GENERAL INSPECTION
1. INSPECT TIRE
(a)  Check the tires for wear and for the proper inflation pressure.
Cold tire inflation pressure (2JZ±GE)
 
 Tire size 
 
Front
kPa (kgf/cm2, psi)
 
 
Rear
kPa (kgf/cm2, psi)
 225/50ZR16 230 (2.3, 33) ±±
 245/50ZR16 ±± 250 (2.5, 36)
Cold tire inflation pressure (2JZ±GTE)
 
 
Tire size 
 
Front
kPa (kgf/cm2, psi)
 
 
Rear
kPa (kgf/cm2, psi)
 235/45ZR17 250 (2.5, 36) ±±
 255/40ZR17 ±± 250 (2.5, 36)
(b)  Check the tire runout.
Tire runout:
Less than 1.4 mm (0.055 in.)
2.  INSPECT WHEEL BALANCE
(a)  Check and adjust the Off±the±car  balance.
(b)  If necessary, check and adjust the On±the±car balance.
Unbalance after adjustment:
5.0 g (0.011 lb) or less
3.  CHECK WHEEL BEARING LOOSENESS
(a)  Check the backlash in bearing shaft direction.
Maximum: 0.05 mm (0.0020 in.)
(b)  Check the axle hub deviation.
Maximum: 0.05 mm (0.0020 in.)
4.  CHECK FRONT SUSPENSION FOR LOOSENESS
5.  CHECK STEERING LINKAGE FOR LOOSENESS
6.  CHECK BALL JOINT FOR LOOSENESS
7.  CHECK SHOCK ABSORBER WORK PROPERLY
wCheck for oil leak
wCheck mounting bushings for wear
wBounce front and rear of the vehicle
± SUSPENSION AND AXLEGENERAL INSPECTIONSA±3 
Cold tire
inflation
pressure
Vehicle height
Front wheel
alignment
Front axle hub
Front
suspension
Rear wheel
alignment
Rear axle hub
Rear
suspension
Rear
drive shaft
Toe±in
Camber
Caster
Steering axis
inclination
Wheel angle
(Max.)
Tie rod end left±right error
Bearing axial direction play
Upper ball joint turning torque
Axle hub flange runout
Bearing axial direction play
Stabilizer bar link ball joint turning torque
Lower ball joint turning torque
Axle hub flange runout
Stabilizer bar link ball joint turning torque
Lower ball joint turning torque
Lower ball joint turning torque
Toe±in
Camber
SERVICE SPECIFICATIONS
SERVICE DATA
± SUSPENSION AND AXLESERVICE SPECIFICATIONSSA±99