1995 OLDSMOBILE AURORA jump cable

1
The HAZARD light on the
instrument panel will also
come
on.
HAZARDA
Your hazard flashers work no matter what position your
key is
in, and even if the key isn’t in.
To turn off the flashers, press the button down again.
When the flashers are
on, your turn signals won’t work.
Other Warning Devices
If you carry reflective triangles, you can set one up at
the side of the road about 300 feet (100 m) behind your
vehicle.
Jump Starting
If your battery has run down, you may want to use
another vehicle and some jumper cables to start your
Aurora. But please follow the steps to do it safely.
5-2
ProCarManuals.com

NOTICE:
Ignoring these steps could result in costly damage
to
your vehicle that wouldn’t be covered by your
warranty.
Trying
to start your Aurora by pushing or pulling
it won’t
work, and it could damage your vehicle.
To Jump Start Your Aurora:
1. Check the other vehicle. It must have a I2-volt
battery
with a negative ground system.
NOTICE:
If the other system isn’t a 12-volt system with a
negative ground, both vehicles can be damaged.
2. Get the vehicles close enough so the jumper cables
can reach, but be s~lre the vehicles aren’t touching
each other. If they are,
it could cause a ground
connection you don’t want. You wouldn’t be able
to
start your Aurora, and the bad grounding could
damage the electrical systems.
You could be injured
if the vehicle rolls. Set the
parking brake firmly on each vehicle. Put an
automatic transaxle in PARK (P) or a manual
transaxle
in NEUTRAL (N).
3. Turn off the ignition on both vehicles. Turn off all
lights that aren’t needed, and radios. This
will avoid
sparks and help
save both batteries. And it could
save your radio!
I NOTICE:
If you leave your radio on, it could be badly
damaged. The repairs wouldn’t be covered by
your warranty.
5-3
ProCarManuals.com

You should always use the remote positive (+)
terminal instead of the positive (+) terminal on your
battery.
To open the remote positive (+) terminal box, pull
the tab and open the cover.
5. Check that the jumper cables don’t have loose or
missing insulation.
If they do, you could get a shock.
The vehicles could be damaged, too.
Before you connect the cables, here are some things
you should know. Positive
(+) will go to positive (+)
and negative (-) will go to negative (-) or a metal
engine part. Don’t connect
(+) to (-) or you’ll get a
short that would damage the battery and maybe other
parts, too.
5-5
y. -.
ProCarManuals.com