1993 CHEVROLET PLYMOUTH ACCLAIM ignition

[x] Cancel search: ignition

Page 1286 of 2438

CHEVROLET PLYMOUTH ACCLAIM 1993  Service Manual Wiring Diagram 
Name Sheet Number 
Fuel Gauge  ............................. .107 
Fuel Pump Module  ........................ .107 
Fuel Pump Relay  .......................... .108 
Fuel Tank Gauge Le

Page 1289 of 2438

CHEVROLET PLYMOUTH ACCLAIM 1993  Service Manual Wiring Diagram 
Name Sheet Number 
Splice F35-2  ......................... .113, 115 
Splice F35-3  ............................ .114 
Splice G5-1  ................ .70, 73, 77, 84, 88, 127 
Splice G5

Page 1290 of 2438

CHEVROLET PLYMOUTH ACCLAIM 1993  Service Manual Wiring Diagram 
Name Sheet Number 
Optical Horn Switch  .........................55 
Park Brake Switch  ...........................70 
Park/Neutral Position Switch  ...............13, 15, 38 
Parking

Page 1467 of 2438

CHEVROLET PLYMOUTH ACCLAIM 1993  Service Manual WIRING DIAGRAMS AP BODY D-P
ALPHABETICAL INDEX
Wiring Diagram 
Name Sheet Number 
ABS Hydraulic Modulator Unit  .....................27 
ABS Pump Motor Relay  .........................27 
ABS System C

Page 1468 of 2438

CHEVROLET PLYMOUTH ACCLAIM 1993  Service Manual Wiring Diagram 
Name Sheet Number 
Exhaust Gas Recirculation Solenoid 2.5L  ..............13 
Exhaust Gas Recirculation Diagnostic Solenoid 3.0L.  ......20 
Fan Control System with A/C and Heater Syst

Page 1469 of 2438

CHEVROLET PLYMOUTH ACCLAIM 1993  Service Manual Wiring Diagram 
Name Sheet Number 
Horn (Lo-note)  .............................42 
Horn Relay  ...............................42 
Horn Switch  ..............................42 
Idle Air Control Motor

Page 1471 of 2438

CHEVROLET PLYMOUTH ACCLAIM 1993  Service Manual Wiring Diagram 
Name Sheet Number 
Splice M1-3  ........................... .40, 55 
Splice M2-1  ...............................39 
Splice P33  ............................ .62, 64 
Splice P34  .....

Page 1568 of 2438

CHEVROLET PLYMOUTH ACCLAIM 1993  Service Manual The MOPAR Silicone Rubber Adhesive Sealant 
gasket material or equivalent should be applied in a
continuous bead approximately 3mm (0.120 inch) in
diameter. All mounting holes must be circled. For
cor