1995 OLDSMOBILE AURORA Owners Manual

To Increase Speed While Using Cruise
Control
There are two ways to go to a higher speed. Here’s the
first:
1. Use the accelerator pedal to get to the higher speed.
2. Push the button at the end of the lever, then release
the button and the accelerator pedal. You’ll now
cruise at the higher speed.
Here’s the second way to
go to a higher speed:
I. Move the cruise switch from ON to RES/ACC. Hold
it there until you get up to the speed you want, and
then release the switch.
2. To increase your speed in very small amounts, move
the switch to REWACC for less than half a second
and then release
it. Each time you do this, your
vehicle
will go about 1 mph (I .6 km/h) faster.
The accelerate feature will only work after you turn on
the cruise control by pushing the
SET button.
To Reduce Speed While Using Cruise
Control
There are two ways to reduce your speed while using
cruise control:
0 Push in the button at the end of the lever until you
reach the lower speed you want, then release
it.
0 To slow down in very small amounts, push the
button for less than half a second. Each time
you do
this, you’ll go
1 mph (1.6 km/h) slower.
Passing Another Vehicle While Using
Cruise Control
Use the accelerator pedal to increase your speed. When
you take your foot off the pedal, your vehicle will slow
down
to the cruise control speed you set earlier.
If you increase your speed over 20 mph (32 km/h),
cruise control will be disabled. You will then have
to
reset your cruise control.
ProCarManuals.com

Using Cruise Control on Hills
How well your cruise control will work on hills depends
upon your speed, load, and the steepness of the hills.
When going up steep hills, you may have to step on the
accelerator pedal to maintain your speed. When going
downhill, you may have to brake or shift to a lower gear to
keep your speed down. Of course, applying the brake takes
yon out of cruise control. Many drivers find this to be
too
much trouble and don’t use cruise control on steep hills.
To Get Out of Cruise Control
There are two ways to turn off the cruise control:
Step lightly on the brake pedal; or
Move the cruise switch to OFF. (The CRUISE light
will go out.)
To Erase Cruise Control Memory
When you turn off the cruise control or the ignition, or
shift into
PARK (P), your cruise control set speed
memory is erased.
2-38
ProCarManuals.com

Headlamps
300: Turn the band to this symbol to turn on:
Parking Lamps
%
0 Side Marker Lamps
0 Taillamps
Instrument Panel Lights
License Plate Lamps
/, Turn the band to this symbol to turn on:
Headlamps
-'Q-
Parking Lamps
Side Marker Lamps
0 Taillamps
Instrument Panel Lights
License Plate Lamps
Turn the band to
OFF to turn off the lamps/lights.
Headlamp High-Low Beam
To change the headlamps
from low beam to high or
high to low, pull the turn
signal lever all the way
toward you. Then release
it.
When the high beams are on, a blue light on the
instrument panel also will be on.
2-39
ProCarManuals.com

Flash-To-Pass Feature
This feature lets you use your high beam headlamps to
signal a driver in front of you that you want to pass. It
works even
if your headlamps are off.
To use it, pull the turn signal lever toward you.
If your headlamps are off, your high beam headlamps
will turn on. They’ll stay on as long as you hold the
lever there. Release the lever to turn them off.
If your headlamps are on, but on low beam, the system
works normally. Just pull the lever until it clicks. Your
headlamps will shift to high beam and stay there. To
return to low beam, just pull the lever toward you.
If your headlamps are on, and on high beam, your
headlamps will switch to low beam.
To get back to high
beam, pull the lever toward you.
Cornering Lamps
I
The cornering lamps are designed to come on when you
signal a turn. This will provide more light for cornering
at night.
2-40
ProCarManuals.com

