2019 MERCEDES-BENZ S-CLASS CABRIOLET warning

#
Allow the engine tocool down and only
to uch co mponent parts described in the
fo llowing. &
WARNING Risk of inju ryfrom using the
windshield wipers while the engine hood
is open
When the engine hood is open and the wind‐
shield wipers are set in motion, you can be
trapped bythe wiper linkage. #
Alw ays switch off the windshield wipers
and ignition before opening the engine
hood. #
Toopen: pull lever1 torelease the hood. #
Push handle 1ofthe hood catch upwards
and lift the hood byappr oximately 15in
(40 cm). #
Toclose: lowe rth e hood and let it fall from a
height of appr oximately 8 in (20 cm). #
Ifth e hood can still be lif ted slightl y,open
th e hood again and close it with a little more
fo rc e until it engages cor rectl y. Maintenance and care
339

Engine oil
Checking
the engine oil le vel with an on-
board computer
Re quirements:
The engine oil le vel is de term ined during driving.
De term ining the engine oil le vel can take up to
30 minutes with a normal driving style and even
longer with an active driving style.
In order torecei veare sult as quickly as possi‐
ble:
R Warm upthe engine.
R Park theve hicle on a le vel sur face.
R Lea vethe engine running at idle speed.
On-board compu ter:
, Service .
Engine Oil Level
Yo u will see one of thefo llowing messa ges in
th e multifunction displa y:#
Measuring Engine Oil Level...: measurement
of the oil le vel is not yet possible. Repeat the
requ est af ter a maximum of 30 minutes' driv‐
ing. #
Engine Oil Level OK andthe bar display for
indicating the oil le vel in the multifunction
display is green and is between "min" and
"max": the oil le vel is cor rect. #
Engine Oil Level Add 1.0 l andthe bar display
fo r indicating the oil le vel in the multifunction
display is orange and is below "min": add
1. 1 US qt (1 liter) of engine oil. #
Reduce Engine Oil Level andthe bar display
fo r indicating the oil le vel in the multifunction
display is orange and is abo ve"max": drain
off theex cess engine oil. Consult a qualified
specialist workshop. #
For Engine Oil Level Switch Ignition On:
switch on the ignition tocheck the engine oil
le ve l. #
Engine Oil Level System Inoperative: sensor
defective or not inse rted. Consult a qualified
specialist workshop. #
Engine Oil Level System Currently Unavail.:
close the hood. Ad
ding engine oil &
WARNING Risk of bu rns from hot com‐
ponent parts in the engine compartment
Cer tain components in the engine compart‐
ment can be very hot, e.g. the engine, the
ra diator and parts of theex haust sy stem. #
Allow the engine tocool down and only
to uch co mponent parts described in the
fo llowing. &
WARNING Risk offire and injury from
engine oil
If engine oil comes into con tact wi thhot
component parts in the engine compart‐
ment, it may ignite. #
Make sure that no engine oil is spilled
next tothefiller opening. #
Allow the engine tocool off and thor‐
oughly clean the engine oil from compo‐
nent parts before starting theve hicle. 340
Maintenance and care

*
NO
TEEngine dama gecaused byan
incor rect oil filter, incor rect oil or addi‐
tives #
Do not use engine oils or oil filters
which do not cor respond tothe specifi‐
cations explicitly prescribed forthe
service inter vals. #
Do not alter the engine oil or oil filter in
order toachie velonger change inter vals
th an presc ribed. #
Do not use additives. #
Follow the instructions in the service
inter val display rega rding the oil
ch ange. *
NO
TEDama gecaused byadding too
much engine oil To
o much engine oil can damage the engine
or the catalytic con verter. #
Have excess engine oil remo ved at a
qu alified specialist workshop. #
Turn cap 1counter-clockwise and remo ve
it. #
Add engine oil. #
Replace cap 1and turn it clockwise as far
as it will go. #
Check the oil le vel again . Checking coolant le
vel &
WARNING Risk of bu rns from hot com‐
ponent parts in the engine compartment
Cer tain components in the engine compart‐
ment can be very hot, e.g. the engine, the
ra diator and parts of theex haust sy stem. #
Allow the engine tocool down and only
to uch co mponent parts described in the
fo llowing. &
WARNING Risk of scalding from hot
coolant
The engine cooling sy stem is pressurized,
particularly when the engine is warm. If you
open the cap, you could be scalded byhot
coolant spr aying out. #
Let the engine cool down before open‐
ing the cap. #
When opening the cap, wear pr otective
gl ove s and saf etygl asses. #
Open the cap slowly torelease pres‐
sure. Maintenance and care
341

