2019 MAZDA MODEL CX-30 warning

Removable Ashtray*
▼Removable Ashtray
The removable ashtray can be fixed
and used in either of the front cup
holders.
WARNING
Only use the removable ashtray in its
fixed position, and make sure it is
completely inserted:
Using an ashtray removed from its
fixed
position or not completely inserted is
dangerous. Cigarettes could roll
around or spill out of the ashtray into
the vehicle and start a fire. Moreover,
cigarette stubs will not extinguish
themselves completely even if the
ashtray lid is closed.
CAUTION
Do not use the ashtray for rubbish. You
might start a
fire.
To use the ashtray, insert it straight into
the cup holder.
To remove the ashtray, pull it upward.

Interior Features
Interior Equipment
5-42*Some models.

Owner Maintenance
Precautions
▼Owner Maintenance Precautions
Routine Service
We highly recommend that these items
be inspected daily, or at least every
week.
xEngine Oil Level (page 6-27)xEngine Coolant Level (page 6-28)xBrake and clutch Fluid Level (page
6-30)
xWasher Fluid Level (page 6-31)xBattery Maintenance (page 6-37)xTy re
Inflation Pressure (page 6-41)

Improper or incomplete service may
result in problems. This section gives
instructions only for items that are easy
to perform.

As explained in the Introduction (page
6-2), several procedures can be done
only by a
qualified service technician
with special tools.

Improper do-it yourself maintenance
during the warranty period may affect
warranty coverage. For details, read the
separate Mazda Warranty statement
provided with the vehicle. If you are
unsure about any servicing or
maintenance procedure, have it done
by an expert repairer (we recommend
an Authorised Mazda Repairer).

There are strict environmental laws
regarding the disposal of waste oil and
fluids. Please dispose of your waste
properly and with due regard to the
environment.

We recommend that you entrust the oil
and fluid changes of your vehicle to an
expert repairer (we recommend an
Authorised Mazda Repairer).
WARNING
Do not perform maintenance work if
you lack sufficient knowledge and
experience or the proper tools and
equipment to do the work. Have
maintenance work done by a
qualified technician:
Performing maintenance work on a
vehicle is dangerous if not done
properly. You can be seriously injured
while performing some maintenance
procedures.
If you must run the engine while
working under the bonnet, make
certain that you remove all jewellery
(especially rings, bracelets, watches,
and necklaces) and all neckties,
scarves, and similar loose clothing
before getting near the engine or
cooling fan which may turn on
unexpectedly:
Working under the bonnet with the
engine running is dangerous. It
becomes even more dangerous when
you wear jewellery, loose clothing or
have long hair or a long beard.
Either can become entangled in
moving parts and result in injury.
Maintenance and Care
Owner Maintenance
6-16

Pull over to a safe location, then
switch the ignition off and make sure
the fan is not running before
attempting to work near the cooling
fan:
Working near the cooling fan when it is
running is dangerous. The fan could
continue running indefinitely even if
the engine has stopped and the engine
compartment temperature is high. You
could be hit by the fan and seriously
injured.
Do not leave items in the engine
compartment:
After you have finished checking or
doing servicing in the engine
compartment, do not forget and leave
items such as tools or rags in the
engine compartment.
Tools or other items left in the engine
compartment could cause engine
damage or a fire leading to an
unexpected accident.
Bonnet
▼Bonnet
WARNING
Always check that the bonnet is
closed and securely locked:
A bonnet that is not closed and
securely locked is dangerous as it could
fly open while the vehicle is moving
and block the driver's vision which
could result in a serious accident.
▼Opening the Bonnet
1. With the vehicle parked, pull the
release handle to unlock the
bonnet.

2. Insert your hand into the bonnet
opening , slide the latch lever to the
left, and lift up the bonnet.


3. Grasp the support rod in the
padded area and secure it in the
Maintenance and Care
Owner Maintenance
6-17

xWhenever the engine oil is replaced, the vehicles engine control unit needs to be
reset as soon as possible. Otherwise the wrench indicator light or engine oil
warning light may turn on. To reset the engine control unit, consult an expert
repairer (we recommend an Authorised Mazda Repairer) or refer to the vehicle
status monitor section in the Mazda Connect Owner's Manual.
▼Inspecting Engine Oil Level
NOTE
xIf the engine oil level warning
indication/warning light turns on,
add 1 L (0.3 US gal, 0.2 Imp gal) of
engine oil.
x(SKYACTIV-D 1.8)
If “Excessive Oil Level. Have the
Vehicle Inspected” is displayed on
the multi-information display in the
instrument cluster, have your vehicle
inspected at an expert repairer (we
recommend an Authorised Mazda
Repairer).
1. Be sure the vehicle is on a level
surface.
2. Warm up the engine to normal
operating temperature.
3. Turn it off and wait at least 5
minutes for the oil to return to the
sump.
4.(SKYACTIV-X 2.0)
Open the engine cover (page
6-19).
5. Pull out the dipstick, wipe it clean,
and reinsert it fully.
SKYACTIV-G 2.0 and SKYACTIV-G
2.5

