2020 SUZUKI JIMNY Owners Manual

Specific conditions for installation
NOTE:
1) Antenna cable is routed as far as possible from the vehicle electronic devices and wiring harness in the vehicle. 2) Power cable of transmitter is properly connected to lead-acid battery on the vehicle.
NOTICE
Before using your vehicle, check if there is no interference to all electrical devices on your vehicle for both Standby mode and Transmitting mode of the RF transmitting equipment.

PANTOGRAPH JACK
INSTRUCTION MANUAL
CE
Manufacturers:
RIKENKAKI CO., LTD. 5-6-12 Chiyoda, Sakado-shl, Saitama, 350-0214 Japan Tel: 049-248-1661 Fax:049-284-4340
CHANGZHOU RIKENSEIKO MACHINERY CO., LTD. No.5 Xinlin Road. Zhonglou Changzho1.1, JiangsLJ CHINA Te!: 0519-327-5284 Fax:0519-327-0811
Please read this INSTRUCTION MANUAL before operation!
Norm: EN 1494:2000+A1:2008
Attention and warning -The JACK may be used only for replacing tyres, not for any other purpose. -Use the JACK no more than 50 times. -No-loadlng person. • Never get under vehicle raised by Jack. -Use of defective or Inadequately ma!ntalned jacks Is extremely dangerous.
Meaning of pictogram on caution label
Parts name of Pantograph Jack
FJG1
Technical Data and Application
'
This symbol Indicates a potential hazard that could result In death or serious Injury.
This symbol Indicates you never get under the vehicle when it Is supported by the Jack.
A ; TOPHOLDER B : BASE C: UPPER ARM D :LOWER ARM E : HANDLE JOINT F :JACKSCREW G : NOMINAL LOAD (t)
lL. H, H3 H,
H1: MINIMUM HEIGHT(mm) H2; MAXIMUM HEIGHT (mm) HJ: PERFORMANCE ASSURANCE HEIGHT (mm) X : JACK HEIGHT (mm) Y: LOAD(t) M: MODEL T :TYPE
M T G H, H, H, 55L Suzuki Tupe-I 0.95 89 327 208 72K Suzuki Tvoe-II 0.95 70 281 175.5 54L Suzuki Type-III 0.95 80 318 199 81A Suzuki Type-IV 1.0 85.5 344 214.75 77K Suzuki Type-V 1.25 100.8 436.3 268.55
FIG2

No.Using Conditions • When temperature under -40-C . • On miring or sand ground . • On big gradient road . • In extreme nature condition: rainstorm, typhoon, cyclone, snowstorm, thunder•storm. etc . • Loading dangerous heavy, for instance: melted metal. acidity substance, radioactivity substance or specially crisp goods • • Contact with hood directly . • Using on boat. • The ground with difference in level.
Operation Instructions Whenever a wheel is changed, always remove any corrosion that may be present on inside of wheel and wheel mounting surface on vehicle. Details: Please operate according to the "operation instructions", Operate the jack on the level ground while checking the jack and the load. Musln"I operate under raising load, unless the load is fastened surely . • Park the car on the nat, love ground and apply the brake firmly. • Set transmission in "reverse"(automalic transmission in ·park") . • Turn on the hazard warning Hasher . • Remove jacklng tools and spare tire from stowage area . • Block fFont and rear of wheel diagonally opposlte wheel being removed before operating jack .
~
ITT
~ .s,.Cl(Jf>Of'(llITT J-'CKIW ~ • Loosen, but do not remove wheel nuts by turning wrench counter clockwise • • Raise jack until Jack-head groove fits boss or frame see Illustrations . • Operate jack with slow, smooth motion, using Jack handle . • Raise vehicle so an innated lire will just clear surface, remove nuts and wheel. • Install wheel, then slightly tighten each nut, wheel must be seated on hub . • lower vehicle, and fully tighten wheel nuts In across-cross sequence by turning wrench clockwise.
Maintenance • Please prevent the JACK SCREW from accretion of dirt . • Check the nameplate, keep the shape same as original. • No-re jigger the Jack's construction privately . • After any use, consult immediately your Suzuki Dealer or Service Partner for inspection and maintenance of the jack . • If the label (slicker) is damaged, pt ease consult your Suzuki Dealer or Service Partner.

BATTERY LABEL SYMBOL MEANINGS
® No smoking, no naked flames, no sparks
A Battery acid
•
Shield eyes
•
Note operating instructions
® Keep away from children
A Explosive gas
Prepared by
SUZUKI MOTOR CORPORATION
June,2019
Part No. 99011-78RB5-01 E
Printed in Japan
TP516

SERVICE STATION INFORMATION
Fuel recommendation:
See page 9-2
For EU countries and Israel:
Classification: ACEAA1/B1, A3/B3, A3/B4, A5/B5
API SL, SM, SN
ILSAC GF-3, GF-4, GF-5
Viscosity: SAE 0W-16, 0W-20, 5W-30
Except for EU countries and Israel:
Classification: SG, SH, SJ, SL, SM, or SN
Viscosity: SAE 0W-20, 5W-30, 1 0W-30, 1 0W-40, 1 SW-40,
20W-40
For further details, see "Engine Oil and Filter" in the
"INSPECTION AND MAINTENANCE" section.
$SUZUKI
Brake fluid:
DOT3 or SAE J1703
Automatic transmission fluid:
SUZUKI ATF3317 or Mobil ATF3309 or equivalent to
DEXRON® -Ill.
Tire cold pressure:
See the "Tire Information Label" located on the
driver's door lock pillar.
llllllllllllllllllllllllllllllllllllllllllllllllllllllllllllllllllllllllllllllllllllllllll 99011-78RB5-01 E
SUZUKI MOTOR CORPORATION Part No. 99011-78RB5-01E June, 2019 Printed in Japan