1990 MITSUBISHI ECLIPSE Service Manual

23-44BODY -Seat Belts
WARNING LIGHT OPERATION (TERMINAL No. 10)
Status at input side
VVarning alarm whenlgnition switchOFF 3 ONignition switch is
activated
Other than as above
Warning alarm whenautomatic seat belt
fastening is
incomplete
1 Ignition switch
Driver’s or passenger’s seatION
belt
r;tNfasyed
’(“Fasten” switch, Door latchswitch “close”)
Other than as above
Warninn alarm whenIgnition switch1 ONdriver’sshoulder belt -
is not fastenedDriver’s door
Driver’s shoulder belt
(“Fasten” switch)
Closed
Fastened
(OFF)Driver’s outer switch
Other than as above
OFF
Warning alarm whenfront passenger’s
shoulder belt is not
fastenedPassenger’s outer switch
lgnition
swtich
Other than as above
OFF
OFF+ ON
r
Light
ON
OFF
ON
OFF
ON
OFF
ON
OFF
DRIVER’S SHOULDER BELT FASTENING OPERATION (TERMINAL No.8)Status at input side
Driver’s shoulder belt
is fastened.
‘~
Other than as aboveOutput signal waveforms
and operation status
Output signalFFF,
LJ
(ON)t, +j ‘$;P$
Approx.0.7 sec.
1Output
signal waveforms and operation status
MotorOutput signal
Operates.stops.
(ON).l---l
Max. 60 sec.

BODY - Seat Belts23-45QRIVER’S SHOULDER BELT RELEASING OPERATION (TERMINAL
No.9)Status at input sideOutput signal waveforms and operation status
Motor
Output signal
Driver’s shoulder beltDriver’s door
is released.OpenOperates. H
(A)Driver’s shoulder beltNot released(OFF)
Other than as abovestops.:ONl -$<
Max. 60 setDriver’s shoulder beltlgnition switch
OFFis released.Operates.
03)Driver’s shoulder.beltNot released(“Release” switch)
(ON)
Key(Key-reminder switchNot in cylinder(OFF/ON)FFF)
1 ;: r
A/B)(ON1p-9 Max. 60 sec.
Other than as abovestops.
FRONT PASSENGER’S SHOULDER BELT FASTENING OPERATION (TERMINAL No. 18)
Status at input side
Ignition switch
Front passenger’s
shoulder belt(“Fasten” switch,
Door latch switch
“close”)
Other than as above
ONNot fastened
(ON, ON)Output signal waveforms and operation status
Motor
IOutput signal
Operates.- Max. 60 sec.
stops.
IFRONT PASSENGER’S SHOULDER BELT RELEASING OPERATION (TERMINAL No. 19)
Status at input sideOutput signal waveforms and operation status
Motor
Output signal
Front passenger’s
shoulder belt is
released.(A)

23-46REAR SEAT BELTBODY - Seat Belts
The rear seat belts are the
3-point seat belts with
ELR which ensures safety of the rear-seat
passen-
gers.The buckle can be tilted forward and inward, whicn
helps make the belts tight around the body.
Retractor
BuckleInward
Forward

24-1
HEATERS
CONDITIONING
CONTENTS Rx&--
.._.........I............................... 8 HEATER CONSTRUCTIO N. . . . . . . . .._..................... 5
Compressor Control . . . . . . . . . . . . . . . . . . . . . . . . . . . . _ . . . . . . .._.. 8IDLE SPEED CONTRO L. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . \
. . . . 9
tNFORMATt0N. . . . . . .._................_......2

24-2 HEATERS AND AIR CONDITIONING
1 OPA17 swash plate t:
To defroster
/A\To side defroster
9G-3 53033
ventilators
‘lo’
Driver’s seat-knee area3$
(under the fieering wheel)b
Side ventilatbr(driver’s seat side) G
Center
20A03M

_-‘5sY-HEATERS AND AIR CONDITIONING
- General Information
COMPONENTS24-3Three-Iaye; flow full
blend air heater

L.
24-4HEATERS AND AIR CONDITIONING - General Information
’ /To side (door) window
(side defroster)
t4L\ m\vTofacearea
/(side ventilator)To windshiel
(defroster)
To side (door) window
(side defroster)
Blower switch
Toface area(side ventilator)
u rorootanTemperature control knob
, , , ,Air-selection lever
Air conditioner switch
OPERATION DIAGRAM OF COMPRESSOR MAGNET
CLUTCHNOTETemperature values shown are for information only.
Air conditioning and
ECONO mode OFFAir conditioning and
ECONO mode ON
II
32 (89.6)
Evaporatorinlet temperature “WF)

HEATERS AND AIR CONDITIONING- General information I Heater Construction24-5
16AO611
Section A-A
Air intake garnish
Check
Section B-B
HEATER CONSTRUCTIONThe air-selection damper (located at the upper
part of the blower motor) can be used to select
either induction of outside air from the front
deck, or circulation of inside air.
The air taken in by the blower motor is passed
through the duct or evaporator (air conditioner
equipped vehicles) for forced supply to the
heater unit. At the right side of the heater unit is
Mode selectionTo defroster
damper
!DEF) mMode selection
3.the btend air damper. Depending on the temper-
ature control knob setting, the amount of blend#waAA
air which has passed through the heater core
and of cool air which has not passed through the
heater core is varied, thus regulating the temper-
ature.The area to which the air will
flow can be
selected by the mode-selection damper.
nFresh airMode selection
To foot areaair damper\IEvaporatorBlower motorRecirculation
dair
To foot area+-l