2022 TOYOTA BZ4X CAN

445
6
Owners Manual_Europe_M42D76_en
6-4. Using the other interior features
Interior features
The USB Type-C charging ports
are used to supply 3 A of electricity
at 5 V to external devices.
The USB Type-C charging ports
are for charging only. They are not
designed for data transfer or other
purposes.
Depending on the external device,
it may not charge properly. Refer to
the manual included with the device
before using a USB charging port.
Refer to “Multimedia owner’s man-
ual” for USB Type-A information.
■Using the USB Type-C
charging ports
Center console
Rear
■The USB Type-C charging ports can be used when
The power switch is in ACC or ON.
■Situations in which the USB Type-C charging ports may not operate correctly
●If a device which consumes more than 3 A at 5 V is connected
●If a device designed to communicate with a personal computer, such as a
USB memory device, is connected
●If the connected external device is
turned off (depending on device)
●If the temperature inside the vehicle is
high, such as after the vehicle has
NOTICE
■When power outlet is not in use
To avoid damaging the power outlet,
close the power outlet lid when the power outlet is not in use.Foreign objects or liquids that enter
the power outlet may cause a short circuit.
■To prevent 12-volt battery dis-charge
Do not use the power outlet longer
than necessary when the EV system is off.
■To prevent incorrect operation of the vehicle
When turning the power switch off,
make sure to disconnect accessories designed for charging, such as porta-ble chargers, power banks, etc. from
the power outlets.
If such an accessory is left connected, the following may occur:
●The doors will not be able to be locked.
●The opening screen will be dis-played on the multi-information dis-
play.
●The interior lights, instrument panel
lights, etc. will illuminate.
USB Type-C charging ports

446
Owners Manual_Europe_M42D76_en
6-4. Using the other interior features
been parked in the sun
■About connected external devices
Depending on the connected external device, charging may occasionally be suspended and then start again. This is
not a malfunction.
A portable device can be charged
by just placing Qi standard wireless
charge compatible portable devices
according to the Wireless Power
Consortium, such as smartphones
and mobile batteries, etc., on the
charge area.
This function cannot be used with
portable devices that are larger
than the charging tray. Also,
depending on the portable device, it
may not operate as normal. Please
read the operation manual for por-
table devices to be used.
■The “Qi” symbol
The “Qi” symbol is a trademark of
the Wireless Power Consortium.
■Name for all parts
Charging tray
Charging area*
Operation indicator light
*: Portable devices and wireless char-
gers contain charging coils. The
charging coil in the wireless charger
can be moved within the charge area
near the center of the charging tray. If
NOTICE
■To prevent damage to the USB Type-C charging ports
●Do not insert foreign objects into the ports.
●Do not spill water or other liquids into the ports.
●Do not apply excessive force to or impact the USB Type-C charging ports.
●Do not disassemble or modify the USB Type-C charging ports.
■To prevent damage to external devices
●Do not leave external devices in the vehicle. The temperature inside the vehicle may become high, resulting
in damage to an external device.
●Do not push down on or apply
unnecessary force to an external device or the cable of an external device while it is connected.
■To prevent 12-volt battery dis-charge
Do not use the USB Type-C charging ports for a long period of time with the EV system stopped.
Wireless charger (if
equipped)

447
6
Owners Manual_Europe_M42D76_en
6-4. Using the other interior features
Interior features
the charging coil inside a portable
device is detected in the charge area,
the charging coil inside the wireless
charger will move toward it and start
charging. If the charging coil inside a
portable device moves outside of the
charge area, charging will automati-
cally stop.
If 2 or more portable devices are
placed on the charging tray, their
charging coils may not be properly
detected and they may not be
charged.
■Using the wireless charger
1 Open the lid.
2 Place the portable device on the
charging tray.
Place the charging side of the portable
device down with the center of the
device in the center of the charge area.
Depending on the portable device, the
charging coil may not be located in the
center of the device. In this case, place
the portable device so that its charging
coil is in the center of the charge area.
When charging, the operation indicator
light (orange) comes on.
If charging is not occurring, try placing
the portable device as close to the
center of the charging area as possible.
When charging is complete, the opera-
tion indicator light (green) comes on.
■Recharging function
 When charging is complete and
after a fixed time in the charge
suspension state, charging
restarts.
 When a portable device is
moved significantly in the charge
area, the charging coil is discon-
nected and charging is stopped
momentarily. However, if there is
a charging coil in the charge
area, the charging coil inside the
wireless charger will move
toward it and then charging
restarts.
■Rapid charging function
 The following portable devices
support rapid charging.
• Portable devices compliant with WPC
Ver1.2.4 and compatible with rapid
charging
• iPhone’s with an iOS version that
supports 7.5 W charging (iPhone 8
and later models)
 When a portable device that sup-
ports rapid charging is charged,
charging automatically switches
to the rapid charging function.

