2022 TOYOTA BZ4X light

546
Owners Manual_Europe_M42D76_en
8-2. Steps to take in an emergency
4Connect a positive jumper cable clamp to on your vehicle and con-
nect the clamp on the other end of the positive cable to on th e sec-
ond vehicle. Then, connect a negative cable clamp to on the se cond
vehicle and connect the clamp at the other end of the negative cable to
.
Positive (+) battery terminal (your vehicle)
Positive (+) battery terminal (second vehicle)
Negative (-) battery terminal (second vehicle)
Solid, stationary, unpainted metallic point away from the batte ry and any
moving parts as shown in the illustration
5 Start the engine of the second
vehicle. Increase the engine
speed slightly and maintain at
that level for approximately 5
minutes to recharge the 12-volt
battery of your vehicle.
6 Open and close any of the doors
of your vehicle with the power
switch OFF.
7 Maintain the engine speed of
the second vehicle and start the
EV system of your vehicle by
turning the power switch to ON.
8 Make sure the “READY” indica-
tor comes on. If the indicator
light does not come on, contact
any authorized Toyota retailer or
Toyota authorized repairer, or
any reliable repairer.
9 Once the EV system has
started, remove the jumper
cables in the exact reverse

547
8
Owners Manual_Europe_M42D76_en
8-2. Steps to take in an emergency
When trouble arises
order from which they were con-
nected.
10 Close the positive (+) battery
terminal cover.
Once the EV system starts, have
the vehicle inspected at any autho-
rized Toyota retailer or Toyota
authorized repairer, or any reliable
repairer as soon as possible.
■Starting the EV system when the 12-volt battery is discharged
The EV system cannot be started by push-starting.
■To prevent 12-volt battery dis-charge
●Turn off the headlights, the air condi-tioning system, the audio system, etc.
while the EV system is off.
●Turn off any unnecessary electrical
components when the vehicle is run- ning at a low speed for an extended period, such as in heavy traffic.
■Charging the 12-volt battery
The electricity stored in the 12-volt bat- tery will discharge gradually even when the vehicle is not in use, due to natural
discharge and the draining effects of certain electrical appliances. If the vehi-cle is left for a long time, the 12-volt bat-
tery may discharge, and the EV system may be unable to start. (The 12-volt bat-tery recharges automatically while the
EV system is operating.)
■When the 12-volt battery is removed or discharged
●Information stored in the ECU is cleared. When the 12-volt battery is depleted, have the vehicle inspected
at any authorized Toyota retailer or Toyota authorized repairer, or any reli-able repairer.
●In some cases, it may not be possible to unlock the doors using the smart
entry & start system when the 12-volt
battery is discharged. Use the wire-
less remote control or the mechanical key to lock or unlock the doors.
●The EV system may not start on the first attempt after the 12-volt battery has recharged but will start normally
after the second attempt. This is not a malfunction.
●The power switch mode is memorized by the vehicle. When the 12-volt bat-tery is reconnected, the system will
return to the mode it was in before the 12-volt battery was discharged. Before disconnecting the 12-volt bat-
tery, turn the power switch off. If you are unsure what mode the power switch was in before the 12-volt
battery discharged, be especially careful when reconnecting the 12-volt battery.
●If the 12-volt battery discharges, it may not be possible to shift the shift
position to other positions. In this case, the vehicle cannot be towed without lifting both front wheels
because the front wheels will be locked.
●The power back door (if equipped) must be initialized. ( P.198)
■When replacing the 12-volt battery
●Use a 12-volt battery that conforms to European regulations.
●Use a 12-volt battery that the case size is same as the previous one (LN1), 20 hour rate capacity (20HR) is
equivalent (45Ah) or greater, and per- formance rating (CCA) is equivalent (286A) or greater.
• If the sizes differ, the 12-volt battery cannot be properly secured.• If an improper 12-volt battery is used,
battery performance may decrease and the EV system may not be able to restart.
• If the 20 hour rate capacity is low, even if the time period where the vehi-cle is not used is a short time, the 12-
volt battery may discharge and EV system may not be able to start.

