2023 TOYOTA RAIZE Headlight

3556-3. Do-it-yourself maintenance
RAIZE_OM_General_BZ358E
Maintenance and care
6
cReplace and attach the light bulb
Align the light bulb’s claws (3 locations)
to the mounted area, insert it and
secure it in place.
aLow beam (outside)
b High beam (inside)
d Attach the socket
After attaching the socket, turn on the
headlights and make sure there is no
light leaking out.
12
KBRO620818N
KBRO620819N
RAIZE_OM_General_BZ358E.book 355 ページ ２０２２年５月１７日　火曜日　午後１時５９分

3566-3. Do-it-yourself maintenance
RAIZE_OM_General_BZ358E
⬛Front turn signal/emergency flashers (vehicles with halogen
headlights)
a Open the hood, and rotate the
socket to remove it
b Remove the light bulb
c Attach the new light bulb, rotate
the socket and set it in place
KBRO620820N
KBRO620821N
KBRO620822N
RAIZE_OM_General_BZ358E.book 356 ページ ２０２２年５月１７日　火曜日　午後１時５９分

3576-3. Do-it-yourself maintenance
RAIZE_OM_General_BZ358E
Maintenance and care
6
⬛Front position lights (vehicles with halogen headlights)
a Open the hood, and rotate the
socket to remove it
b Remove the light bulb
c Attach the new light bulb, rotate
the socket and set it in place
KBRO620823N
KBRO620824N
KBRO620825N
RAIZE_OM_General_BZ358E.book 357 ページ ２０２２年５月１７日　火曜日　午後１時５９分

3636-3. Do-it-yourself maintenance
RAIZE_OM_General_BZ358E✽
: If equipped
Maintenance and care
6
⬛Other light bulbs
If any other light bulbs go out, replace them at your Toyota dealer.
⚫Headlight high beam/low beam (vehicles with LED headlights)
⚫Daytime running lights✽
⚫Front position lights (vehicles with LED headlights)
⚫Front turn signal/emergency flashe rs (vehicles with LED headlights)
⚫Side turn signal lights/emergency flashers
⚫Stop lights/tail lights
⚫High mounted stoplight
⚫Rear fog light✽
⬛LED lights
Each unit of LED headlights,
✽ daytime running lights✽, and high mounted stop-
light are made of several LEDs. If any one of the LEDs do not light up, replace it
at your Toyota dealer.
⬛When replacing the front fog lights✽
Remove the retaining clips of the fender liner and replace the light bulb. After
replacement, be sure to hold the fender liner with the clips and secure it in
place.
⚫When you remove the clip, use a
tool such as a flathead screwdriver
to pull out the center of the clip ( a)
and take the clip off ( b).
To prevent damage, wrap a cloth
around the tip of the flathead screw-
driver or the like to protect it.
⚫When you attach the clip, insert the
clip ( a) and push down the center
part ( b).
12
KBGR620838
12
KBGR620839
RAIZE_OM_General_BZ358E.book 363 ページ ２０２２年５月１７日　火曜日　午後１時５９分

3646-3. Do-it-yourself maintenance
RAIZE_OM_General_BZ358E
⬛Water droplets and condensation in the lens
Temporary condensation build-up on the inside of the lens does not indicate a
malfunction. However, contact your Toyota dealer in the following situations:
⚫Large drops of water have built up on the inside of the lens
⚫Water has built up inside the light
⬛When replacing light bulbs
➞P. 3 5 2
WARNING
⬛When replacing light bulbs
⚫Turn off the lights. Do not attempt to replace the bulb immediately after
turning off the lights. The bulbs be come very hot and may cause burns.
There is also a danger of electric shock.
⚫Do not touch the glass portion of the light bulb with bare hands.
When it is unavoidable to hold the gl ass portion, use and hold with a clean
dry cloth to avoid getting moisture and oils on the bulb.
Also, if the bulb is scratched or dropped, it may blow out or crack.
⚫Fully install light bulbs and any parts us ed to secure them. Failure to do so
may result in heat damage, fire, or water entering the headlight unit. This
may damage the headlights or cause condensation to build up on the lens.
⚫Do not repair or disassemble light bulbs, sockets, electrical circuits, or com-
ponents.
Electric shock may result in death or serious injury.
⬛To prevent vehicle damage or fire
⚫Make sure bulbs are securely in stalled in the correct position.
⚫Check the wattage of the bulb before installing to prevent heat damage.
RAIZE_OM_General_BZ358E.book 364 ページ ２０２２年５月１７日　火曜日　午後１時５９分

