2022 HYUNDAI ELANTRA N transmission

05
5-41
4) Canadian Programming
Canadian radio-frequency laws require
transmitter remote signals to “time-
out” (or quit) after a couple seconds of
transmission, which may not be long
enough for HomeLink to pick up the
signal during programming.
If you live in Canada or you are having
difficulties programming a gate operator
or garage door opener by using the
programming procedures, replace
“Programming a New HomeLink Button”
step 3 with the following:
While the HomeLink indicator light (7)
is flashing orange, press and release
(“cycle”) your device’s handheld remote
every two seconds until the HomeLink
indicator light (7) changes from orange
to green. You may now release the hand-
held remote button. Then proceed with
“Programming a New HomeLink Button”
step 4.2. Operating HomeLink
®
1) Operating HomeLink®
OJX1050294NOJX1050294N
1. Press and release the desired
programmed HomeLink button (1, 2
or 3).
Information
The HomeLink indicator (7) should
light green, solid or flashing, and your
programmed device should operate.
If your device does not operate, the
HomeLink programming was not
successful, and you’ll need to reprogram
the button.
CN7 N HMA 5.indd 5-41 2021-09-06  3:06:19

Convenience Features5-58
TRUNK
Opening the trunk
1. Make sure the shift lever is in P (Park, for Dual clutch transmission) or
first gear or R (Reverse, for manual
transmission) and set the parking
brake.
OutsideOutside
OCN7N051036NOCN7N051036N
2. Then do one of the following:
• Hold down the trunk unlock button located on your smart key for more
than 1 second.
• Additionally, for vehicles equipped with smart key :
- While all doors are unlocked, press the switch in the trunk to open the
trunk with or without the smart key
in your possession.
- If any door is locked or all doors are locked, the switch can still be used
to open the trunk, as long as the
smart key is in your possession.
InsideInside
OCN7050037OCN7050037
- Use the trunk release lever.
3. Lift the trunk lid up.
Closing the trunk
Lower the trunk lid and press down
until it locks. To be sure the trunk lid is
securely fastened, always check by trying
to pull it up again.
WARNING
Always keep the trunk lid completely
closed while the vehicle is in motion. If
it is left open or ajar, poisonous exhaust
gases containing carbon monoxide
(CO) may enter the vehicle and serious
illness or death may result.
Information
To prevent damage to the trunk lift
cylinders and the attached hardware,
always close the trunk before driving.
NOTICE
In cold and wet climates, trunk lock
and trunk mechanisms may not work
properly due to freezing conditions.
CN7 N HMA 5.indd 5-58 2021-09-06  3:06:27

6
6. Driving Your Vehicle
Before Driving ........................................................................\
........................6-4Before Entering the Vehicle ........................................................................\
............. 6-4
Before Starting ........................................................................\
................................. 6-4
Engine Start/Stop Button ........................................................................\
..... 6-5
Vehicle Auto-Shut Off ........................................................................\
.......... 6-11
Operating Conditions ........................................................................\
..................... 6-11
Deactivating Conditions ........................................................................\
................ 6-11
System Operation ........................................................................\
............................ 6-11
Manual Transmission ........................................................................\
............6-12Manual Transmission Operation ........................................................................\
..... 6-12
Good Driving Practices ........................................................................\
...................6-14
Rev Matching ........................................................................\
................................... 6-15
Dual Clutch Transmission ........................................................................\
.... 6-18Dual Clutch Transmission Operation .....................................................................6-18
LCD Display for Transmission Temperature and Warning Message ................... 6-20
Parking .................................................................\
................................................... 6-26
Paddle Shifter (Manual Shift Mode) ..................................................................... 6-26
Good Driving Practices ........................................................................\
.................. 6-27
Brake System ........................................................................\
........................ 6-28Power Brakes ........................................................................\
.................................. 6-28
Disc Brakes Wear Indicator......................................................................\
.............. 6-28
High Performance Brake.......................................................................\
................. 6-29
Parking Brake ........................................................................\
.................................. 6-29
Anti-lock Brake System (ABS) ......................................................................6-31Electronic Stability Control (ESC) ........................................................................\
. 6-32
Vehicle Stability Management (VSM) ................................................................... 6-37
Hill-Start Assist Control (HAC) ........................................................................\
...... 6-38
Good Braking Practices ................................................................\
......................... 6-39
Electronic Control Suspension (ECS) ........................................................ 6-40
Electronic Limited Slip Differential ............................................................. 6-41
Warning messages ........................................................................\
......................... 6-42
N Button ........................................................................\
...............................6-43N1/N2 Button Settings ........................................................................\
................... 6-43
CN7 N HMA 6.indd 6-1 2021-09-14  9:42:13