449
6
Owners Manual_Europe_M42D76_en
6-4. Using the other interior features
Interior features
■The wireless charger can be oper- ated when
The power switch is in ACC or ON.
■Portable devices that can be charged
●Portable devices compatible with the Qi wireless charging standard can be charged by the wireless charger. How-
ever, compatibility with all devices which meet the Qi wireless charging
Green (comes on)Blue
AM radio stations are being automat-
ically selected
 Wait until the system has com-
pleted the automatic selection of
AM radio stations. In the case that
automatic selection cannot be
completed, stop automatic selec-
tion.
The smart entry & start system is
detecting the key
 Please wait until the key detection
is complete.
Orange (Repeat-
edly flashes 3 times
continuously)
Gray
Foreign substance detection:
A metallic foreign substance is in the
charge area, and so the abnormal
heating prevention function of the
charging coil operated
 Remove the foreign substance
from the charge area.
Portable device misaligned:
 The charging coil in the portable
device moved outside of the
charge area, and so the abnormal
heating prevention function of the
charging coil operated
Orange (Repeat-
edly flashes 4 times
continuously)
Gray
Safety shutdown resulting when the
temperature within the wireless char-
ger exceeded the set value
 Stop charging, remove the porta-
ble device from the charging tray,
wait for the temperature to drop,
and then start charging again.
Operation indicator
light
Multimedia system
screenSuspected causes/Handling method

450
Owners Manual_Europe_M42D76_en
6-4. Using the other interior features
standard is not guaranteed.
●The wireless charger is designed to supply low power electricity (5 W or
less) to a cellular phone, smartphone, or other portable device.
●Failure to do so may result in the pos-sibility of fire, However, portable devices, such as the following, can be
charged with more than 5 W. • 7.5 W charging compatible iPhones can be charged at 7.5 W or less.
• Portable devices which conform to WPC Ver 1.2.4 (Extended Power pro-file) can be charged at 10 W or less.
■When covers and accessories are
attached to portable devices
Do not charge in situations where cover and accessories not able to handle Qi
are attached to the portable device. Depending on the type of cover (includ-ing for certain genuine manufacturer
parts) and accessory, it may not be pos- sible to charge.When charging is not performed even
with the portable device placed on the charge area, remove the cover and accessories.
■Charging precautions
●If the electronic key cannot be detected in the cabin, charging cannot
be performed. When a door is opened and closed, charging may be tempo-rarily suspended.
●While charging, the wireless charger and the portable device will become
warm. This is not a malfunction. If a portable device becomes warm while charging and charging stops
due to the protection function of the portable device, wait until the portable device cools down and charge it
again.
●Depending on usage of the portable
device, it may not be fully charged. This is not a malfunction.
■Important points of the wireless charger
●If the electronic key cannot be
detected within the vehicle interior,
charging can not be done. When the door is opened and closed, charging may be temporarily suspended.
●When charging, the wireless charging device and portable device will get
warmer, however this is not a mal- function. When a portable device gets warm while charging may stop due to
the protection function on the portable device side. In this case, when the temperature of the portable drops sig-
nificantly, charge again. The fan may start operating to lower the temperature inside the wireless
charger, however this is not a mal- function.
■Sound generated during operation
When the power supply switch is turned
on or while a portable device is being identified, operation sounds may be heard. This is not a malfunction.
■Cleaning the wireless charger
 P. 4 6 0
■Certification
 P. 6 6 2
WARNING
■Caution while driving
When charging a portable device, for safety reasons, the driver should not operate the main part of the portable
device while driving.
■Caution while in motion
Do not charge lightweight devices such as wireless headphones while in motion. These devices are very light
and may be ejected from the charging tray, which may lead to unforeseen accidents.