548
Owners Manual_Europe_M42D76_en
8-2. Steps to take in an emergency
For details, consult with at any autho-
rized Toyota retailer or Toyota autho- rized repairer, or any reliable repairer as soon as possible.
WARNING
■When removing the 12-volt bat-tery terminals
Always remove the negative (-) termi-
nal first. If the positive (+) terminal contacts any metal in the surrounding area when the positive (+) terminal is
removed, a spark may occur, leading to a fire in addition to electrical shocks and death or serious injury.
■Avoiding 12-volt battery fires or explosions
Observe the following precautions to prevent accidentally igniting the flam-mable gas that may be emitted from
the 12-volt battery:
●Make sure each jumper cable is connected to the correct terminal
and that it is not unintentionally in contact with any other than the intended terminal.
●Do not allow the other end of the jumper cable connected to the “+”
terminal to come into contact with any other parts or metal surfaces in the area, such as brackets or
unpainted metal.
●Do not allow the + and - clamps of
the jumper cables to come into con- tact with each other.
●Do not smoke, use matches, ciga-rette lighters or allow open flame near the 12-volt battery.
■12-volt battery precautions
The 12-volt battery contains poison- ous and corrosive acidic electrolyte,
while related parts contain lead and lead compounds. Observe the follow-ing precautions when handling the
12-volt battery:
●When working with the 12-volt bat- tery, always wear safety glasses
and take care not to allow any bat- tery fluids (acid) to come into con-tact with skin, clothing or the vehicle
body.
●Do not lean over the 12-volt battery.
●In the event that battery fluid (acid) comes into contact with the skin or
eyes, immediately wash the affected area with water and seek medical attention.
Place a wet sponge or cloth over the affected area until medical attention can be received.
●Always wash your hands after han-dling the 12-volt battery and other
battery-related parts.
●Do not allow children near the 12-
volt battery.
■When replacing the 12-volt bat-
tery
●When the vent plug is close to the hold down clamp, the battery fluid
(acid) may leak.
●For information regarding battery
replacement, contact any autho- rized Toyota retailer or Toyota authorized repairer, or any reliable
repairer.
NOTICE
■When handling jumper cables
When connecting the jumper cables,
ensure that they do not become entangled in the cooling fan.

559
9
Owners Manual_Europe_M42D76_en
9-1. Specifications
Vehicle specifications
*1: Minimum pedal clearance when depressed with a force of 300 N (31 kgf, 66 lbf)
while the EV system is operating.
*2: Make sure to confirm that the brake system warning light (yell ow) does not illumi-
nate. (If the brake system warning light illuminates, refer to P.515)
*3: Left-hand drive vehicles
*4: Right-hand drive vehicles
18-inch tires
20-inch tires
Parking brake indicator*2
When pushing the parking brake switch for 1 to
4 seconds: turns off
When pulling the parking brake switch for 1 to 4
seconds: comes on
Fluid typeSAE J1703 or FMVSS No.116 DOT 3
SAE J1704 or FMVSS No. 116 DOT 4
Steering
Free playLess than 30 mm (1.2 in.)
Tires and wheels
Tire size235/60R18 103H
Tire inflation pressure
(Recommended cold tire inflation
pressure)
Front: 260 kPa (2.6 kgf/cm2 or bar, 38 psi)
Rear: 260 kPa (2.6 kgf/cm2 or bar, 38 psi)
Wheel size18  7 1/2 J
Wheel bolt torque140 N•m (14.3 kgf•m, 103 ft•lbf)
Tire size235/50R20 104V XL
Tire inflation pressure
(Recommended cold tire inflation
pressure)
Front: 260 kPa (2.6 kgf/cm2 or bar, 38 psi)
Rear: 260 kPa (2.6 kgf/cm2 or bar, 38 psi)
Wheel size20  7 1/2 J
Wheel bolt torque140 N•m (14.3 kgf•m, 103 ft•lbf)

567
9
Owners Manual_Europe_M42D76_en
9-2. Customization
Vehicle specifications
■Reverse warning buzzer
■Power switch (P.246)
■Automatic light control system (P.259)
■Lights (P.259)
■AHS (Adaptive High-beam System)*1 (P.262)
FunctionDefault settingCustomized set-
ting
Signal (buzzer) when the shift
position is in RContinualMuteO
FunctionCustomized setting
ACC modeON/OFFOO
FunctionDefault settingCustomized set-
ting
Light sensor sensitivityStandard-2 to 2OO
Time elapsed before headlights
turn off (Extended Headlight
Lighting system)
30 seconds
60 seconds
O90 seconds
120 seconds
FunctionDefault settingCustomized set-
ting
Light reminder buzzerOnOffO
FunctionCustomized setting
Adaptive High-beam SystemOn/OffO
Brightness and illuminated area
adjustment of the high beams
according to the vehicle speed
15 km/h (9 mph)/30 km/h (19
mph)/60 km/h (37 mph)O
Intensity adjustment of the high
beams when driving around a
curve (illuminates the area in the
direction vehicle is turning more
brightly)
On/OffO