Driving Your Vehicle6-6
Engine Stop/Start button positions
- Vehicle with manual transmission
Button
Position Action Notes
OFF T
o turn off the engine, stop the vehicle
and then press the Engine Start/Stop
button.
The steering wheel locks to protect
the vehicle from theft. If the steering wheel is not locked
properly when you open the driver's
door, the warning chime will sound.
ACC Press the Engine Start/Stop button
when the button is in the OFF position
without depressing the clutch pedal.
Some of the electrical accessories are
usable.
The steering wheel unlocks. If you leave the Engine Start/Stop
button in the ACC position for more
than one hour, the battery power will
turn off automatically to prevent the
battery from discharging.
If the steering wheel doesn't unlock
properly, the Engine Start/Stop button
will not work.
Press the Engine Start/Stop button
while turning the steering wheel right
and left to release.
ON Press the Engine Start/Stop button
while it is in the ACC position without
depressing the clutch pedal.
The warning lights can be checked
before the engine is started. Do not leave the Engine Start/Stop
button in the ON position when the
engine is not running to prevent the
battery from discharging.
START To start the engine, depress the clutch
and brake pedals and press the Engine
Start/ Stop button with the shift lever
in neutral. If you press the Engine Start/Stop
button without depressing the clutch
pedal, the engine does not start and
the Engine Start/Stop button changes
as follows:
OFF → ACC → ON → OFF or ACC
CN7 N HMA 6.indd 6-6
2021-09-14  9:42:19

06
6-7
Engine Stop/Start button positions
- Vehicle with dual clutch transmission
Button
Position Action Notes
OFF T
o turn off the engine, press the
Engine Start/Stop with shift lever is in
P (Park). The steering wheel locks to
protect the vehicle from theft. If the steering wheel is not locked
properly when you open the driver’s
door, the warning chime will sound.
ACC Press the Engine Start/Stop button
when the button is in the OFF position
without depressing the brake pedal.
Some electrical accessories are
usable.
The steering wheel unlocks. If you leave the Engine Start/Stop
button in the ACC position for more
than one hour, the battery power will
turn off automatically to prevent the
battery from discharging.
If the steering wheel doesn’t unlock
properly, the Engine Start/Stop button
will not work. Press the Engine Start/
Stop button while turning the steering
wheel right and left to release tension.
ON Press the Engine Start/Stop button
while it is in the ACC position without
depressing the brake pedal.
The warning lights can be checked
before the engine is started. Do not leave the Engine Start/Stop
button in the ON position when the
engine is not running to prevent the
battery from discharging.
START To start the engine, depress the brake
pedal and press the Engine Start/Stop
button with the shift lever in the P
(Park) or in the N (Neutral) position.
For your safety, start the engine with
the shift lever in the P (Park) position. If you press the Engine Start/Stop
button without depressing the brake
pedal, the engine does not start and
the Engine Start/Stop button changes
as follows:
OFF → ACC → ON → OFF or ACC
CN7 N HMA 6.indd 6-7
2021-09-14  9:42:19

