Page 924 of 2492
83
INSTRUMENT PANEL
Fuel level sensor
Page 1915 of 2492
GENERAL
Engine and equipment
40
(1) If necessary, unleaded fuel with an octane rating of 91 may be used.
Vehicle
typeVersionEngine
Type Ratio InjectionCapacity
(cm
3)Idle speed
(rpm)Fuel type
KA0M
KA0V1.4 l E7J 9.5/1 Multipoint 1390Non-
adjustableUnleaded
95 or 98 (1)
KA0W
KA0D1.4 l
16 VK4J 10/1 Multipoint 1390Non-
adjustableUnleaded
95 or 98 (1)
KA04
KA0B1.6 l
16 VK4M 10/1 Multipoint 1598Non-
adjustableUnleaded
95 or 98 (1)
KA0J
VA0J1.9 l D F8Q 21.5/1 Indirect 1870 825±50 Diesel
KA05
VA05
KA0N
VA0N
KA01
VA011.9 l
DtiF9Q
Turbo18.3/1 Direct 1870850±50
Non-
adjustableDiesel
Vehicle Rim TyresTyre inflation pressure -
cold (bar) (1)
Front Rear
KA0M/KA0V
KA0W/KA0D5.5 J 14 175/70 R 14 2.2 2.0
KA04/KA0B6.0 J 15 185/60 R 15 2.2 2.0
KA0J/VA0J6.0 J 15 175/70 R 14 2.2 2.0
KA0N/VA0N
KA05/VA05
KA01/VA01
6.0 J 15 185/60 R 15 2.2 2.0
(1) Fully laden and motorway use.
Tightening torque for wheel nuts : 9 daN.m
Rim run-out: 1.2 mm
Identification
40-2
Page 2427 of 2492
UPPER REAR STRUCTURE
Rear wing panel
44S
144UPPER REAR STRUCTURE
Rear wing panel
INTRODUCTION
The replacement of this part is a basic operation for a
rear side impact.
For the method for replacing this part, see the basic
Workshop Repair Manual.
The rear wing panel is delivered by the Parts
Department with the welded pins for mounting the
plastic fittings panels.
The dimensions of the holes drilled and and the
welded pins are given below for your information.
COMPOSITION OF THE PART FROM THE PARTS
DEPARTMENT
Part assembled with:
– bumper side mounting reinforcement,
– striker plate stiffener, rear door,
– plate cage,
– plate,
– sound-deadening material,
– fuel pipe unit (right side).
– welded nuts,
– lower blanking cover,
– welded pins.
PRF4418
44-1
A
Page 2477 of 2492
EXTERIOR PROTECTION
Rear wing extender
55PRear wing extender
REMOVING THE RIGHT HAND EXTENDER
After removing the rear section of the valance
protector (section 55-B),
Remove:
– mounting bolt (A),– two mounting bolts (B),
– the fuel filler flap,
– two mounting bolts (C),
PRF5516
18065R17541R
17516-2R
55-8
D
