1994 CHEVROLET CAMARO lock

Downloaded from www.Manualslib.com manuals search engine Features and Controls
Key Release Button: If you have a
manual transmission, your ignition lock
has a key release button.
You must press
the button before
you can take your key
out
of the ignition lock.
NOTICE:
If your key seems stuck in “Lock”
and you can’t turn
it, be sure it is all
the way in. If it is, then turn the steer-
ing wheel left and right while you
turn the key hard. But turn the key
only with your hand. Using
a tool to
force it could break the key or the
ignition switch. If none
of this works,
then
your vehicle needs service.
Retained Accessory Power (RAP)
If you have power door locks, your
vehicle has a feature called Retained
Accessory Power (RAP). With RAP your
power door locks, electric mirrors, power
windows, audio system and remote hatch
release
will continue to work up to 10
minutes after the ignition key is turned to
“Off’ and neither door
is opened.
If
a door is opened, the audio system and
power windows will shut off. The power
door locks, electric mirrors and remote
hatch release
will work until you shut the
door. Once you have shut the door, these
accessories
will continue to work for
approximately
35 seconds. After this
time you will not be able to use these
accessories until the next time you open
a door or
turn on the ignition.
... 56

Downloaded from www.Manualslib.com manuals search engine Engine Coolant Heater
(Engine Block Heater)
(OPTION)
In very cold weather, 0°F (- 1 8 "Cj or
colder, the engine coolant heater can help.
You'll get easier starting and better fuel
economy during engine warm-up.
Usually, the coolant heater should be
plugged
in a minimum of four hours prior
to starting your vehicle.
To use the coolant heater:
1. Turn off the engine.
2. Open the hood and unwrap the
electrical cord.
3. Plug it into a normal, grounded
110-volt outlet.
NOTICE:
After you've used the coolant heater,
be sure
to store the cord as it was
before, to keep
it away from moving
engine parts.
If you don't, it could be
damaged.
How long should you keep the coolant
heater plugged in? The answer depends
on the weather, the kind
of oil you have,
and some other things. Instead
of trying to
list everything here, we ask that
you
contact a Chevrolet dealer in the area
where you'll be parking your vehicle. The
dealer can give
you the best advice for
that particular area.
59. .

Downloaded from www.Manualslib.com manuals search engine Features and Controls
Automatic Transmission
rhere are several different positions for
Tour shift lever.
B P (Park)
rhis locks your rear wheels. It’s the best
losition to use when you start your
:ngine because your vehicle can’t move
:asily. Ensure the shift
lever
is fully in “P’
:Park) range before starting the engine.
Your Chevrolet has a brake-transmission
shift interlock.
You have to fully apuly
your regular brakes before
you can shift
From
“P’ (Park) when the ignition key is
In the “Run” position. If you cannot shift
]ut of
“P’ (Park), ease pressure on the
shift lever
- push the shift lever all the
way into
“P’ (Park) and also release the
shift lever button on floor shift console
models as you maintain brake application.
I‘hen move the shift lever into the gear
you wish. (Press the shift lever button
before moving the shift lever on floor
shift console models.) See “Shifting out
Df “P’ (Park)” in this part.
. ..60

Downloaded from www.Manualslib.com manuals search engine Features and Controls
a
a
0
0
0
2 (Second Gear) - Press the clutch
pedal as you let up on the accelerator
pedal and shift into
“2.” Then, slowly
let up on the clutch pedal as you
press the accelerator pedal.
3,4,5 and 6 (Third, Fourth, Fifth
and Sixth Gears)
- Shift into “3,”
“4,” “5” and “6” the same way you do
for
“2.” Slowly let up on the clutch
pedal
as you press the accelerator
pedal.
To Stop - Let up on the accelerator
pedal and press the brake pedal. Just
before the vehicle stops, press
the
clutch pedal and the brake pedal, and
shift to “Neutral.”
Neutral - Use this position when
you start or idle your engine.
R (Reverse) - To back up, press
down the clutch pedal and shift into
“R.” Let
up on the clutch pedal slowly
while pressing the accelerator pedal.
If you shift from
“6” into “R,” the
shift lever must be first placed in the
“Neutral” position centered between
“2” and “3” prior to shifting into “R.”
Your six-speed manual transmission has a
feature that allows you to safely shift into
“R’ (Reverse) while the vehicle is rolling
(at less than
5 mph). You will be
“locked-out”
if you try to shift into “R’
(Reverse) while your vehicle is moving
faster than
5 mph.
If
you have turned your ignition off and
wish to park your vehicle
in Reverse, you
will have to move the shift lever quickly
to the right, “crashing” through the high
load spring and then into gear.
SKIP SHIFT
Skip Shift Light (5.7L LT1 Engine)
When this light comes on, you can only
shift from “1” (First) to
“4” (Fourth) gear
instead of
“1” (First) to “2” (Second)
gear. This helps you
to get the best
possible fuel economy.
This light will come on under these
conditions:
0 The engine coolant temperature is
0 You are going 15-20 mph
0 You are at 35% throttle or less.
greater than
170°F
(77”C),
(24-32 km/h), and
... 64