568
Owners Manual_Europe_M42D76_en
9-2. Customization
*1: If equipped
■PCS (Pre-Collision System) (P.283)
■LDA (Lane Departure Alert) (P.299)
■Dynamic radar cruise control/Speed Limiter (P.307, 318)
Projection distance adjustment of
the low beams according to the
distance to a preceding vehicle
On/OffO
High beam light distribution con-
trol for rainOn/OffO
Light distribution control for urban
areasOn/OffO
FunctionCustomized setting
Pre-Collision SystemON/OFFO
Warning timingLater/Default/EarlierO
FunctionCustomized setting
Lane Departure Alert systemON/OFFO
Alert timingDefault/EarlierO
Alert optionsVibration/BeepO
FunctionCustomized setting
Extended Resume TimeON/OFFO
Overtake preventionON/OFFO
Acceleration settingHigh/Mid/LowO
Speed setting (short press)•1 km/h/5 km/h/10 km/h*1
•1 mph/5 mph/10 mph*2O
Speed setting (long press)•1 km/h/5 km/h/10 km/h*1
•1 mph/5 mph/10 mph*2O
DRCC (RSA)ON/OFFO
Speed limit offset-5~+5O
FunctionCustomized setting

572
Owners Manual_Europe_M42D76_en
9-2. Customization
■Remote Air Conditioning System (P.427)
■Illumination (P.431)
*: If equipped
■Vehicle customization
●When the speed linked door locking function and shift position linked door locking function are both on, the door
lock operates as follows. • When shifting the shift position to any
position other than P, all the doors will be locked.• If the vehicle is started with all the
FunctionDefault settingCustomized set-
ting
Operation using the “A/C” button
on the wireless remote control
Press and
hold for 0.8
seconds
Press once
O
Press twice
Press and hold for
2.4 seconds
Off
Stopping the operation using the
“A/C” button on the wireless
remote control
Press twice
Press once
O
Press and hold for
0.8 seconds
Press and hold for
2.4 seconds
Off
FunctionDefault settingCustomized set-
ting
Time elapsed before the interior
lights turn off15 seconds
Off
OO7.5 seconds
30 seconds
Operation after the power switch
is turned offOnOffO
Operation when the doors are
unlockedOnOffO
Operation when you approach
the vehicle with the electronic
key on your person
OnOffO
Rear interior light and footwell
lights*OnOffO

577
Owners Manual_Europe_M42D76_en
What to do if... (Troubleshooting)
weak or depleted?
In this case, the EV system can
be started in a temporary way.
( P.543)
 Is the 12-volt battery dis-
charged? ( P.544)
 Is the window lock switch
pressed?
The power window except for the
one at the driver’s seat cannot
be operated if the window lock
switch is pressed. ( P.221)
 The auto power off function will
be operated if the vehicle is left
in ACC or ON (the EV system is
not operating) for a period of
time. ( P.246)
 The seat belt reminder light is
flashing
Are the driver and the passen-
gers wearing the seat belts?
( P.517)
 The parking brake indicator is on
Is the parking brake released?
( P.256)
Depending on the situation, other
types of warning buzzer may also
sound. ( P.515, 523)
 Did anyone inside the vehicle
open a door during setting the
alarm?
The sensor detects it and the
alarm sounds. ( P.77)
To stop the alarm, start the EV sys-
tem.
 Is the message displayed on the
multi-information display?
Check the message on the multi-
information display. ( P.523)
 When a warning light turns on or
a warning message is displayed,
refer to P.515, 523.
 Stop the vehicle in a safe place
and repair the flat tire temporarily
with the emergency tire puncture
The windows do not open or
close by operating the
power window switches
The power switch is turned
off automatically
A warning buzzer sounds
during driving
An alarm is activated and the
horn sounds (vehicles with
alarm)
A warning buzzer sounds
when leaving the vehicle
A warning light turns on or a
warning message is dis-
played
When a problem has
occurred
If you have a flat tire