Page 21 of 2492
AD4 4
ELF RENAULT MATIC D2 (D20104)
or use: MOBIL ATF 220 (D20104 or D21412)
TEXAMATIC 4011
Automatic
transmission
VALUES AND SETTINGS
Capacity - Grades
07
3 .4 Manual gearboxComponents
Capacity in
litresGradeFeatures
JB1 3 .4
Brake circuit
Brake fluids must be approved by the Technical
DepartmentSAE J 1703
and DOT 3
All countries: TRANSELF TRX 75 W 80 W
( API GL5 or MIL-L 2105 C or D standards)
Normal : 0.7
ABS : 1
Fuel tankapproximately
60
Unleaded
petrol/diesel
JB3
Separate
reservoir
1.1
Cooling circuit
F3R
F8Q
E7J - K7M
GLACÉOL RX
(type D)
Only add coolant
7
7 .5
6
Power assisted
steeringELF RENAULT MATIC
D2 or
MOBIL ATF 220
07-4
Page 43 of 2492

Contents
Consumables
Identification
Oil consumption
Oil pressure
Engine - Gearbox
Engine and transmission assembly
Sump10-1
10-1
10-2
10-3
10-4
10-19
10-43
TOP AND FRONT OF ENGINE
Timing belt
Cylinder head gasketPage Page
11
Engine and
peripherals
11-1
11-12 ENGINE AND PERIPHERALS
10FUEL SUPPLY - PUMPS -
PREHEATING
Fuel supply
Fuel cut-out on impact
Fuel gallery
Injectors
Fuel filter
Pump flow
Supply pressure
Diesel equipment
Specifications
Description of the pump
Tightening torques (in daN.m)
Special notes
Idle speed settings
Microswitches
Pump
Pump - timing
Coded solenoid valve
Operating diagram
Pre-post-heating unit
Injector holder - heater plug
Fuel filter
Coolant temperature sensor
Inlet - exhaust manifolds
Pump
Brake assistance vacuum pump
Mechanical power assisted steering
pump13-1
13-3
13-8
13-9
13-10
13-11
13-15
13-16
13-17
13-18
13-20
13-22
13-23
13-27
13-28
13-29
13-30
13-36
13-37
13-39
13-40
13-41
13-4213
FUEL MIXTURE
Specifications
Throttle body
Inlet manifold
Exhaust manifold
Manifolds12-1
12-7
12-15
12-18
12-2012
Page 115 of 2492
TOP AND FRONT OF ENGINE
Cylinder head gasket
11 F3R ENGINE
Remove:
- the timing belt (see section 11-Timing belt),
- the spark plug caps.
98899R
98900S
Disconnect:
- the pinking sensor,
- the cylinder reference sensor,
- the absolute pressure sensor and its pipe,
- the idle speed valve,
- the air and coolant sensors,
- the throttle potentiometer,
- the injectors,
- the canister solenoid valve pipe,
- the oil vapour rebreathing pipe,
- the brake servo pipe,
- the accelerator cable,
- the fuel supply and return pipes (gallery end),
- the coolant temperature sensor (9).
Remove:
- the air filter,
- hoses 3, 4, 5, 6, 7, 8,
99222R
11-17
Page 126 of 2492

FUEL MIXTURE
Specifications
12
Vehicle GearboxEngine
Type SuffixBore
(mm)Stroke
(mm)Capacity
(cm
3)RatioCatalytic
converterDepollution
standard
BA0E JB1 E7J 764 75.8 77 1 390 9.1/1 C44 EU 96
* For a coolant temperature greater than 80°C and at stable engine speed of 2 500 rpm for
approximately 30 seconds.
** For legislative values, refer to specification for individual country.
*** Compatible with OR 91 unleaded.
Temperature in °C (± 1°) 0 20 40 80 90
Air temperature sensor
Type CTN
Resistance in Ohms7 470
to 11 9703 060
to 4 0451 315
to 1 600--
Coolant temperature sensor
Type CTN
Resistance in Ohms-3 060
to 4 0451 315
to 1 600300 to 370 210 to 270
Engine
Type SuffixTests carried out at idle speed*
Engine
speed
(rpm.)Emission of pollutants **
CO (%) CO
2 (%) HC (ppm) Lambda (λ)Fuel ***
(minimum octane
rating)
E7J 764 750±500.3
maximum14.5
minimum100
maximum0.97<λ<1.03 Unleaded (OR 95)
Engine
Type SuffixComputer Supplier’s No.Homologation
No.RENAULT No.
(G70*)
E7J 764 SIEMENS 35 tracks (FENIX 3) S 111 730 108 B 77 00 864 451 77 00 874 461
12-1
Page 128 of 2492

