1995 OLDSMOBILE AURORA Owners Manual

At Least Once a Year Starter Switch
Key Lock Cylinders
Lubricate the key lock cylinders with the lubricant
specified
in Part D.
Body Lubrication
Lubricate all body door hinges. Also lubricate all hinges
and latches, including those for the hood, rear
compartment, glove box door, console door and any
folding seat hardware. Part
D tells you what to use.
More frequent lubrication may be required when
exposed to
a corrosive environment.
I. Before you start, be sure you have enough room
2. Firmly apply both the parking brake (see “Parking
around
the vehicle.
Brake’‘
in the Index if necessary) and the regular
brake.
NOTE: Do not use the accelerator pedal. and be
ready to turn
off the engine immediately if it starts.
should work only in
PARK (P) or NEUTRAL (N). If
the starter works in any other position, your vehicle
needs service.
3. Try to start the engine in each gear. The starter
7-37
ProCarManuals.com

Brake-Transaxle Shift Interlock -- BTSI
1.
2.
3.
Before you start, be sure you have enough room
around the vehicle.
It should be parked on a level
surface.
Firmly apply the parking brake (see "Parking Brake"
in the Index if necessary).
NOTE: Be ready to apply the regular brake
immediately
if the vehicle begins to move.
With the engine
off, turn the key to the RUN
position, but don't start the engine. Without applying
the regular brake,
try to move the shift lever out of
PARK (P) with normal effort. If the shift lever
moves out
of PARK (P), your vehicle's BTSI needs
service.
Steering Column Lock
While parked, and with the parking brake set, try to turn
the key
to LOCK in each shift lever position.
0 The key should turn to LOCK only when the shift
lever
is in PARK (P).
0 The key should come out only in LOCK.
Parking Brake and Automatic Transaxle PARK (P)
Mechanism Check
7-3s
ProCarManuals.com

Park on a fairly steep hill, with the vehicle facing
downhill. Keeping your foot
011 the regular brake, set the
parking brake.
0 To check the parking brake: With the engine running
and transaxle in NEUTRAL (N). slowly remove foot
pressure from the regular brake pedal. Do this until
the vehicle is held by the parking brake only.
0 To check the PARK (P) mechanism’s holding ability:
Shift
to PARK (P). Then release all brakes.
Underbody Flushing
At least every spring. LIS~ plain water to flush any
corrosive materials from the underbody. Take care to
clean thoroughly any areas where mud
and other debris
can collect.
7-39
ProCarManuals.com

Part C: Periodic Maintenance
Inspections
Listed below are inspections and services which should
be performed at least twice
a year (for instance, each
spring and fall). You should let your
GM retailer’s
service department or other qualified service center do
these jobs. Make
SLI~~ any necessary repairs are
completed
at once.
Restraint Systems
Now and then, make sure all your belts, buckles, latch
plates, retractors, anchorages and reminder systems are working properly. Look for any loose parts or damage.
If you see anything that might keep a restraint system
from doing its job, have
it repaired.
Steering, Suspension and Front-
Wheel-Drive Axle Boot and Seal Inspection
Inspect the front and rear suspension and steering
system for damaged, loose or missing parts,
signs of
wear, or lack of lubrication. Inspect the power steering
lines and hoses for proper hookup, binding, leaks,
cracks, chafing, etc. Clean and then inspect the drive
axle boot seals for damage, tears or leakage. Replace
seals
if necessary.
Exhaust System Inspection
Inspect the complete exhaust system. Inspect the body
near the exhaust system.
Look for broken, damaged,
missing or out-of-position parts
as well as open seams,
holes, loose connections,
or other conditions which
could cause a heat build-up in the floor pan or could let
exhaust fumes into the vehicle. See “Engine Exhaust”
in
the Index.
Throttle Linkage Inspection
Inspect the throttle linkage for interference or binding,
and for damaged or missing parts. Replace parts as
needed. Accelerator and cruise control cables should
not
be lubricated.
Brake System Inspection
Inspect the complete system. Inspect brake lines and
hoses for proper hookup, binding, leaks, cracks, chafing,
etc. Inspect disc brake pads
for wear and rotors for
surface condition. Inspect other brake parts, including
calipers, parking brake, etc.
You may need to have your
brakes inspected more often
if your driving habits or
conditions result
in frequent braking.
7-40
ProCarManuals.com

