2022 TOYOTA BZ4X CAN

143
2
Owners Manual_Europe_M42D76_en
2-2. Charging
Electric Vehicle system
If the charging schedule you wish to
change is not displayed on the
screen, scroll the list up and down
to display it.
Each time the button is pressed,
the charging schedule switches
between on and off.
■Changing the registered
charging schedules
1 Display the “Charging sched-
ule” screen. ( P. 1 4 0 )
2 Press “Edit”.
The “Scheduled Events” screen will be displayed on the screen.
3 Press “Edit” on the “Events”
screen.
4 From the items displayed on the
screen, press the charging
schedule you wish to change.
 Changing registered items:
Change the desired settings as
described in step 3 to step 4 of the
“Registering the charging schedule”
procedure. ( P.141)
When a setting is changed, its icon
on the calendar also changes.
 Deleting registered items:
Press “Delete”.
A deletion confirmation message
will be displayed.
Press “Delete” to delete the
selected charging schedule.
To cancel deletion, press “Cancel”
or the return button.
When a charging schedule is
deleted, its icon is also deleted from

144
Owners Manual_Europe_M42D76_en
2-2. Charging
the calendar.
■Turning “Charge now” on
1 Display the “Charging sched-
ule” screen. ( P. 1 4 0 )
2 Press “Charge now”.
Each time the button is pressed,
“Charge now” switches between on
and off.
After setting operations are com-
plete, charging starts when the AC
charging connector is connected.
■Changing Next Event
If the multimedia customize content
“ACC customize” is not set to OFF,
the ending screen will not be dis-
played.If it is this case, check the
settings of the multimedia.
Turn the power switch off.
Next event will be displayed according
to the charging schedule settings.
When press “OK”, close Next charging
event screen.
When press “Charge now”, charge now
is turned on.
■When all charging schedules are turned off
The icon is not displayed on the
“Charging schedule” screen.
The icon will be displayed by turning it
ON on the “Events” screen.
■When charging schedule setting operations are canceled
When the vehicle is in the following con-
ditions, charging schedule setting oper- ations are canceled.
●The power switch is turned off before the settings are confirmed
●The vehicle starts off
●A display with a higher priority than
that of the charging schedule setting is shown
NOTICE
■While performing the setting
operation
When performing the setting opera- tion while the EV system is stopped,
be careful that the 12-volt battery will not be discharged.

145
2
Owners Manual_Europe_M42D76_en
2-2. Charging
Electric Vehicle system
1Connect the charge cable to the
vehicle to start charging.
AC Charging: P.121
DC Charging: P. 1 2 9
2Turn the power switch to ON
while charging.
My Room Mode settings is automati- cally displayed on the multi-information
display.
3 Operate the meter control
switches to select “Yes”, and
then press “OK”.
My Room Mode is started and it is pos- sible to use the air conditioning system, audio system, etc.
Select “No” and press “OK” when My Room Mode is not being used.
To disable My Room Mode, turn the
power switch off.
My Room Mode will automatically be off when DC charging is completed.
When starting My Room Mode, the
electric power balance will be auto-
matically displayed on the multi-
information display, and an approxi-
mation of the electricity balance
(the balance between the amount
of electricity provided and electricity
consumed) during My Room Mode
can be checked.
Discharging (-)
Charging (+)
The size of the arrow symbol changes
depending on the power supply and
electricity consumption amounts.
If the electricity consumption is more
than the power supply, is displayed
more than .
If the power supply and electricity con-
sumption amounts are equal, and
are displayed as the same size.
■When a door is unlocked while using “My Room Mode”
The charging connector unlocks, charging stops and “My Room Mode” stops. In order to use “My Room Mode”
again, reconnect the AC charging cable and start “My Room Mode”.
When using “My Room Mode” with pub-
lic charging station, operation to start charging using the charger may be required again before starting “My Room
Using My Room Mode
When the charging cable is
connected to the vehicle, elec-
trical components such as the
air conditioning system and
audio system can be used by
the power supply from an
external power source.
Starting My Room Mode
Display information for elec-
tric power balance during
My Room Mode

146
Owners Manual_Europe_M42D76_en
2-2. Charging
Mode”.
■Meter display while charging
After turning the power switch to ON while charging, the power switch auto-matically turns off if My Room Mode is
not selected within approximately 100 seconds.
■When using My Room Mode the fol-lowing may occur
●When the remaining charge of the traction battery drops to the lower
limit, the air conditioning system auto- matically stops. In that case, the air conditioning system can not operate
until the remaining charge of the trac- tion battery increases. Turn off the power switch once, then use My
Room Mode after the remaining charge of the traction battery increases.
●If the doors are unlocked while using My Room mode, the AC charging con-
nector will be unlocked and My Room mode will be stopped. To use My Room mode again, perform the opera-
tion to start it. ( P.145) In addition, when using AC charger at the public charging station, it is necessary to
perform the operation to start the charger before using My Room mode.
●The charging time of the traction bat-tery gets longer.
●Noise may be heard from the radio depending on conditions of the radio
wave.
●The surrounding area of the onboard traction battery charger in the motor
compartment may become hot.
●The electric power steering system
warning light (yellow) may turn on, but this is not a malfunction.
■Using My Room Mode during DC charging
When using My Room mode during DC charging, the state of charge completion will be lower than when not using My
Room Mode.
■When “My Room Mode” is used while the traction battery is fully charged
When the power switch is turned on
while the traction battery is fully charged
and the charging connector that sup-
plies power is connected, “Charging
Port Lid is Open” is displayed on the
multi-information display. In this case,
press on the meter control switches
to display the setting screen of “My
Room Mode”, and then select “My
Room Mode”.
When “My Room Mode” is used while
the traction battery is fully charged, the electric power of the traction battery may be consumed. In this case,
charging may be performed again.
■Warning message display
When trying to start My Room Mode or My Room Mode is being used , if a message
is displayed on the multi-information display, refer to the cor responding table and perform the appropriate correction procedures.
MessageCorrection procedure
“Traction Battery is too Low
for “My Room Mode””
There is no remaining charge of the traction battery to
start My Room Mode. Wait until the remaining charge
of the traction battery increases, start My Room Mode.

