Po
sition of jack support points Co
ver of jack support points
Before positioning the jac k,you must remo ve
th e co vers forth e jack support points. #
Toremo ve:turn clip 1onthe co ver one
qu arter-turn and remo ve. #
Pull the co ver down wards using handle 2
until the co verre leases at theto p of the lon‐
gitudinal member panel. #
Remo vethe co ver. Co
ver of jack support points #
Tofit: inse rttabs 3 ofthe co ver into the
re cesses of the longitudinal member panel
and press the co vers closed. 504
Wheels and tyres
#
Insert clip 1into the co ver,as shown in the
illustration, until you hear it en gage inthe
fl oor bush.
Make sure that thefloor bush in theve hicle
is cor rectly aligned tothe co ver. &
WARNING Risk of inju ryfrom incor rect
positioning of the jack
If yo u do not position the jack cor rectly at
th e appropriate jacking point of theve hicle,
th e jack could tip with theve hicle raised. #
Only position the jack at the appropri‐
ate jacking point of theve hicle. The
base of the jack must be positioned ve
rtically under the jacking point of the
ve hicle. *
NO
TEVehicle damage from the jack If
yo u do not position the jack cor rectly at
th e appropriate jack support point of the
ve hicle, the jack could tip over with theve hi‐
cle raised. #
The jack is designed exclusively for
jacking up theve hicle at the jack sup‐
port points. #
Take thera tchet out of the tyre-change tool
kit and place it on the he xagon nut of the
jack so that the letters "AUF" are visible. #
Position jack 5at jack support point 4. #
Turn ratchet 6clockwise until jack 5sits
comple tely on jack support point 4and the
base of the jack lies evenly on the ground. #
Turn ratchet 6until the tyre is raised a max‐
imum of 3 cm from the ground. #
Loosen and remo vethe wheel (/ page 506). Wheels and tyres
505
