501-2. Safety information for children
RAIZE_OM_General_BZ358E
Child restraint system compatibility
⬛Weight groups
Child restraint systems that meet the cr iteria of UN (ECE) R44* are classi-
fied into the following 5 types according to the weight of the child.
Group 0 : Up to 10 kg (22 lb.)
Group 0
+ : Up to 13kg (28 lb.)
Group I : 9 to 18 kg (20 to 39 lb.)
Group II : 15 to 25kg (34 to 55 lb.)
Group III : 22 to 36kg (49 to 79 lb.)
*UN (ECE) R44 is an international re gulation on child restraint systems.
RAIZE_OM_General_BZ358E.book 50 ページ 2022年5月17日 火曜日 午後1時59分
521-2. Safety information for children
RAIZE_OM_General_BZ358E
WARNING
⬛When a child is riding
Observe the following precautions.
Failure to do so may result in death or serious injury.
⚫For effective protection in automobile accidents and sudden stops, a child
must be properly restrained, using a seat belt or child restraint system which
is correctly installed. For installation details, refer to the operation manual
enclosed with the child restraint syst em. General installation instruction is
provided in this manual.
⚫Toyota strongly urges the use of a proper child restraint system that con-
forms to the weight and size of the child, installed on the rear seat. Accord-
ing to accident statistics, the child is safer when properly restrained in the
rear seat than in the front seat.
⚫Holding a child in your or someone else ’s arms is not a substitute for a child
restraint system. In an accident, the child can be crushed against the wind-
shield or between the holder and the interior of the vehicle.
⬛Handling the child restraint system
If the child restraint system is not properly fixed in place, the child or other
passengers may be seriously injured or even caused death in the event of sud-
den braking, sudden swerving, or an accident.
⚫If the vehicle were to receive a strong im pact from an accident, etc., it is pos-
sible that the child restraint system has damage that is not readily visible. In
such cases, do not reuse the restraint system.
⚫Depending on the child restraint syst em, installation may be difficult or
impossible. In those cases, check whether the child restraint system is suita-
ble for installment in the vehicle. (➞ P. 5 5 )
⚫Be sure to install and observe the us age rules after carefully reading the
child restraint system fixing method in this manual, as well as the operation
manual enclosed with the child restraint system.
⚫Keep the child restraint system properly secured on the seat even if it is not
in use. Do not store the child restraint system unsecured in the passenger
compartment.
⚫If it is necessary to detach the child re straint system, remove it from the vehi-
cle or store it securely in the luggage compartment.
RAIZE_OM_General_BZ358E.book 52 ページ 2022年5月17日 火曜日 午後1時59分
551-2. Safety information for children
RAIZE_OM_General_BZ358E
For safety and security
1
Child restraint system compatibility for each seating position
⬛Child restraint system compatibility for each seating position
Compatibility of each seating positi on with child restraint systems (➞P. 5 6 )
displays the type of child restraint systems that can be used and possible
seating positions for installation using symbols. Also, the recommended
child restraint system that is suitable for your child can be selected.
Otherwise, check [Recommended child restraint systems and Compatibil-
ity table] for recommended child restraint systems. (➞P. 59)
Check the selected child restraint system together with the following
[Before confirming the compatibility of each seating position with child
restraint systems].
⬛Before confirming the compatibilit y of each seating position with
child restraint systems
a Checking the child rest raint system standards.
Use a child restraint system th at conforms to UN(ECE) R44*
1 or
UN(ECE) R129*
1, 2. The following approval mark is displayed on child
restraint systems which are conformed.
Check for an approval mark attached to the child restraint system.
▶Example of the displayed regu-
lation number
a UN(ECE) R44 approval mark*
3
The weight range of the child
who is applicable for an
UN(ECE) R44 approval mark is
indicated.
bUN(ECE) R129 approval mark*3
The height range of the child
who is applicable as well as
available weights for an
UN(ECE) R129 approval mark
is indicated.
*1UN(ECE) R44 and UN(ECE) R129 are U.N. regulations for child restraint sys-
tems.
*2The child restraint systems mentioned in the table may not be available
outside of the EU area.
*3The displayed mark may differ depending on the product.
KBTA110604
RAIZE_OM_General_BZ358E.book 55 ページ 2022年5月17日 火曜日 午後1時59分
2364-5. Using the driving support systems
RAIZE_OM_General_BZ358E
WARNING
⬛The ABS does not operate effectively when
⚫Do not overly rely on the ABS.