452
Owners Manual_Europe_M42D76_en
6-4. Using the other interior features
Fold down the armrest for use.
NOTICE
• A case or cover attached with an uneven or tilted surface, so that the
charging side is not flat
• Thick decorations
• Accessories, such as finger rings, straps, etc.
●When the portable device is in con-tact with, or is covered by any of the
following metallic objects:
• A card that has metal on it, such as
aluminum foil, etc.
• A pack of cigarettes that includes
aluminum foil
• A wallet or bag that is made of
metal
•Coins
• A heating pad
• CDs, DVDs or other media
• A metal accessory
• A case or cover made of metal
●Electric wave type wireless remote controls are being used nearby
●The electronic key is not inside the vehicle
●2 or more portable devices are placed on the charging tray at the same time
If charging is abnormal or the opera- tion indicator light continues to flash
for any other reason, the wireless charger may be malfunctioning. Con-tact any authorized Toyota retailer or
Toyota authorized repairer, or any reli- able repairer.
■To prevent malfunctions and data corruptions
●When charging, bringing a credit, or
other magnetic card, or magnetic storage media close to the charge area may clear any stored data due
to magnetic influence. Also, do not bring a wristwatch or other preci-sion instrument close to the charge
area since doing so may cause it to malfunction.
●Do not charge with a non-contact IC card such as a transportation sys-tem IC card inserted between the
charging side of a portable device and the charge area. The IC chip may become extremely hot and
damage the portable device or IC card. Be especially careful not to charge a portable device inside a
case or cover with a non-contact IC card attached.
●Do not leave portable devices inside the vehicle. The inside of the vehicle can become hot in extreme
heat, which could cause a malfunc- tion.
■If the smartphone OS has been updated
If the smartphone OS has been
updated to a newer version, its charging specifications may have changed significantly.
For details, check the information on the manufacturer’s website.
■To prevent 12-volt battery dis-charge
Do not use the wireless charger for a
long period of time when the EV sys- tem is stopped.
Armrest

453
6
Owners Manual_Europe_M42D76_en
6-4. Using the other interior features
Interior features
The coat hooks are provided with
the rear assist grips.
An assist grip installed on the ceil-
ing can be used to support your
body while sitting on the seat.
NOTICE
■To prevent damage to the arm- rest
Do not apply too much load on the armrest.
Coat hooks
WARNING
■Items that must not be hung on the hook
Do not hang coat hangers or other hard or sharp objects on the hook. If the SRS curtain shield airbags deploy,
these items may become projectiles, causing death or serious injury.
Assist grips
WARNING
■Assist grips
Do not use the assist grip when get- ting in or out of the vehicle or rising
from your seat.
NOTICE
■To prevent damage to the assist grip
Do not hang any heavy object or put a
heavy load on the assist grip.

456
Owners Manual_Europe_M42D76_en
7-1. Maintenance and care
7-1.Mainte nance a nd care
Working from top to bottom, lib-
erally apply water to the vehicle
body, wheel wells and underside
of the vehicle to remove any dirt
and dust.
 Wash the vehicle body using a
sponge or soft cloth, such as a
chamois.
 For hard-to-remove marks, use
car wash soap and rinse thor-
oughly with water.
 Wipe away any water.
 Wax the vehicle when the water-
proof coating deteriorates.
If water does not bead on a clean sur-
face, apply wax when the vehicle body
is cool.
■Self-restoring coat
The vehicle body has a self-restoring coating that is resistant to small surface scratches caused in a car wash, etc.
●The coating lasts for 5 to 8 years from when the vehicle is delivered from the
plant.
●The restoration time differs depending
on the depth of the scratch and out- side temperature. The restoration time may become shorter when the coating
is warmed by applying warm water.
●Deep scratches caused by keys,
coins, etc., cannot be restored.
●Do not use wax that contain abra- sives.
■Automatic car washes
●Before washing the vehicle:• Fold the mirrors
• Turn off the power back door (if equipped)
Start washing from the front of the vehi-
cle. Extend the mirrors before driving.
●Brushes used in automatic car washes may scratch the vehicle sur-face, parts (wheel, etc.) and harm
your vehicle’s paint.
●Rear spoiler (if equipped) may not be
washable in some automatic car washes. There may also be an increased risk of damage to vehicle.
●When the shift position needs to be held in N, refer to P.251.
■High pressure car washes
As water may enter the cabin, do not bring the nozzle tip near the gaps around the doors or perimeter of the
windows, or spray these areas continu- ously.
■Note for a smart entry & start sys-tem
●If the door handle becomes wet while the electronic key is within the effec-
tive range, the door may lock and unlock repeatedly. In that case, follow the following correction procedures to
wash the vehicle: • Place the key in a position 2 m (6 ft.) or more separate from the vehicle
while the vehicle is being washed. (Take care to ensure that the key is not stolen.)
• Set the electronic key to battery-sav- ing mode to disable the smart entry & start system ( P.204)
●If the electronic key is inside the vehi- cle and a door handle becomes wet
during a car wash, a buzzer may sound outside the vehicle and “Key Detected In Vehicle” may be shown
Cleaning and protecting
the vehicle exterior
Perform cleaning in a manner
appropriate to each compo-
nent and its material.
Cleaning instructions