1994 CHEVROLET CAMARO load capacity

Downloaded from www.Manualslib.com manuals search engine Features and Controls
’F
-E
Fuel Gage
Your fuel gage shows about how much
fuel is in your tank. The fuel gage works
only when the ignition switch is in the
“Run” position. When the gage pointer
first indicates
“E,” you still have a little
fuel left (about one to two gallons), but
you need to get more right away.
Here are four concerns some owners
have had about the fuel gage. All these
situations are normal and do not indicate
that anything is wrong with the fuel gage. At
the gas station, the gas pump shuts
off before the gage reads
“E”
It takes more (or less) gas to fill up
than the gage reads. For example, the
gage reads
1/2 full, but it took more
(or less) than half of the tank’s
capacity to fill it.
The gage moves a little when you
turn, stop or speed up.
When you
turn the engine off, the
gage doesn’t go back to
“E.”
BRAKE
I I 3
Brake System Warning Light
Your Chevrolet’s hydraulic brake system
is divided into two parts. If one part isn’t
working, the other part can still work and
stop you.
For good braking, though, you
need both parts working well.
If the warning light comes on, there could
be a brake problem. Have your brake system inspected right away.
This light should come on as you start the
vehicle.
If it doesn’t come on then, have it
fixed
so it will be ready to warn you if
there’s a problem.
... 94

Downloaded from www.Manualslib.com manuals search engine Your Driving and the Road
Run your engine only as long as you
must. This saves fuel. When you run the
engine, make it go a little faster than just
idle. That is, push the accelerator slightly.
This uses less fuel for the heat that you
get and it keeps the battery charged.
You
will need a well-charged battery to restart
the vehicle, and possibly for signaling
later on with your headlights. Let the
heater run for awhile. Then,
shut the engine
off and close the
window almost all the way to preserve the
heat. Start the engine again and repeat this
only when you feel really uncomfortable
from the cold. But do it as little as
possible. Preserve the fuel as long as you
can. To help keep warm, you can get out
of the vehicle and do some fairly vigorous
exercises every half hour or
so until help
comes.
Towing a Trailer
NOTICE:
Pulling a trailer improperly can dam-
age your vehicle and result in costly
repairs not covered
by your warranty.
To pull a trailer correctly, follow the
advice
in this section, and see your
Chevrolet dealer for important
information about towing a trailer
with your vehicle.
Your vehicle can tow a trailer if it is
equipped with the proper trailer towing
equipment. To identify what the vehicle
trailering capacity is for your vehicle, you
should read the information in “Weight
of the Trailer” that appears later in this
section. But trailering is different than just
driving your vehicle by itself. Trailering
means changes in handling, durability,
and fuel economy. Successful, safe
trailering takes correct equipment, and
it has to be used properly.
That’s the reason for this section. In it are
many time-tested, important trailering
tips and safety rules. Many of these are
important for your safety md that of your
passengers.
So please read this section
carefully before you pull a trailer.
. . .142

Downloaded from www.Manualslib.com manuals search engine Your Driving and the Road
A B
Weight of the Trailer Tongue
The tongue load (A) of any trailer is
an important weight to measure
because it affects the total capacity
weight of your vehicle. The capacity
weight includes the curb weight of the
vehicle, any cargo you may carry in it.
and the people who will be riding in
the vehicle. And if you will tow a
trailer, you must subtract the tongue
load from your vehicle’s capacity
weight because your vehicle will be
carrying that weight, too. See “Loading Your Vehicle” in the Index
for more information about your
vehicle’s maximum load capacity.
If you’re using a “dead-weight’’
hitch, the trailer tongue
(A) should
. .I44
weight 10% of the total loaded trailer
weight (B). If you have a
“weight-distributing” hitch,
the
trailer tongue (A) should weigh 12%
of the total loaded trailer weight
(B).
After you’ve loaded your trailer,
weigh the trailer and then the tongue,
separately, to see if the weights are
proper. If they aren’t, you may be able
to get them
right simply by moving
some items around in the trailer.
Total Weight on Your Vehicle’s Tires
Be sure your vehicle’s tires are
inflated to the limit for cold tires.
You’ll find these numbers on the
Certification label at
the rear edge of
the driver’s door or see “Loading Your
Vehicle
” in the Index. Then be sure
you don’t go over the GVW limit for
your vehicle.
Hitches
It’s important to have the correct hitch
zquipment. Crosswinds, large trucks
going by, and rough roads are a few
reasons why you’ll need the right hitch.
Here are some rules to follow:
Will you have to make any holes in
the body
of your vehicle when you
install a trailer hitch? If you do, then
be sure to seal the holes later when
you remove the hitch. If you don’t
seal them, deadly carbon monoxide
(CO) from your exhaust can get into
your vehicle (see “Carbon Monoxide”
in the Index). Dirt and water can, too.
The bumpers on your vehicle are not
intended for hitches.
Do not attach
rental hitches or other bumper-type
hitches to them. Use only a
frame-mounted hitch that does not
attach to the bumper.
Safety Chains
You should always attach chains between
your vehicle and your trailer. Cross the
safety chdins under the tongue of the
trailer
so that the tongue will not drop to
the road if it becomes separated from the
hitch. Instructions about safety chains
may be provided by the hitch
manufacturer or by the trailer
manufacturer. Follow the manufacturer’s
recommendation for attaching safety
chains. Always leave just enough slack
so
you can turn with your rig. And, never
allow safety chains to drag on the ground.