The limits of tire gripping performance have been exceeded (such as exces-
sively worn tires on a snow covered road).
⚫The vehicle hydroplanes while driving at high speed on wet or slick roads.
⬛Stopping distance when the ABS is operating may exceed that of normal
conditions
The ABS is not designed to shorten th e vehicle’s stopping distance. Always
maintain a safe distance from the vehicle in front of you, especially in the fol-
lowing situations:
⚫When driving on dirt, grav el or snow-covered roads
⚫When driving with tire chains
⚫When driving over bumps in the road
⚫When driving over roads with potholes or roads with uneven surfaces
⬛TRC/VSC may not operate effectively when
⚫Do not overly rely on the TRC/VSC.
Directional control and power may not be achievable while driving on slip-
pery road surfaces, even if the TRC/VSC system is operating.
Drive the vehicle carefully in condit ions where stability and power may be
lost.
⚫The VSC and TRC may not function proper ly when tire chains are installed.
⬛Hill-start assist control does not operate effectively when
⚫Do not overly rely on hill-start assist control. Hill-start assist control may not
operate effectively on steep inclines an d dirt, gravel or snow-covered roads.
⚫Unlike the parking brake, hill-start assist control is not intended to hold the
vehicle stationary for an extended period of time. Do not attempt to use hill-
start assist control to hold the vehicle on an incline, as doing so may lead to
an accident.
⚫The hill-start assist control may no t become activated depending on the
number of occupants or luggage weight in the vehicle, or if the driver did not
step on the brake pedal strong enough when stopping.
⬛When the VSC is activated
The slip indicator light flashes. Always drive carefully. Reckless driving may
cause an accident. Exercise particular care when the indicator light flashes.
⬛When the ABS warning light or slip indicator is on
The emergency brake signal ( ➞P. 232) may not be activated.
RAIZE_OM_General_BZ358E.book 236 ページ 2022年5月17日 火曜日 午後1時59分
2876-1. Maintenance and care
RAIZE_OM_General_BZ358E
NOTICE
✽: If equipped
Maintenance and care
6
⬛Cleaning the exterior lights
⚫Wash carefully. Do not use any organic solvent or scrub with a hard brush.
This may damage the su rfaces of the lights.
⚫Do not apply wax to the surfaces of the lights.
Wax may cause damage to the lenses.
⬛To prevent damage to the outside rear view mirrors
When using an automatic car wash, fo ld the outside rear view mirrors.
⬛Handling of the pole antenna✽
When handling the antenna, do not use ex cessive force. It may lead to defor-
mation of the body or damage to the antenna.
⬛To prevent damage to the pole antenna✽
⚫Retract the antenna if it touches the garage ceiling, etc.
⚫Remove the antenna in the following cases
⦁ When covering the vehicle with a car cover
⦁ When using an automatic car wash
⦁ When parking the vehicle for a long time during snowfall
⬛Removing the pole antenna✽
⚫Make sure that the antenna is insta lled to the vehicle when driving normally.
⚫Be careful not to misplace the antenna when removing it for using an auto-
matic car wash, etc. Replace the ante nna on your vehicle before resuming
driving.
⬛Precautions when wa shing the vehicle
⚫When washing the vehicle, do not pre ss hard, such as by applying weight.
The vehicle body may be dented.
⚫Check that the fuel filler door is cl osed. High water pressure can cause the
fuel filler door to open vigorously and damage the vehicle body and fuel filler
door.
⚫Washing the vehicle with hot water may damage plastic parts.
⚫When you wash the car with a machine using steam, keep the steam away
from the sonar area. The steam may cause the system to malfunction.
⚫Do not use detergents or waxes containing abrasives (compounds).
⬛When using an automatic car wash
Set the air conditioning system to “recirculated air mode”. Water may get
inside the vehicle and cause a malfunction.
RAIZE_OM_General_BZ358E.book 287 ページ 2022年5月17日 火曜日 午後1時59分
3136-3. Do-it-yourself maintenance
RAIZE_OM_General_BZ358E
WARNING
Maintenance and care
6
⬛When closing the hood
Be careful not to get your hands
caught.
There is a danger of serious injury.