Driving Your Vehicle6-8
Starting the engine
WARNING
• Always wear appropriate shoes when
operating your vehicle.
Unsuitable shoes, such as high heels,
ski boots, sandals, flip-flops, etc.,
may interfere with your ability to use
the brake and accelerator pedals.
• Do not start the vehicle with the
accelerator pedal depressed. The
vehicle can move and lead to an
accident.
• Wait until the engine rpm is normal.
The vehicle may suddenly move if
the brake pedal is released when the
rpm is high.
Information
• The engine will start by pressing the
Engine Start/Stop button, only when
the smart key is in the vehicle.
• Even if the smart key is in the vehicle,
if it is far away from the driver, the
engine may not start.
• When the Engine Start/Stop button
is in the ACC or ON position, if any
door is open, the system checks for the
smart key. If the smart key is not in the
vehicle, the “
” indicator will blink
and the warning "Key not in vehicle"
will come on and if all doors are closed,
the chime will also sound for about
5 seconds. Keep the smart key in the
vehicle when using the ACC position or
if the vehicle engine is ON. Vehicle with manual transmission:
1. Always carry the smart key with you.
2. Make sure the parking brake is
applied.
3. Make sure the shift lever is in neutral.
4. Depress the clutch and brake pedals.
5. Press the Engine Start/Stop button.
Information
Depress the brake pedal and clutch pedal
until the engine starts.
Vehicle with dual clutch transmission:
1. Always carry the smart key with you.
2. Make sure the parking brake is applied.
3. Make sure the shift lever is in P (Park).
4. Depress the brake pedal.
5. Press the Engine Start/Stop button.
Information
• Do not wait for the engine to warm up
while the vehicle remains stationary.
Start driving at moderate engine
speeds. (Aggressive accelerating and
decelerating should be avoided.)
• Always start the vehicle with your foot
on the brake pedal. Do not depress the
accelerator while starting the vehicle.
Do not rev the engine while warming
it up.
CN7 N HMA 6.indd 6-8 2021-09-14  9:42:19

06
6-9
NOTICE
To prevent damage to the vehicle:
• If the engine stalls while you are in
motion, do not attempt to move the
shift lever to the P (Park) position.
If traffic and road conditions permit,
you may put the shift lever in the N
(Neutral) position while the vehicle
is still moving and press the Engine
Start/Stop button in an attempt to
restart the engine.
• Do not push or tow your vehicle to
start the engine.
NOTICE
To prevent damage to the vehicle:
When the stop lamp switch fuse is
blown, you can't start the engine
normally. Replace the fuse with a new
one. If you are not able to replace
the fuse, you can start the engine by
pressing and holding the Engine Start/
Stop button for 10 seconds with the
Engine Start/Stop button in the ACC
position.
Do not press the Engine Start/Stop
button for more than 10 seconds except
when the stop lamp switch fuse is
blown.
For your safety always depress the
brake pedal before starting the engine.
OCN7N061250NOCN7N061250N
Information
If the smart key battery is weak or the
smart key does not work correctly, you
can start the engine by pressing the Engine
Start/Stop button with the smart key in
the direction of the picture above.
Turning off the engine
Vehicle with manual transmission:
1. Stop the vehicle and depress the
clut
ch and brake pedals at the same
time.
2. With the clutch and brake pedals depressed, put the shift lever in
neutral.
3. Press the Engine Start/Stop button to the off position and apply the parking
brake.
Vehicle with Dual clutch transmission:
1. Stop the vehicle and depress the br
ake pedal fully.
2. Make sure the gear is in P(Park).
3. Press the Engine Start/Stop button to the OFF position and apply the
parking brake.
CN7 N HMA 6.indd 6-9 2021-09-14  9:42:19

6-12
Driving Your Vehicle
OCN7N060001OCN7N060001
The shift lever can be moved without
pressing the button (1).
The button (1) must be pressed while
moving the shift lever.
Manual Transmission Operation
The manual transmission has 6
forward gears. The transmission is fully
synchronized in all forward gears so
shifting to either a higher or a lower gear
is easily accomplished.
WARNING
•
Before leaving the driver’s seat,
always make sure the shift lever is in
1st gear when the vehicle is parked
on a uphill and in R (Reverse) on a
downhill, set the parking brake, and
place the Engine Start/Stop button
in the OFF position. Unexpected
vehicle movement may occur if these
precautions are not followed.
• When parking on an incline, block
the wheels to prevent the vehicle
from rolling down.
To shift to R (Reverse), make sure the
vehicle has completely stopped, and
then move the shift lever to neutral
before moving into R (Reverse).
When you've come to a complete stop
and it's hard to shift into 1st gear or R
(Reverse):
1. Put the shift lever in neutral and release the clutch pedal.
2. Depress the clutch pedal, and then shift into first or R (Reverse) gear.
Information
During cold weather, shifting may be
difficult until the transmission lubricant
has warmed up.
MANUAL TRANSMISSION (IF EQUIPPED)
CN7 N HMA 6.indd 6-12 2021-09-14  9:42:20