Daytime Running Lamps (Canada Only)
Daytime Running Lamps (DRL) can make it easier for
others to see the front of your vehicle during the day.
DRL can be helpful
in many different driving
conditions, but they can be especially helpful
in the
short periods after dawn and before sunset.
A light sensor on top of the instrument panel makes the
DRL work,
so be sure it isn’t covered. The DRL system
will make your low-beam headlamps conle on at
a
reduced brightness when:
0 The ignition is ON,
The headlamp switch is OFF, and
0 The transaxle is not in PARK (P).
When the DRL are on,
only your low beam headlamps
will be on. The taillamps, sidemarker and other lamps
won’t be on. Your instrument panel won’t be
lit up either.
When it’s dark enough outside, your
low beam
headlamps will change to
full brightness automatically.
The other lamps that come on with your headlamps
will
also come on. When
it’s bright enough outside, the regular lamps
will
go off, and your low beam headlamps will change to the
reduced brightness of DRL.
To idle your vehicle with the DRL off, shift the
transaxle into PARK
(P). The DRL will stay off until
you shift out of PARK (P). If it’s dark, you must also
move the Twilight Sentinel control to MIN.
As with any vehicle, you should turn on the regular
headlamp system when you need it.
Fog Lamps
To turn on the fog lamps,
first turn
on the parking
lamps or headlamps. Then
press the fog lamp switch.
A light will glow on the
switch when the switch
is
on. To turn off the fog
lamps, press
it again. The
fog lamps will also switch
off when you turn on your
high beam headlamps.
but
will turn on again when you
switch to low beams.
2-41
ProCarManuals.com

Instrument Panel Intensity Control
INTERIOR LIGHTS TWILIGHT SENTINEL
You can brighten or dim your instrument cluster, radio and
climate control displays and control lights
by rotating the
lNTERlOR LIGHTS control between
LO and HI when
your lights are on. Rotate the control all the way to
HI and
you will turn on the interior courtesy lamps.
Twilight Sentinel
The Twilight Sentinel Does Two Things:
0 First, depending on how dark it becomes outside, the
Twilight Sentinel turns your headlamps on automatically, when they’re needed. Avoid covering
the sensor located near the windshield, by the defroster
outlet--otherwise your headlamps
will stay on.
Also, it’s possible that your headlamps might go out
if you drive from a dark area into a bright area, such
as a lighted parking lot. If this happens, turn on your
headlamps with the regular headlamp switch.
Second, to light your way when you leave your
vehicle, the Twilight Sentinel will keep your
headlamps
on for as long as three minutes.
2-42
ProCarManuals.com

To operate the Twilight Sentinel, rotate the Twilight
Sentinel control to
MAX for a three-minute delay.
Rotate it toward
MIN to reduce the delay. Rotate the
control all the way to
MIN to turn off the Twilight
Sentinel. These
lamps work even
when the ignition is off. To
avoid draining your vehicle’s battery, be sure to turn off
all front and rear reading lamps when leaving your
vehicle.
Front Reading Lamps Rear Reading Lamps
These lamps and
the interior courtesy lamps will come
on when you open a door. They will turn off when
you
turn on the ignition. If the door is left open, they will
turn off after about
10 minutes.
To turn on the reading lamps when the doors are closed,
press the button behind the lamp you want
on. Press it
again
to turn the lamp off.
These lamps go on when you open the doors. You can
also turn them on by pressing the button to the side of
the lamp. Press it again to turn them off.
These lamps work even when the ignition
is off. To avoid
draining
your vehicle’s battery, be sure to turn off all front
and rear reading lamps when leaving your vehicle.
2-43
ProCarManuals.com

Installing a Garage Door Opener
To install a garage door opener in the overhead console,
follow these directions:
1. Push the extended tab, which is located in front of
the
GARAGE button, and pull the door downward.
2. Remove the square height adapters from the door.
3. Refer to the chart on the following pages to
determine the number and location
of the height
adapters for your transmitter unit.
If your unit does
not appear on the chart, you will have
to try random
adapter number and location combinations.
2-44
ProCarManuals.com