#
Park theve hicle on a le vel sur face. #
Check the coolant temp erature display in the
instrument clus ter.
The coolant temp erature must be below
15 8 °F (70 °C). #
If necessa ry,re mo vethe co ver. #
Slowly turn cap 1counter-clockwise to
re lie ve ove rpressure. #
Continue turning cap 1counter-clockwise
and remo veit.
The coolant le vel is cor rect:
R Ifth e engine is cold, up tomar ker bar 2.
R Ifth e engine is warm, up to0.6 in (1.5 cm)
ov er mar ker bar 2. #
If necessar y,add coolant that has been
appr ovedby Mercedes-Benz.
R Further information on coolant:
(→ page 414) Ad
ding washer fluid tothe windshield
wa sher sy stem &
WARNING Risk of bu rns from hot com‐
ponent parts in the engine compartment
Cer tain component parts in the engine com‐
partment can be very hot, e.g. the engine,
th e cooler and parts of theex haust sy stem. #
Let the engine cool down and only
to uch the component parts described
as follo ws. &
WARNING Danger of bu rns when open‐
ing the hood
If yo u open the hood when the engine has
ove rheated or during a fire inthe engine
compartment, you could come into contact
with hot gases or other escaping operating
fl uids. #
Before opening the hood, allow the
engine tocool down. #
Intheeve nt of a fire inthe engine com‐
partment, keep the hood closed and
call thefire service. &
WARNING ‑ Risk of fire and injury from
windshield washer concentrate
Wi ndshield washer concentrate is highly
fl ammable. It could ignite if it comes into
con tact wi thhot engine component parts or
th eex haust sy stem. #
Make sure that no windshield washer
concentrate spills out next tothefiller
opening. 342
Maintenance and care

#
Remo vecap 1bytheta b, place on the edge
of thefiller opening and engage in place. #
Addwa sher fluid. Ke
eping the air-water duct free #
Keep the area between the hood and the
windshield free of deposits, e.g. ice, sn ow
and lea ves. Cleaning and care
Note
s onwashing theve hicle in a car wash &
WARNING Risk of accident due to
re duced braking ef fect af terwa shing the
ve hicle
The braking ef fect is reduced af terwa shing
th eve hicle. #
Afterth eve hicle has been washed,
brake carefully while paying attention to
th e traf fic conditions until the braking
ef fect has been ful lyrestored. *
NO
TEDama gedue tounsuitable car
wa sh #
Before driving into a car wash make
sure that the car wash is suitable for
th eve hicle dimensions. #
Ensure there is suf ficient ground clear‐
ance between the underbody and the
guide rails of the car wash. #
Ensure that the clearance width of the
car wash, in particular the width of the
guide rails, is suf ficient. To
avo id damage to yourvehicle when using a
car wash, ensure thefo llowing beforehand:
R toavoid possible water ingress in theve hicle,
it is preferable touse car washes which allow
th e high-pressure pre-cleaning tobe deacti‐
va ted (specification forth e con vertible pro‐
gram).
R it is imperative toavo id a subsequent hot-
wa x treatment.
R remo vethe SmartK eyin order toensure that
th e wind deflector on the windshield retracts.
R Active Dis tance Assi stDISTRONIC and the
HOLD function are deactivated.
R the 360° Camera or there ar view camera is
swit ched off.
R the side windo wsand soft top are closed
comple tely.
R the blo werfo rth eve ntilation/heating is
switched off. Maintenance and care
343