FUEL MIXTURE
Specifications
12
Vehicle GearboxEngine
Type SuffixBore
(mm)Stroke
(mm)Capacity
(cm
3)RatioCatalytic
converterDepollution
standard
BA0F Manual K7M 702 79.5 80.5 1598 9.7/1 C45 EU 96
BA0F
AutomaticK7M 703 79.5 80.5 1598 9.7/1 C45 EU 96
BA0L Manual K7M 720 79.5 80.5 1598 9/1 C45 EU 96
* For a coolant temperature greater than 80°C and at stable engine speed of 2 500 rpm for
approximately 30 seconds.
** For legislative values, refer to specification for individual country.
*** Compatible with OR 91 unleaded.
Temperature in °C (± 1°) 0 20 40 80 90
Air temperature sensor
Type CTN
Resistance in Ohms7 470
to 11 9703 060
to 4 0451 315
to 1 600--
Coolant temperature sensor
Type CTN
Resistance in Ohms-3 060
to 4 0451 315
to 1 600300 to 370 210 to 270
Engine
Type SuffixTests carried out at idle speed*
Engine
speed
(rpm.)Emission of pollutants**
CO (%) CO
2 (%) HC (ppm) Lambda (λ)Fuel ***
(minimum octane
rating)
K7M702
720720±500.3
maximum14.5
minimum100
maximum0.97<λ<1.03 Unleaded (OR 95)
K7M 703 750±500.3
maximum14.5
minimum100
maximum0.97<λ<1.03 Unleaded (OR 95)
Engine
Type SuffixComputer Supplier’s No.Homologation
No. RENAULT No.
(G70*)
K7M 702 SIEMENS 55 tracks (FENIX 5) S 105 300 101 D 77 00 860 319 77 00 863 499
K7M 703 SIEMENS 55 tracks (FENIX 5) S 105 300 201 C 77 00 860 337 77 00 869 818
K7M 720 SIEMENS 55 tracks (FENIX 5) S 105 300 104 B 77 00 864 454 77 00 865 827
12-3
Page 130 of 2492

FUEL MIXTURE
Specifications
12
Vehicle GearboxEngine
Type SuffixBore
(mm)Stroke
(mm)Capacity
(cm
3)RatioCatalytic
converterDepollution
standard
BA0G Manual F3R 750 82.7 93 1998 9.8/1 C47 EU 96
* For a coolant temperature greater than 80°C and at stable engine speed of 2 500 rpm for
approximately 30 seconds.
** For legislative values, refer to specification for individual country.
*** Compatible with OR 91 unleaded.
Temperature in °C (± 1°) 0 20 40 80 90
Air temperature sensor
Type CTN
Resistance in Ohms7 470
to 11 9703 060
to 4 0451 315
to 1 600--
Coolant temperature sensor
Type CTN
Resistance in Ohms-3 060
to 4 0451 315
to 1 600300 to 370 210 to 270
Engine
Type SuffixTests carried out at idle speed*
Engine
speed
(rpm.)Emission of pollutants **
CO (%) CO
2 (%) HC (ppm) Lambda (λ)Fuel ***
(minimum octane
rating)
F3R 750 770±500.3
maximum14.5
minimum100
maximum0.97<λ<1.03 Unleaded (OR 95)
Engine
Type SuffixComputer Supplier’s No.Homologation
No. RENAULT No.
(G70*)
F3R 750 SIEMENS 55 tracks (FENIX 5) S 103 717 101 B 77 00 868 299 77 00 874 462
12-5
Page 140 of 2492
FUEL MIXTURE
Inlet manifold
12
E7J engine
Manifold nuts 2.5
TIGHTENING TORQUES (in daN.m)
REMOVAL
To remove the manifold, the throttle body must
be removed (see previous pages).
There are no special notes for removal.
The inlet manifold is fitted with an electrical
heater (2) with a PTC type resistance (positive
temperature coefficient).
This is mounted in the inlet manifold, opposite
the throttle, and is secured by a circlip.
The heater is fed via a relay by the computer up to
a coolant temperature of 68°C.
If the coolant temperature sensor is faulty, the
heater is permanently fed.
PRM1202
1Retaining circlip.
2 Electrical heater.
3Seal.
REFITTING
When refitting, replace the manifold gasket and
bleed the cooling circuit.
12-15
Page 151 of 2492
99238R1
FUEL SUPPLY
Fuel gallery
13
Throttle body mounting bolt on manifold 2
Fuel gallery mounting nut 1
TIGHTENING TORQUES (in daN.m)
REMOVAL
Disconnect the battery.
Remove the acoustic tie bar.
Disconnect:
- the air temperature sensor (1),
- the pressure sensor (3),
- the throttle potentiometer (4),
- the cylinder reference sensor (6),
- the fuel vapour recirculation pipe (11),
- the brake servo vacuum pipe (10),
- from the manifold, the pressure sensor
vacuum pipe (7).
Slacken the clip mounting the air sleeve to the
throttle body.
Remove the three nuts mounting the air filter.
99213R1
Remove the filter and the air sleeve.
Disconnect:
- the oil vapour rebreathing pipe (9),
- the coolant temperature sensor (2),
- the idle speed regulation solenoid valve (5). F3R engine
13-5