MOTOR ANTENNA
MOTOR ANTENNA REMOVAL AND
INSTALLATION
1. REMOVE MOTOR ANTENNA
(a) Remove the antenna nut.
(b) Remove the LH side cover.
(c) Disconnect the motor antenna connector and the antennacord.
(d) Remove the nut and the motor antenna assembly.
2. INSTALL MOTOR ANTENNA
(a) Install the antenna nut.
(b) Connect the motor antenna connector and the antenna cord.
(c) Install the nut.
ANTENNA ROD REMOVAL AND
INSTALLATION
1. REMOVE ANTENNA ROD HINT: Perform this operation with the battery negative (±)
cable connected to the battery terminal.
(a) Turn the ignition switch to ºLOCKº position.
(b) Remove the antenna nut.
(c±1) with CD player
Press the ºAMº and ºCDº buttons on the radio receiver, and
simultaneously turn the ignition switch to ºACCº position.
(c±2) without CD player Press the ºAMº and ºT APEº buttons on the radio receiver, and
simultaneously turn the ignition switch to ºACCº position.
HINT:
w The rod will extend fully and be released from the motor
antenna.
w After removing the antenna rod, leave the ignition switch
at ºACCº.
NOTICE: To prevent body damage when the antenna rod is re-
leased, hold the rod while it comes out.
BE±214±
BODY ELECTRICAL SYSTEM AUDIO SYSTEM
WhereEverybodyKnowsYourName
2. INSTALL ANTENNA ROD
(a) Insert the cable of the rod until it reaches the bottom.HINT:
wWhen inserting the cable, the teeth on the cable must
face toward the rear of the vehicle.
w Insert the cable approx. 400 mm (15.75 in.).
(b) Wind the cable to retract the rod by turning the ignition switch
to ºLOCKº position.
HINT:
w If the ignition switch is already in ºLOCKº position,
perform step 1.
w In case the cable is not wound, twist it as shown in the
illustration.
w Even if the rod has not retracted fully, install the ant enna
nut and inspect the antenna rod operation. It will finally
retract fully.
(c) Inspect the antenna rod operation by pushing the radio wave
band select buttons.
MOTOR ANTENNA INSPECTION
1. INSPECT MOTOR ANTENNA (Circuit)
Disconnect the motor antenna connector from the body wire
harness and inspect the connector on body wire harness side
as shown.
Check for Tester connection\
\
Condition Specified value
Continuity 7±Ground\
\
Constant Continuity
Voltage 3±Ground\
\
Constant Battery positive voltage
g
8±Ground Ignition switch ACC or ON Battery positive voltage
8±Ground
g
position LOCK No voltage
6±Ground Ignition switch ON Battery positive voltage
6±Ground
g
position ACC or LOCK No voltage
2±Ground Ignition switch Radio or Tape or CD switch ON Battery positive voltage
2±Ground
g
ACC or ON Radio or Tape or CD switch OFF No voltage
5±Ground Ignition switch Radio switch ON Battery positive voltage
5±Ground
g
ACC or ON Radio switch OFF No voltage
4±Ground
Ignition switch
ACC or ON and
AM or FM (87.9 ± 96.0 MHz) Battery positive voltage
4±Ground ACC or ON and
radio switch ON Others No voltage
1±Ground
Ignition switch
ACC or ON and
AM
Battery positive voltage
radio switch ON Others No voltage
If circuit is not as specified, inspect radio or wire harness. If
circuit is as specified, replace motor antenna.
±
BODY ELECTRICAL SYSTEM AUDIO SYSTEMBE±215
WhereEverybodyKnowsYourName