R
the windshield wiper switch is in position 005A.
R the SmartK eyis at a minimum dis tance of
10 ft(3 m) away from theve hicle, otherwise
th e trunk lid could open unintentionally.
R in car washes with a con veyo r sy stem: neu‐
tral 005Cis engaged.
% In car washes with a con veyo r sy stem: if you
wo uld like tolea vetheve hicle while it is
being washed, make sure the SmartK eyis
located in theve hicle. The 005Dgear is other‐
wise automatically engaged.
% If, af terth e car wash, youre mo vethewax
from the windshield and wiper rubbers, this
will pr event smearing and reduce wiper
noise. Information on using a po
werwa sher &
WARNING Risk of accident when using
high-pressure cleaning equipment wi th
ro und-spr aynozzles
The wate r jet from a round-spr aynozzle (dirt
grinder) may cause dama getotires and sus‐
pension components that is not visible.
Components damaged in this wa y may fail
unexpec tedly. #
Do not use high-pressure cleaning
equipment wi thround-spr aynozzles to
clean your vehicle. #
Damaged tires or suspension compo‐
nents must be replaced immediatel y. To
avo id damage to yourvehicle, obser vethefo l‐
lowing when using a po werwa sher:
R keep the SmartK eyat least 10ft(3 m) away
from theve hicle. Otherwise the trunk lid
could open unintentionall y.
R maintain a dis tance of at least 11.8 in
(30 cm) totheve hicle. R
vehicles with deco rative foil: parts of your
ve hicle are co vered with a decorative foil.
Maintain a dis tance of at least 27.6 in
(70 cm) between thefo il-c ove red parts of the
ve hicle and the nozzle of the po werwa sher.
Mo vethe po werwa sher nozzle around whilst
cleaning. The waterte mp erature of the
po we rwa sher must not exceed 140 °F
(60 °C).
R obse rveth e information on the cor rect dis‐
tan ce in the equipment manufacturer's oper‐
ating instructions.
R do not point the nozzle of the po werwa sher
directly at sensitive parts such as tires, the
soft top, the wind deflector net, slits, electri‐
cal component parts, batteries, light sources
and ventilation sl ots. Wa
shing theve hicle byhand Obser
vethe legal requ irements, e.g. in a number
of countries, washing byhand is only permitted
in specially designated wash ba ys. #
Use a mild cleaning agent, e.g. car shampoo. 344
Maintenance and care

#
Clean wind sc reen net 1with a damp clo th
in conjunction with the care products and
cleaning agents recommended and appr oved
fo r Mercedes-Benz. Cleaning
thefo lding wind screen Re
quirements:
R Never use a po werwa sher toclean the net of
th e wind deflector. R
Obser vethe no tes on the cor rect ins tallation
and stow ing location of thefo lding wind
screen (→ page 80). #
Clean the net of thefo lding wind screen with
a damp clo thin conjunction with the care
products and cleaning agents recommended
and appr ovedby Mercedes-Benz. Note
s on care of vehicle parts &
WARNING Risk of entrapment if the
windshield wipers are swit ched on while
th e windshield is being cleaned
If th e windshield wipers are set in motion
while you are cleaning the windshield or
wiper blades, you can be trapped bythe
wiper arm. #
Alw ays switch off the windshield wipers
and the ignition before cleaning the
windshield or wiper blades. &
WARNING Risk of bu rning from theta il‐
pipe or tailpipe trim
The tailpipe and tailpipe trim can become
ve ry hot. If you come into contact with these
car parts, you could burn yourself. #
Alw ays be particular lycareful when in
th e vicinity of theta ilpipe and tailpipe
trims and supervise children very
closely when in this area. #
Before any con tact, allow the car parts
to cool down. 352
Maintenance and care

Note
s on care of the interior &
WARNING Risk of inju ryfrom pla stic
parts breaking off af terth e use of sol‐
ve nt-based care products
Ca reand cleaning products con taining sol‐
ve nts can cause su rfaces in the cockpit to
become porous. When
the airbags are deplo yed, plastic parts
may break away. #
Do not use any care or cleaning prod‐
ucts containing sol vents toclean the
cockpit. &
WARNING Risk of inju ryor death from
bleached seat belts
Bleaching or dyeing seat belts can se verely
we aken them.
This can, forex ample, cause seat belts to
te ar or fail in an accident. #
Never blea chor dye seat belts. Obser
vethefo llowing information: Cleaning and car
eA voiding vehicle damage
Seat belts Clean with lukewarmand soapy water. R
Do not use chemical cleaning agents.
R Do not dry seat belts byheating them toove r17 6 °F
(80 °C) or exposing them todirect sunlight.
Display Cleanthe sur face carefully wi tha mic rofiber clo thand a suit‐
able display care product (TFT/LCD). R
Swit choff the display and let it cool down.
R Do not use any other cleaning products.
Plastic trim R
Clean with a damp microfiber clo th.
R For heavy soiling: use care product recommended for
Mercedes-Benz. R
Do not attach sticke rs,fi lms or similar materials.
R Do not allow cosmetics, insect repellent or sun cream to
come in contact wi th the plastic trim. 354
Maintenance and care