and Window Glass
installation bolt
up-stop bolt
5. Before proceeding with these adjustments,
a) Mark each adjusting stud bolt prior to loosening.
NOTE
Scratch around adjusting stud bolt as point of reference
after starting to adjust
b) Loosen one adjusting stud bolt/nut at a time.
6. Lower the quarter window slightly, loosen the up -stop
installation bolt(s).
7. Adjust using the up-stop installation bolts so that the
difference in the quarter window glass height from the
door window glass height is at the standard value.
Standard value (A): 0 2.0 mm (0
NOTE
Any adjustment to the up-stop installation bolts af fects
front door glass gap (illustration A
A, A’ A’).
TSB Revision
BODY Windshield and Window Glass
A
Section
Quarter
Door window glassSash weatherstrip
up-stopup-stopinstallation bolt
8. Adjust using the up-stop installation bolts so t
hat the
clearance between the quarter
glass sash
weatherstrip and the door window is at the standard
value.
Standard value (B): 8.3 2.0 mm in.)
NOTE
If dimensions of section A and A’ A’ are adjusted,
the height of the quarter window glass may be chang ed.
Confirm the height of the quarter window glass again.
(Refer to view A in the illustration.)
9.Measure the quarter window to front door gap 76.2 m m
(3.0 in.) from the top of the, door glass and 76.2 mm
(3.0 in.) from the top of the front door. Adjust so that,
gap is same at both locations.
10. Open and close the front door several times aft er
adjustment to ensure settings are good.
TSB Revision
