1991 MITSUBISHI 3000GT check engine

FUEL SYSTEM - On-vehicle Inspection of MPI Components13-117
HARNESS INSPECTION
connectorl Connector: Disconnected
l Ignition switch: ON
Check for an open-circuit, or a short-
P
circuit to ground between the engine
control unit and the power transistor.l
Engine control unit connector:
Disconnectedl
Power transistor connector: Dis-connectedEngineRepair thecontrolunit-+ harness.harness(@@J-1101/)stdeconnector
T6FU1251
Check for an open-circuit, or a short-circuit to ground between the power
transistor and the ignition coil.l
Ignition coil connector: Discon-netted
l
Power transistor connector: Dis-
connected
Repair the
7FUO699
TSB Revision

FUEL SYSTEM - On-vehicle Inspection of MPI Components13-119PURGE CONTROL SOLENOID VALVE
Q Harness side
connector
I
Control relay
@ Equipment side
connector connector
unit
OlAO324
Engine control unit connector
7FUO653OPERATION
lThe purge control solenoid valve is an ON-OFF type one which controls introduction of purge air from the
canister into the intake air plenum.
lThe battery power is supplied to the purge control solenoid valve through the control relay. When the
engine control unit turns ON the power transistor in the unit, current flows to the coil, introducing purge
air.
INSPECTION
Using Multi-use Tester
Function
Actuator testItem No.Drive content
Check conditionNormal state
08Solenoid valve from OFFIgnition switch: ONOperating sound is heard
to ONwhen driven
TSB Revision

13-120FUEL SYSTEM - On-vehicle Inspection of MPI Components
HARNESS INSPECTION
@ Harness side
connector
T7FUO525
I -connector57FUO526
1
Measure the power supply voltage.
l Connector: Disconnected0 Ignition switch: ON
Check for an open-circuit, or a short-circuit to ground between the purgecontrol solenoid valve and the engine
control unit,
lEngine control unit connector:
Disconnected@-+A
lPurge control solenoid valve con-nector: DisconnectedRepair the
harness.

ACTUATOR INSPECTIONRefer to GROUP 17
- Evaporative Emission Control System.
1 TSB Revision1

FUEL SYSTEM - On-vehicle lnwection of MPI ComDonents13-121
LEGR CONTROL SOLENOID VALVE - Non Turbo, Turbo>MlBYZBAControl relav
EGR control
solenoid valve@ Equipment side
connector
Engine
control
unitEngine control unit connector
7FUO653
OPERATION
lThe EGR control solenoid valve is a duty control type solenoid valve. It makes control by leaking EGR valve
operating negative pressure to the throttle body A port.
lPower supply from the battery is sent through the control relay to the EGR control solenoid valve. When
the engine control unit turns off the power transistor inside the unit, current no more flows through the
coil and EGR valve operating negative pressure leaks.
TROUBLESHOOTING HINTIf the results of EGR control solenoid valve on-vehicle and off-vehicle inspections are normal but the
self-diagnosis code for EGR system failure is displayed, check the EGR valve, vacuum hose and EGR passage
for blocking.
c.
1 TSB Revision

13-122FUEL SYSTEM - On-vehicle Inspection of MPI Components
INSPECTIONUsing Multi-use Tester
Function
Actuator testItem No.
Drive content
Check condition
Normal state
10Change solenoid valve
from OFF to ON stateIgnition switch: ONOperating sound is heardwhen driven
HARNESS INSPECTION
1
@ Harness side
connector
Measure the power supply voltage.
Y01105*4Engine control unit
harness side connector
Control relay)
Repair the
-S harness.C@vJ-~)
d
Ls
ACTUATOR INSPECTIONRefer to GROUP 17
- Exhaust Gas Recirculation (EGR) System.
1 TSB Revision

13-124FUEL SYSTEM -On-vehicle Inspection of MPI Components
INSPECTIONUsing Multi-use tester
Function
Actuator testItem No.Drive content
Check conditionNormal state
09Turn solenoid valve fromIgnition switch: ONOFF to ONr%;reard when
HARNESS INSPECTION
@ Harness side
connector
Measure the power supply voltage.
l Connector: Disconnectedl Ignition switch: ON
Voltage
(V)2-* q
SVRepair thei* harness.(@m - Con-
trol relay)
7FUO527
Check for an open-circuit, or a short-circuit to ground, between the fuelpressure control solenoid valve andthe engine control unit.
lEngine controLunit connector:
Disconnected
lFuel pressure control valve con-nector: Disconnected
TSB Revision

FUEL SYSTEM - On-vehicle Inspection of MPI Components'13-127
INSPECTIONUsing Multi-use tester
LFunctionItem No.Drive contentCheck conditionNormal state
Actuator test12
Turn solenoid valve fromIgnition switch: ONOFF to ON
CliZli~,“eard when
HARNESS INSPECTION
Measure the power supply voltage.
l Connector: Disconnectedl Ignition switch: ON
trol relay)
7FUO525
Check for an open-circuit, or a short-circuit to ground, between the wastegate control solenoid valve and the
engine control unit.
lWaste gate control solenoid valveconnector: DisconnectedlEngine control unit connector:
DisconnectedRepair the
-+ harness.
(@m- ml)
7FUO526
ACTUATOR INSPECTIONRefer to GROUP 15.
1 TSB Revision

FUEL SYSTEM - On-vehicle Inspection of MPI Components13-129
i
HARNESS INSPECTION@ Harness side connector
*7FUO986Engine control unit
harness side
connect0r
1
Measure the power supply voltage.l Connector: Disconnected
l Ignition switch: ON
Voltage
(V)
svRepair the
harness.
(@I@-- Ini-tion coil9IG])
Check for an open-circuit or a short-circuit to ground, between the engine
control unit and the boost meter.
Boost meter connector: Discon-
nectedEngine control unit connector:Disconnected
ACTUATOR INSPECTIONRefer to GROUP 54.
1 TSB Revision