Downloaded from www.Manualslib.com manuals search engine Service and Appearance Care
”,
d
4
To Check Engine Oil
(3.4L L32 (Code S) Engine)
Pull out the dipstick and clean it with a
paper towel or cloth, then push it back in
all the way. Remove it again, keeping the
tip lower, and check the level.
IC
To Check Engine Oil
(5.7L LTl (Code P) Engine)
Pull out the dipstick slightly. Pinch the
end
of the dipstick tube as you remove
the dipstick to wipe the oil from it. Then
push it all the way back in. Now remove
it without pinching the tube, keeping the
tip lower.
3.4L L32 (Code S)
When to Add Oil:
f the oil is at or below the “ADD” line,
hen you’ll need to add some oil. But you
nust use the right kind. This section
:xplains what kind
of oil to use. For
:rankcase capacity, see “Capacities and
ipecifications” in the Index.
. . .I88

Downloaded from www.Manualslib.com manuals search engine Service and Appearance Care
I
c i
c
3. Turn counterclockwise and pull out
the socket and the bulb.
1. Reverse the steps with a new bulb.
. .212
r ~~
TIRE-LOADING INFORMATION
FRT. CRT.
RR. TOTAL LBS KG 3 3 2 8 1199 544 MAX. LOADING @ GVWR SAME AS VEHICLE
CAPACITY WEIGHT BBW
OCCUPANTS VEHICLE CAP. WT.
TIRE SIZE
IF
v)
INFORMATION
2
Loading Your Vehicle
Two labels on your vehicle show how
much weight
it may properly carry. The
Tire-Loading Information label found on
the driver’s door tells you the proper size,
speed rating and recommended inflation
pressures for the tires on your vehicle. It
also gives you important information
about the number of people that can be
in
your vehicle and the total weight that you
can carry. This weight is called the
Vehicle Capacity Weight and includes the
weight of all occupants, cargo, and all
nonfactory-installed options.
MFD BY GENERAL MOTORS CORP.
1 DATE GVWR GAWRFRT GAWRRR
7
fl
d

il
tl
P
tl
P
tl
0
0
S.
’he other label is the Certification label,
ound on
the rear edge of the driver’s
.oor. It tells you the gross weight capacity
If your vehicle, called the GVWR (Gross
rehicle Weight Rating). The GVWR
ncludes the weight of the vehicle, all
lccupants, fuel and cargo. Never exceed
le GVWR for your vehicle, or the Gross
ixle Weight Rating (GAWR) for either
ne front or rear axle.
md, if you do have a heavy load, you
hould spread it out. Don’t
carry more
Ian
100 pounds (45 kg) in your rear area.

Downloaded from www.Manualslib.com manuals search engine Wheel Alignment and Tire Balance
The wheels on your vehicle were aligned
and balanced carefully at the factory to
give
you the longest tire life and best
overall performance.
In most cases, you will not need to have
your wheels aligned again. However,
if
you notice unusual tire wear or your
vehicle pulling one way or the other,
the
alignment may need to be reset. If you
notice your vehicle vibrating when
driving on a smooth road, your wheels
may need to be rebalanced.
Wheel Replacement
Replace any wheel that is bent, cracked or
badly rusted.
If wheel nuts keep coming
loose,
the wheel, wheel bolts, and wheel
nuts should be replaced. If the wheel
leaks air out, replace
it (except some
aluminum wheels, which can sometimes
be repaired). See your Chevrolet dealer
if
any of these conditions exist.
Your dealer will know
the kind of wheel
you need.
Each new wheel should have the same
load carrying capacity, diameter, width,
offset, and be mounted the same way as
the one it replaces.
[f you need to replace any of your wheels,
wheel bolts, or wheel nuts, replace them
Drily with new GM original equipment
parts. This way, you will be sure to have
the right wheel, wheel bolts, and wheel
nuts for your Chevrolet model.
NOTICE:
The wrong wheel can also cause
problems with bearing life, brake
cooling, speedometer/odometer cal-
ibration, headlight aim, bumper
height, vehicle ground clearance, and
tire or tire chain clearance to the
body and chassis.
Used Replacement Wheels
219..

Downloaded from www.Manualslib.com manuals search engine Service Station Information
Hood Release
See Page 184
Engine Oil Dipstick and- Fill Cap
(3.4L L32 (Code S) Engine)
See Page 188
Engine Oil Dipstick and /
Fill Cap
(5.7L LTl (Code P) Engine)
See Page 188
Cold Tire Pressure
See Tire-Loading Information label on the
inside of
the rear edge of the driver’s door.
See Page 212

Fuel
Capacity 15.5 U.S. Gal. (58.7 L).
Use unleaded gas only, 87 octane or
higher for the 3.4L L32 (Code
S) engine,
9 1 octane or higher for the 5.7L LT 1
(Code P) engine. See Page 181 See Page 201
\Battery
The
Delco Freedom@ battery needs
no water.
See Page 204
Cooling System Reservoir
Check coolant at the coolant recovery tank
by using the dipstick. Add coolant at the
coolant recovery tank. The fluid should be
at or a little above the “FULL HOT” mark
on the dipstick when the engine
is warm.
If the engine is cool, the level should be at
”FULL COLD” on the dipstick.
See Page 199
‘Spare Tire Pressure
Compact Spare: 60 psi (420 kPa).
See Page 176