Page 111 of 395

Downloaded from www.Manualslib.com manuals search engine As you signal a turn or a lane change, if the arrows don’t flash but just stay on
a signal bulb may be burned
out and other drivers won’t see your turn signal.
If
a bulb is burned out, rcplacc it to help avoid an accident. If the green
arrows don’t go on at all when you signal
a turn, check the fuse (see
“Fuses’’ in
the Index) and for burned-out bulbs.
Wiper Activated Headlumps
This feature activates the headlamps and parking lamps after the
windshield wipers have been in use
for approximately 23 seconds.
In order
to operate the wiper activated headlamps, the twilight sentinel
must
be in the ON position. This feature lights the way in poor weather
and
it also makes your vehicle more visible to other drivers. If the wiper
activated headlamps are
on, and the ignition switch is turned off, the
wiper activated headlamps
will immediately turn off.
The wiper activated headlamps will deactivate if you turn off the twilight
sentinel
or if the windshield wipers have been turned off for a period of
one or two seconds.
Headlamp High-Low Beam
To change the
headlamps from low
beam
to high or high to
low, pull the turn signal
lever all
the way toward
you. Then releasc it.
When the high beams
are on, this blue
light
on thc instrument
panel
will also be on.
Flash-To-Pass Feature
This lets you use your high beam headlamps to signal a driver in front of
you that you want to pass. It works even if your headlamps are off.
2-40
Page 117 of 395
Downloaded from www.Manualslib.com manuals search engine CRUISE ENGAGED
4. The digital
instrument panel
cluster has a
CRUISE
ENGAGED light
that will come on.
On the analog cluster
the
CRUISE
ENGAGED
message
~ will display for a few
~ seconds.
5. Take your foot off the accelerator pedal.
To Resume a Set Speed
Suppose you set your cruise control at a desired speed and then you apply
the brake. This,
of course, shuts off the cruise control, however, you don’t
need
to reset it. Once you’re going about 25 mph (40 km/h) or more, you
can move the cruise control switch from
ON to R/A (ResumelAccelerate)
for about half a second.
You’ll
go right back UD to your chosen speed and stay there.
2-46
J
U
0
3
Page 119 of 395
Downloaded from www.Manualslib.com manuals search engine To Get Out of Cruise Control
There are two ways to turn off the cruise control:
1. Step lightly on the brake pedal; OR
2. Move the CRUISE switch to OFF. (The CRUISE light will go out.)
To Erase Speed Memory
When you turn off the cruise control or the ignition, your cruise control
set speed memory is erased.
2-48
1
Page 121 of 395

Downloaded from www.Manualslib.com manuals search engine You can brighten or dim your instrument cluster by rotating the
Press the switch all the way in to turn off your lamps.
Your Cadillac is also equipped with a feature that will automatically turn
your exterior lamps
on after about 25 seconds of wiper operation.
headlamp
switch.
La-mps On Reminder
If you open the door while leaving the lamps on, except when using
twilight sentinel,
you will hear a warning tone.
Interior Lamps
Turn the headlamp switch past HI to turn on the interior lamps.
Twilight Sentinel
The control is next to the headlamp switch. It automatically switches your
lamps
on and off by sensing how dark it is outside. To operate the twilight
sentinel, leave
the lamp switch off and move the control to any position
but
OFF.
If you move the control all the way to MAX, your lamps will remain on
for
1130 seconds after you turn your engine off. If you move the control so
it is just on, the lamps will go off quickly when you turn off your engine.
You can change this delay time from only a few seconds to 180 seconds.
Page 122 of 395

Downloaded from www.Manualslib.com manuals search engine Light Sensor
............ :,,r,.?,;,**;,~,.I ........ " I
Fog Lamps (ETC)
... ... LO Hi TWILIGHT SENTINEL
INTERIOR
dl
The lamp sensor for
the twilight sentinel is
located
in the center of
the front defogger
grille. If
you cover the
sensor,
it will read
"dark" and your lamps
will come on.
Use your fog lamps
for better vision
in
foggy or misty
conditions. When you
press the upper fog
lamp switch, a small
indicator light will
glow to tell
you the
fog lamps are on.
Press the switch again
to turn them
off.
If you switch on your high beam headlamps, your fog lamps will turn off.
They'll turn back on again when you switch to low beam headlamps.
When the twilight sentinel is
on and the fog lamp switch is activated, only
the headlamps will turn
off automatically. Your fog and parking lamps will
remain on.
When the twilight sentinel is on, only the headlamps will turn
off
automatically. Your fog and parking lamps will remain on.
2-5 1
Page 123 of 395
Downloaded from www.Manualslib.com manuals search engine Rear Fog Lamps (Export Only)
To operate the rear fog
lamps, first turn on the
front
fog lamps, then
press the lower switch.
A small indicator light
will glow to tell you
they are on. Press the
switch again to turn
them
off.
Cornering Lamps
The cornering lamps come on when you signal a turn when the headlamps
or parking lamps are on. This will provide more light for cornering.
Underhood Lamp
TO operate the underhood lamp, turn on your parking lamps. Then the
underhood lamp will illuminate when the hood
is open.
2-52
Page 124 of 395

Downloaded from www.Manualslib.com manuals search engine 3.
Daytime Running Lamps (Canada Only)
Daytime Running Lamps (DRL) can make it easier for others to see
the front of your vehicle during the day. DRL can be helpful
in many
different driving conditions, but they can be especially helpful
in the
short periods after dawn and before sunset.
A light sensor on top of the instrument panel makes the DRL work, so be
sure
it isn’t covered.
The DRL system
will make your low beam headlamps come on at
reduced brightness when:
0 the ignition is on,
0 the headlamp switch is off, and
0 the transaxle is not in PARK (P).
When it’s dark enough outside, your low beam headlamps will change to
full brightness. When it’s bright enough outside, the regular lamps will go
off and your low beam headlamps change to the reduced brightness of
DRL.
To idle your vehicle with the DRL off shift the transaxle into PARK (P).
The DRL will stay off until you shift out of PARK (P).
As with any vehicle, you should turn on the regular headlamp system
when you need it.
2-53
Page 127 of 395
Downloaded from www.Manualslib.com manuals search engine OnlOff Switch
Reverse Gear Day Mode
To turn the
auto-dimming feature
on press the switch
located at the base
of
the mirror.
The switch will light,
indicating
it is on.
The reverse mode
is another important feature of the automatic mirror.
When the shift lever is placed in
REVERSE (R), the mirror changes to
the daytime mode for
a bright image in the mirror as you back up.
Cleaning Photocells
Use a cotton swab and glass cleaner to clean the front and rear photocells
that make
the auto-dimming feature work.
2-56