CENTER
MANAGER!

FOR THE TOYOTA DEALER
COLLISION REPAIR INFORMATION
TITLE: SRS AIRBAG COMPONENT REPLACEMENT PAGE 1 of 4
SECTION: ELECTRICAL BULLETIN #83
MODELS: ALL
DATE: MAY 1998
After an airbag has been deployed during a collision, it will be necessary to replace certain
components of the SRS system. Technicians can identify these parts by using the attached
matrix.
If, after the vehicle has been completely repaired, the airbag warning light stays on for
more than 6 seconds while the key is turned to the ªACCº or ªONº position, it is necessary
to perform a diagnostic test. Always refer to the model±specific Toyota Repair Manual for
the correct repair procedure.
The attached information includes:

A matrix indicating components requiring replacement (page 3).

Parts replacement notes (page 4).

An example Repair Manual page outlining the diagnostic procedure available in
each model±specific Repair Manual (page 2).
On some vehicles the front sensors may be replaced. Please refer to the model±specific
repair manual concerning front airbag sensor replacement requirements before performing
this repair. Three part numbers are available for
replacement electrical wire and
connectors from the wire harness to the front SRS sensors. They are P/N 82988±24010,
82988±50010, and 82988±33010.
Toyota also offers a video package which outlines the operation of the SRS airbag system
(P/N 00401±42994).
NOTE: PLEASE ROUTE THIS BULLETIN TO YOUR COLLISION REPAIR CENTER
MANAGER!

FOR THE TOYOTA DEALER
COLLISION REPAIR INFORMATION
TITLE: SRS AIRBAG COMPONENT REPLACEMENT PAGE 1 of 6
SECTION: ELECTRICAL BULLETIN #79
MODELS: ALL
DATE: AUGUST 1997
After an airbag has been deployed during a collision, it will be necessary to replace certain
components of the airbag system. Technicians can identify these parts by using the
attached matrix.
If the airbag does not deploy, yet the combination meter (airbag warning light) stays on for
more that 10 seconds after the key is turned to the ªACCº or ªONº position, it is necessary
to perform a diagnostic test. Always refer to the Toyota repair manual for the correct repair
procedure.
The attached information includes:

A matrix indicating components requiring replacement (pages 2±4).

Parts replacement note (page 5).

An example repair manual page outlining the diagnostic procedure available in
each model specific repair manual (page 6).
Toyota recommends the use of electrical repair kit (P/N 00002±04200±01) for any wiring
repairs. This kit includes a selection of numerous repair connectors, terminal ends, a repair
procedures manual and special tools specific to Toyota. The
replacement electrical wire
and connector (from the wire harness to the front sensors) is P/N 82988±24010.
Toyota also offers a video package which shows the operation of the SRS airbag system
(P/N 00401±42994).
CAUTION: SRS Airbag service work can be performed only AFTER 90 SECONDS
from the time the ignition switch is turned to the ªlockº position and the
negative (±) terminal cable is disconnected from the battery.
NOTE: PLEASE ROUTE THIS BULLETIN TO YOUR COLLISION REPAIR CENTER
MANAGER!

DI4WW-01
THEFT DETERRENT SYSTEM Check Sheet
Inspector 's name:
Customer 's Name
Date of VehicleRegistration No.
Registration Year
Frame No.
Odometer Reading / /km
Mile
Weather Conditions
When Problem
Occurred Frequency Problem OccursWeather
Outdoor temperature
/ /

Constant
Sometimes ( Times per day, month)

Once only Brought in

Theft deterrent system cannot be set.

Indicator light does not flash when the theft deterrent system is set.
(It stays on or does not light at all.)

Theft deterrent system
does not operate.
When unlocked using the
door lock knob.

When the engine hood is
opened.

System cannot be
canceled once set.
When door is unlocked using key or wireless door lock control system.

When the key is inserted in the ignition key cylinder and turned to ACC or ON
position.
(However, only when the system has never operated)

When the luggage compartment door is opened with the key.

System cannot be
canceled during warning
operation.
When door is unlocked using key or wireless door lock control system.

When the key is inserted in the ignition key cylinder and turned to ACC or ON
position.

Warning operation starts when the system is set and the door or luggage compartment door is opened with
the key.

Others.
Date Problem First Occurred

Fine
Cloudy
Rainy
Snowy

Various/Others

Hot
Warm
Cool

Cold (Approx. 5F ( 5C))
Problem Symptom
Malfunction

Horns only

Theft deterrent horn only

Headlights only

Taillights only

Starter cut only

Door lock operation only
- DIAGNOSTICSTHEFT DETERRENT SYSTEM
DI-609
837 Author
: Date
:
1997 SUPRA (RM502U)
CUSTOMER PROBLEM ANALYSIS CHECK

DI4WX-01
DI-610
- DIAGNOSTICSTHEFT DETERRENT SYSTEM
838 Author
: Date
:
1997 SUPRA (RM502U)
PRE-CHECK
1. Setting Conditions:
SETTING OF THE THEFT DETERRENT SYSTEM
(a) Close all the doors.
(b) Close the engine hood and luggage compartment door.
(c) Remove the ignition key from the ignition key cylinder.
2. Setting Operation:
SETTING OF THE THEFT DETERRENT SYSTEM
When any of the following operations (a) or (c) is done, the theft deterrent indicator light will light up as de-
scribed.
(1) Lock the left or right front door using the key. (All doors are locked by key-interlinked lock opera-
tion)
(2) With the rear doors locked and with one of the front doors locked, lock the other front door without
using the key (keyless door lock).
Elapsed time after operationIndicator light
Within about 30 secondsLight up
After about 30 secondsBlinks *1
*1: 1 sec. on, 1 sec. off
HINT:
When the theft deterrent system is set, doors cannot be locked or unlocked with the door lock control switch
and the luggage compartment door cannot be unlocked with the luggage compartment door opener switch.
3. Cancelling Operation:
CANCELING OF THE THEFT DETERRENT SYSTEM IN THE SET CONDITION
HINT:

Check if the theft deterrent indicator light is blinking.

When any of the following operation (a), (b), (c) or (d) is done, the theft deterrent system is canceled
and indicator light will go off.
(a) Unlock the left or right front door using the key.
(b) Insert the ignition key in the ignition key cylinder and turn it to the ACC or ON position. (This is operative
only when the theft deterrent system has never operated.)
(c) Unlock the luggage compartment door with the key. *
1
*1: The theft deterrent systems is temporarily canceled only while the luggage compartment door is open.
Approximately 2 seconds after the luggage compartment door is closed, the theft deterrent system is reset.