4057-2. Steps to take in an emergency
RAIZE_OM_General_BZ358E
When trouble arises
7
If the engine does not start
If the engine does not start even though correct starting procedures
are being followed ( ➞P. 184), consider each of the following points:
The engine does not start even though the starter motor operates
normally
One of the following may be the cause of the problem:
⚫There may not be sufficient fuel in the vehicle’s tank.
Refuel the vehicle.
⚫The engine may be flooded.
Try to restart the engine again fo llowing correct starting procedures
( ➞ P. 1 8 4 ) .
⚫There may be a malfunction in th e engine immobilizer system. (➞P. 72)
The starter motor runs slowly, the interior light and headlights are
dim, or the horn does not so und or sounds at a low volume
One of the following may be the cause of the problem:
⚫The battery may be discharged. ( ➞P. 408)
⚫The battery terminal connections may be loose.
If the starter does not operat e (vehicles with key-free system)
⚫There may be an issue in the electrical system, such as a disconnected
electrical component or blown fuse. Depending on the cause, you may
be able to start the engine using temporary measures. ( ➞P. 406)
⚫There may be a malfunction in the steering wheel lock system.
The starter motor does not run, the interior light and headlights do
not turn on, or the horn does not sound
One of the following may be the cause of the problem:
⚫There may be a disconnected battery terminal.
⚫The battery may be discharged. ( ➞P. 408)
Contact your Toyota dealer if the procedures are not clear, or if the engine does not
start even after the measures have been taken.
RAIZE_OM_General_BZ358E.book 405 ページ ２０２２年５月１７日　火曜日　午後１時５９分

4288-1. List of specifications
RAIZE_OM_General_BZ358E✽
: If equipped
Tires and wheels
Light bulbs
A : HB3 halogen bulbs
B : H11 halogen bulbs
C : Wedge base bulbs (amber) D : Wedge base bulbs (clear)
E : H16 halogen bulbs
F : Double end bulbs
Tire size205/65R16 95H
Tire inflation pres-
sure (Recom-
mended cold tire
inflation pressure)Front wheels
kPa (kgf/cm
2 or bar, psi)
Rear wheels
kPa (kgf/cm
2 or bar, psi)
240 (2.4, 35)240 (2.4, 35)
Wheel size16 x 6J
Wheel nut torque103 N·m (10.5 kgf·m, 76 ft·lbf)
Tire size205/60R17 94H
Tire inflation pres-
sure (Recom-
mended cold tire
inflation pressure)Front wheels
kPa (kgf/cm
2 or bar, psi)
Rear wheels
kPa (kgf/cm
2 or bar, psi)
240 (2.4, 35)240 (2.4, 35)
Wheel size17 x 6J
Wheel nut torque103 N·m (10.5 kgf·m, 76 ft·lbf)
Light BulbsWType
Exterior
Headlights✽
High beam
Low beam60
55A
B
Front turn signal lights✽21C
Front position lights✽5D
Front fog lights✽19E
Rear turn signal lights21C
License plate lights5D
Back-up lights16D
Interior
Front personal lights5D
Rear interior light8F
Luggage compartment light5D
RAIZE_OM_General_BZ358E.book 428 ページ ２０２２年５月１７日　火曜日　午後１時５９分

4318-2. Customizations
RAIZE_OM_General_BZ358E✽
: If equipped
Vehicle information
8
⬛Door lock ( ➞P. 136)
⬛Back door (vehicles with key-free system) ( ➞P. 142)
⬛BSM✽. RCTA✽ (➞ P. 211)
⬛Lights ( ➞P. 198)
FeatureInitial settingCustomized setting
Speed linked door locking functionONNone
Shifting the shift lever to positions
other than P locks all doors
(Shift position linked door locking)
✽
NoneON
Shifting the shift lever to P unlocks
all doors
(Shift position linked door unlock-
ing)
✽
NoneON
Turning the engine switch to “ACC”
or “OFF” unlocks all doors
(Engine switch “OFF” linked auto-
matic door unlocking)
NoneON
FeatureInitial settingCustomized setting
Operation with the switch on the
right side of the back doorLock onlyLock and unlock
FeatureInitial settingCustomized setting
Brightness of the outside rear view
mirror indicatorsBrightDark
FeatureInitial settingCustomized setting
Automatic light off systemEngine switch linkedDriver’s door linked
Follow me home✽ (Time elapsed
before headlights automatically turn
off)
30 seconds
60 seconds
90 seconds
120 seconds
Timing of the headlight switch being
turned on and off automaticallyNormalFast
Slow
RAIZE_OM_General_BZ358E.book 431 ページ ２０２２年５月１７日　火曜日　午後１時５９分