TRIMS OF OPENINGS OTHER THAN SIDE DOORS
Exterior hood trim
73
RR R R
EE E E
MM M M
OO O O
VV V V
AA A A
LL L L
Place the rear frame in a vertical position.
Seat the rear formed section (12) in the rear
frame.
Rivet (Ø 4×12) the side tensioning strap (10) to
the main control rod.
Pass the side tensioning cable (9) into the exterior
trim, rivet it (Ø 3×8) to the front crossmember.
Seat:
- the side formed section (8) on the front cross-
member,
- the front formed section (6) on the front
frame.
Fold the hood.
Clip the front formed section tightening wrench
(5).
Place the hood in the neutral position.
Secure:
- the side tensioning strap (7) to the main
frame,
- the main frame seal (4).
Place the rear frame in a vertical position.
Seat:
- the rear seal (12) on the rear frame,
- the front crossmember side seal (2).
Clip and clamp the front frame cover, secure the
handle, close the hood.
Adjustment of the windscreen aperture seal -
front crossmember side seal.
A clearance of 1 mm must be obtained between
the two seals by sliding the side seal.
In the event of sideways offset, slide the winds-
creen aperture seal as necessary after unseating it
at the front locks.
73-4