1. MAX
2. OK
3. MIN

SKYACTIV-X 2.0

1. MAX
2. OK
Maintenance and Care
Owner Maintenance
6-27

3. MIN

SKYACTIV-D 1.8

1. X Mark
2. MAX
3. OK
4. MIN

NOTE
(SKYACTIV-D 1.8)
When inspecting the engine oil
level, pull out the dipstick straight
without twisting. In addition, when
inserting the dipstick, always insert
it without twisting so that the “X”
mark faces the front of the vehicle.
6. Pull it out again and examine the
level.
The level is normal if it is between
the MIN and MAX marks.
If it is near or below MIN, add
enough oil to bring the level to
MAX.
CAUTION
Do not overfill the engine oil. This
may cause engine damage.
7. Make sure the O-ring on the
dipstick is positioned properly
before reinserting the dipstick.
8. Reinsert the dipstick fully.
Engine Coolant
▼Inspecting Coolant Level
WARNING
Do not use a match or live flame in
the engine compartment. DO NOT
ADD COOLANT WHEN THE ENGINE
IS HOT:
A hot engine is dangerous. If the
engine has been running, parts of the
engine compartment can become very
hot. You could be burned. Carefully
inspect the engine coolant in the
coolant reservoir, but do not open it.
Pull over to a safe location, then
switch the ignition off and make sure
the fan is not running before
attempting to work near the cooling
fan:
Working near the cooling fan when it is
running is dangerous. The fan could
continue running indefinitely even if
the engine has stopped and the engine
compartment temperature is high. You
could be hit by the fan and seriously
injured.
Do not remove either
cooling system cap when the engine
and radiator are hot:
When the engine and radiator are hot,
scalding coolant and steam may shoot
out under pressure and cause serious
injury.
Maintenance and Care
Owner Maintenance
6-28

Brake/Clutch Fluid
▼Inspecting Brake/Clutch Fluid
Level
WARNING
If the brake/clutch fluid level is low,
have the brakes inspected:
A low brake/clutch fluid level is
dangerous.
A low level could indicate brake lining
wear or a brake system leak which
could cause the brakes to fail and lead
to an accident.
The brakes and clutch draw fluid from
the same reservoir.
Inspect the fluid level in the reservoir
regularly. It should be kept between
the MAX and MIN lines.
The level normally drops with
accumulated distance, a condition
associated with wear of brake and
clutch linings. If it is excessively low,
have the brake/clutch system
inspected by an expert repairer (we
recommend an Authorised Mazda
Repairer).
Left-hand drive model
Without M Hybrid
With M Hybrid
Right-hand drive model
Without M Hybrid
With M Hybrid
Maintenance and Care
Owner Maintenance
6-30

Window and Headlight
Washer Fluid
▼Inspecting Washer Fluid Level
WARNING
Use only windscreen washer fluid or
plain water in the reservoir:
Using radiator antifreeze as washer
fluid is dangerous. If sprayed on the
windscreen, it will dirty the
windscreen, affect your visibility, and
could result in an accident.
Inspect fluid level in the washer fluid
reservoir; add fluid if necessary.

The top of the float should be between
F and E.

Use plain water if washer
fluid is
unavailable.
But use only washer fluid in cold
weather to prevent it from freezing.
NOTE
Front and rear washer
fluid is supplied
from the same reservoir.
Body Lubrication
▼Body Lubrication
All moving points of the body, such as
door and bonnet hinges and locks,
should be lubricated each time the
engine oil is changed. Use a
nonfreezing lubricant on locks during
cold weather.

Make sure the bonnet's secondary
latch keeps the bonnet from opening
when the primary latch is released.
Maintenance and Care
Owner Maintenance
6-31

Then install the blade assembly in
the reverse order of removal.
Battery
▼Battery
WARNING
Read the following precautions
carefully before using the battery or
inspecting to ensure safe and correct
handling:
Always wear eye protection
when working near the battery:
Working without eye protection is
dangerous. Battery fluid contains
SULPHURIC ACID which could cause
blindness if splashed into your eyes.
Also, hydrogen gas produced during
normal battery operation, could ignite
and cause the battery to explode.
Wear eye protection and
protective gloves to prevent contact
with battery
fluid:
Spilled battery fluid is dangerous.
Battery
fluid contains SULPHURIC
ACID which could cause serious
injuries if it gets in eyes, or on the skin
or clothing. If this happens,
immediately flush your eyes with water
for 15 minutes or wash your skin
thoroughly and get medical attention.
Maintenance and Care
Owner Maintenance
6-36