Part D: Recommended Fluids and
Lubricants
NOTE: Fluids and lubricants identified below by name,
part number or specification may be obtained from your
3M retailer.
USAGE
Engine Oil
Engine Coolant
Coolant Supplement
FLUID/LUBRICANT
Engine oil with the American
Petroleum Institute Certified For
Gasoline Engines “Starburst”
symbol
of the proper viscosity. To
determine the preferred viscosity
for your vehicle’s engine, see
“Engine Oil” in the Index.
50/50 mixture of water (preferably
distilled) and good quality
ethylene glycol base antifreeze
(GM Part
No. 1052753 or
equivalent) conforming to GM
Specification 1825M or approved
recycled coolant conforming
to
GM Specification 1825M.
GM Part
No. 3634621 or
equivalent with a complete flush
and refill.
L
USAGE
Hydraulic Brake System
Parking Brake
Guides
Power Steering System
Automatic
Transaxle
Key Lock
Cylinders
FLUIDLUBRICANT
Delco Supreme 11 @ Brake Fluid
(GM Part
No. 1052535 or
equivalent DOT-
3 brake fluid).
Chassis lubricant (GM Part
No. 1052497 or equivalent) or
lubricant meeting requirements of
NLGI Grade 2, Category LB
or GC-LB.
GM Hydraulic Power Steering
Fluid (GM Part
No. 1052884 or
equivalent).
DEXRON@-I11 Automatic
Transmission Fluid.
Lubricate with Multi-Purpose
Lubricant (GM Part
No. 12345 120)
or synthetic SAE 5W-30
engine oil.
7-41
ProCarManuals.com

USAGE
4utomatic
Ihmsaxle Shift
Linkage
Floor Shift
Linkage
Chassis
Lubrication
Windshield
Washer Solvent
Hood Latch
Assembly
a. Pivots and
Spring Anchor
b. Release Pawl
FLUIDLUBRICANT
Engine oil.
Engine oil. Chassis lubricant (GM Part
No. 1052497 or equivalent) or
lubricant meeting requirements
of NLGI Grade 2, Category LB
or GC-LB.
GM Optikleen@ Washer Solvent
(GM Part
No. 1051515) or
equivalent.
a. Engine oil.
b. Chassis lubricant (GM Part
No. 1052497 or equivalent) or
lubricant meeting requirements
of NLGI Grade 2, Category LB
or GC-LB.
USAGE
Hood and Door
Hinges, Fuel
Door Hinge,
Rear
Compartment
Lid Hinges
Weatherstrip Conditioning
FLUIDLUBRICANT I
Engine oil or Lubriplate Lubricant
(GM Part
No. 1050109).
Dielectric Silicone Grease (GM
Part
No. 12345579 or equivalent).
See “Replacement Parts” in the Index for recommended
replacement filters, valves and spark plugs.
7-42
I
ProCarManuals.com

Part E: Maintenance Record
After the scheduled services are performed, record the
date, odometer reading and
who performed the service
in the boxes provided after the maintenance interval.
Any additional information from “Owner Checks and
Services” or “Periodic Maintenance” can be added on
the following record pages. Also,
you should retain all
maintenance receipts.
Your owner information portfolio
is a convenient place to store them.
Maintenance Recora
ODOMETER
DATE READING SERVICED
BY MAINTENANCE PERFORMED
7-43
ProCarManuals.com

Maintenance Record
ODOMETER
DATE READING SERVICED BY MAINTENANCE PERFORMED
ODOMETER
DATE READING SERVICED BY MAINTENANCE PERFORMED
c
7-44
ProCarManuals.com