⬛When opening the hood
Make sure to use the support rod to support the hood when opening it, ensur-
ing that the rod is fixed correctly. Th e hood may stay open without support on
slope, however, it is dangerous because the hood may suddenly close.
NOTICE
⬛When opening the hood
Do not open the hood with the windshield wiper arms raised. The wipers may
hit the hood and damage it.
⬛When inspecting the engine compartment
Do not place anything around the lowe r part of the windshield. Objects may
fall into the engine and cause a malfunction.
⬛To prevent damage to the hood
When closing the hood, do not press hard, such as by applying weight.
The hood may be dented.
⬛When closing the hood
Remove the hood stay from the stay hole and correctly return it to its clip.
Closing the hood when the stay is not pr operly returned to its clip may damage
the hood and the stay.
KBRO620104E
RAIZE_OM_General_BZ358E.book 313 ページ 2022年5月17日 火曜日 午後1時59分
3366-3. Do-it-yourself maintenance
RAIZE_OM_General_BZ358E✽
: If equipped
Wheels
If a wheel is bent, cracked or heavily corroded, it should be replaced.
Otherwise, the tire may separate from the wheel or cause a loss of
handling control.
Wheel selection
When replacing wheels, care should be taken to ensure that they are
equivalent to those removed in load capacity, diameter, rim width and
inset*.
Replacement wheels are available at your Toyota dealer.
*Conventionally referred to as “offset”.
Toyota does not recommend using the following:
⚫Wheels of different sizes or types
⚫Used wheels
⚫Bent wheels that ha ve been straightened
Aluminum wheel
✽ precautions
⚫Use only Toyota wheel nuts and wrenches designed for use with your
aluminum wheels.
⚫When rotating, repairing or changing your tires, check that the wheel
nuts are still tight after driving 1600 km (1000 miles).
⚫Use only Toyota genuine balance weights or equivalent and use a plastic
or rubber hammer when balancing your wheels.
⬛When replacing wheels (vehicles with a tire pressure warning system)
The wheels of your vehicle are equipped with tire pressure warning valves and
transmitters that allow the tire pressu re warning system to provide advance
warning in the event of a lo ss in tire inflation pressure. Whenever wheels are
replaced, tire pressure warning valves and transmitters must be installed.
( ➞ P. 328)
RAIZE_OM_General_BZ358E.book 336 ページ 2022年5月17日 火曜日 午後1時59分
3807-2. Steps to take in an emergency
RAIZE_OM_General_BZ358E ✽
: If equipped
SRS warning light
⦁Malfunction in the SRS airbag system
⦁Malfunction in the seat belt pr etensioner & force limiter system
➞ Have the vehicle inspected at your Toyota dealer immedi-
ately.
ABS warning light
Malfunction in the ABS system
➞ Have the vehicle inspected at your Toyota dealer immedi-
ately.
(Red)
Electric power steering system warning light (warning buzzer)
Malfunction in EPS (Electric Power Steering) system
➞ Have the vehicle inspected at your Toyota dealer immedi-
ately.
*2
(Yellow)
Electric power steering system warning light (warning buzzer)
Low battery voltage/Electric power steering overheating
➞ Steering wheel operation becomes heavy. Restrain from
operating the steering wheel fo r a short while. When about
10 minutes has passed, it will return to its usual weight.
Front corner sensor/Reverse sensor indicator✽ (warning buzzer)
Master warning light
✽
Malfunction of the front corner sensors or reverse sensor
➞ Have the vehicle inspected at your Toyota dealer.
Slip indicator
⦁Malfunction in the brake assist
⦁Malfunction in the VSC system
⦁Malfunction in the TRC system (Flashes when VSC/TRC is
activated ➞P. 233)
⦁Malfunction in the hill-sta rt assist control system
➞ Have the vehicle inspected at your Toyota dealer.
(Flashing)
BSM OFF indicator✽
Area surrounding radar sensor on rear bumper ( ➞P. 214) is cov-
ered with rain, snow, ice, dirt, etc.
➞ Remove the rain, snow, ice, dirt, etc. If flashing persists even
after some time has elapsed since removal, have the vehicle
inspected at your Toyota dealer.
Warning lightsWarning light name/Warning content/Action to take
RAIZE_OM_General_BZ358E.book 380 ページ 2022年5月17日 火曜日 午後1時59分