Downloaded from www.Manualslib.com manuals search engine Features and Controls
1. Hold the brake pedal down with your
right foot and set the parking brake.
2. Move the shift lever into “P’ (Park)
position like this:
Hold in the button on the lever,
and push the lever all the
way
toward the front of your vehicle.
3. Move the ignition key to “LOCK.”
4. Remove the key and take it with you.
If you can walk away from your
vehicle with
the ignition key in your
hand, your vehicle is in “P” (Park).
Leaving Your Vehicle with the
Engine Running
(AUTOMATIC TRANSMISSION)
If you have to leave your vehicle with the
engine running, be sure your vehicle is
in
“P’ (Park) and your parking brake is
firmly set before you leave it. After
you’ve moved the shift lever into the
“P’
(Park) position, hold the regular brake
pedal down. Then, see
if you can move
the shift lever away from “P” (Park)
without first pushing the button. If you can,
it means
that the shift lever wasn’t
fully locked into “P’ (Park).
Torque f Ock (AUTOMATIC
TRANS#lSSlON)
If you are parking on a hill and you don’t
shift your transmission into “P” (Park)
properly, the weight of the vehicle may
put too much force on the parking pawl in
the transmission.
You may find it difficult
to pull the shift lever out of “P” (Park).
This is called “torque lock.”
To prevent
torque lock, set
the parking brake and
then shift into “P” (Park) properly before
you leave the driver’s seat. To find out
how, see “Shifting Into “P” (Park)” in
the Index.
When you are ready to drive, move the
shift lever out of “P” (Park)
BEFORE
you release the parking brake.
If “torque lock” does occur, you may
need to have another vehicle push yours
a little uphill to take some of the pressure
From the transmission,
so you can pull the
shift lever out of “P” (Park).
... 68

Downloaded from www.Manualslib.com manuals search engine Shifting out of P (Park)
[AUTOMATIC TRANSMISSION)
Your Chevrolet has a brake-transmission
shift interlock.
You have to fully apply
your regular brake before
you can shift
from
“P’ (Park) when the ignition is in
the
“Run” position. See “Automatic
Transmission” in the Index.
If you cannot shift out of “P’ (Park), ease
pressure on the shift lever
- push the
shift lever all the way into
“P’ (Park) and
release the shift lever button
as you
maintain brake application. Then press the
shift lever button and move the shift
lever into the gear you wish.
If you ever hold the brake pedal down but
still can’t shift out of “P” (Park), try this:
1. Turn the key to ‘bOff.”
2. Apply and hold the brake until the end
3. Shift to “N” (Neutral).
4. Start the vehicle and then shift to the
drive gear
you want.
of Step 4.
5. Have the vehicle fixed as soon as you
can.
Parking Your Vehicle
(MANUAL TRANSMISSION)
Before you get out of your vehicle, put
your
manual transmission in “R”
(Reverse) and firmly apply the parking
brake.
If your vehicle is equipped to tow a trailer,
see “Towing a Trailer”
in the Index.
69 ...

Downloaded from www.Manualslib.com manuals search engine Features and Controls
The switch for the driver's window has an
Express
Down feature. Quickly press and
release the switch for the driver's window
and the window will lower completely.
You can also open the driver's window
any amount by pressing the switch again
while the window is in the Express Down
mode when
it has lowered to the position
you want.
Horn
To sound the horn, press either horn
symbol
on your steering wheel.
Tilt Wheel
1 tilt steering wheel allows you to adjust
he steering wheel before you drive.
u'ou can also raise it to the highest level to
:ive
your legs more room when you exit
tnd enter the vehicle.
To tilt the wheel, hold the steering wheel
md
pull the lever. Move the steering
wheel to
a comfortable level, then release
he lever to lock the wheel
in place.
I .72

Downloaded from www.Manualslib.com manuals search engine Windshield Washer
At the top of the turn signal lever there’s
a paddle with the word
“PUSH” on it. To
spray washer fluid on the windshield, just
push the paddle. The washer will continue
to spray until you release the paddle. The
wipers will clear the window and wipe a
few more times before stopping
or
returning to the previous setting.
In freezing weather, don’t use your
washer until the windshield is
warmed. Otherwise the washer fluid
can form ice on the windshield,
blocking your vision.
NOTICE:
e
e
0
e
When using concentrated washer
fluid, follow the manufacturer’s
instructions for adding water.
Don’t mix water with
ready-to-use washer fluid. Water
can cause the solution to freeze
and damage your washer fluid
tank and other parts of the washer
system. Also, water doesn’t clean
as well as washer fluid.
Fill your washer fluid tank only
314 full when it’s very cold. This
allows for expansion, which could
damage the tank
if it is completely
full.
Don’t use radiator antifreeze in
your windshield washer. It can
damage your washer system and
paint.
75. .