147
2
Owners Manual_Europe_M42D76_en
2-2. Charging
Electric Vehicle system
*: During My Room Mode, the information for electric power balance can be checked
on the multi-information display.
““My Room Mode” has
stopped due to low traction
battery level”
The remaining charge of the traction battery is insuffi-
cient. Stop using My Room Mode and charge the trac-
tion battery.
““My Room Mode” will stop
when traction battery level
is too low Reduce power
usage to continue using “My
Room Mode””
When My Room mode electricity consumption
exceeds the charge amount, the traction battery
charge level becomes too low.*
• If the electricity consumption of the vehicle can not
be improved, My Room Mode will be off.
• When My Room Mode continuation is desired, turn
off the air conditioning system, audio system, etc.,
to increase the remaining charge of the traction bat-
tery.
MessageCorrection procedure
WARNING
■Warnings for using My Room
Mode
Observe the following precautions.
Failure to do so may result in death or
a serious health hazard.
●Do not leave children, people who need care, or pets inside the vehi-
cle. The temperature inside the vehicle may become high or low due to features such as the auto-
matic shut-off. The children, people who need care, or pets left inside the vehicle may suffer heatstroke
dehydration or hypothermia. Also, since the wipers, etc., can be oper-ated, there may be accidental oper-
ation, possibly leading to an accident.
●Use the mode after sufficiently checking the vicinity of the vehicle for safety hazards.

149
2
Owners Manual_Europe_M42D76_en
2-2. Charging
Electric Vehicle system
Solar roof
Solar ECU
Traction battery
Information related to the solar
charging system can be checked
on the multi-information display and
multimedia.
Meter control switches ( P.176)
Multi-information display
Multimedia
Multi-information display
1 Press or of the meter
control switches to select .
2 Press or of the meter
control switches to select solar
charging screen.
Current power generation
Mileage with power generation*
*: Mileage with power generation from
the end of the previous drive to the
current state. These values are cal-
culated by converting the power gen-
erated into driving distance, and may
differ from the actual driving distance.
When optional tires are installed, the
displayed value may differ from the
actual driving distance.
Multimedia
 Energy screen
1 Press .
2 Press “Solar charging”.
If a screen other than the desired one is displayed, select “Energy” on the
Displaying information
related to the solar charging
system

151
2
Owners Manual_Europe_M42D76_en
2-2. Charging
Electric Vehicle system
of the solar charging system operates
• There is a malfunction in the solar charging system
●The amount of power generated by the solar roof differs according to the season, climate, weather conditions,
vehicle angle and surrounding condi- tions.
●If even part of the solar roof is in the shade, there may be an extreme drop in power generation.
●Please adhere to the following in order to allow full performance of the
solar roof. • Clean the roof on a routine basis (Especially fallen leaves and bird
droppings can lead to a substantial decrease in power generation)• Remove snow from the roof as soon
as possible • Do not attach any seals or stickers to the roof
It is recommended not to install a roof carrier etc. unless it is necessary
●When the traction battery is fully charged, charging the battery via the solar charging system is not per-
formed. When it is not necessary to perform charging from an external power source, charge the vehicle as
much as possible using the solar charging system during the day and use the external power source only at
night. As a result, the solar charging system can be used effectively.
●When the vehicle is left in the hot weather, the temperature preservation function of the solar charging system
becomes easy to operate due to high temperature of the vehicle interior.
●Applying a glass coating to the solar roof may change the refractive index of light and reduce the amount of
power generated.
●Small dots, lines, and stains may be
visible inside the solar roof, however there is no problem with the power generation function or safety.
NOTICE
■To protect the solar charging system from damage
●Make sure to observe the following precautions.
• Do not modify the solar roof
• Do not condense sunlight onto the
solar roof
• Do not place anything on top of the
solar roof
• Do not subject the solar roof to
strong impacts or apply force with sharp objects from the inside roof of the vehicle.
●If the solar roof is damaged, do not touch the damaged area and imme-
diately request repairs from any authorized Toyota retailer or Toyota authorized repairer, or any reliable
repairer.
■If luggage is loaded on the roof
 P. 2 3 6

152
Owners Manual_Europe_M42D76_en
2-2. Charging
Refer to the following table and carry out the appropriate correction proce-
dure.
■The error warning indicator on the CCID (Charging Circuit Inter rupt-
ing Device) flashes
■Charging indicator of the charging port does not illuminate, ev en
though charging connector is connected.
When charging cannot be carried out
When charging does not start, even though the normal procedure is
followed, check each of the follo wing items. If a message is shown
on the multi-information disp lay, also refer to P.160.
When charging cannot be carried out
Likely causeCorrection procedure
Electrical leakage detection function or
self-diagnostic function operates and
power is cut off
When the voltage is insufficient, the error
warning indicator may flash when there
is noise interference. Perform a reset
and connect to a proper power source.
( P.102)
If charging does not start, immediately
stop charging and contact any authorized
Toyota retailer or Toyota authorized
repairer, or any reliable repairer.
Likely causeCorrection procedure
Plug is not properly connected to socketCheck that the plug is properly con-
nected to the socket.
Power is outAfter power is restored, carry out the
charging procedure again.
Remote switch is offIf the remote switch is equipped, turn the
switch on.