2018 Peugeot iOn battery

88
Ancillaries battery
All of the electrical components on your vehicle
(with the exception of the electric motor, the
heating and the air conditioning) are powered
by the ancillaries battery.
It is located in the front compartment under
the bonnet and is charged by the main battery
during phases of operation ("Ready" lamp on in
the instrument panel) and charging.If the ancillaries battery is discharged,
the electric motor cannot be started and
charging of the main battery is no longer
possible.
It is not recommended to disconnect the
battery.
However, during a prolonged period of
more than one month without using your
vehicle, it may be necessary, in winter,
to disconnect the battery and store it to
prevent the electrolyte freezing.
After prolonged disconnection of the
battery, you must consult a PEUGEOT
dealer or a qualified workshop in order to
have the electronic computer reset.
Access to the battery
F Open the bonnet using the interior release lever and then the exterior safety catch.
F

S
ecure the bonnet stay.
F

L
oosen the nut 1 .
F

R
emove the protective cover from the
battery for access to the two terminals.
Starting using another
battery
Make sure the electrolyte is not frozen.
Check the level and top up with distilled
water, if necessary.
For more information on Checking levels ,
refer to the corresponding section.
Ensure that the back-up battery is a 12
V
battery.
F

L
ift the protective cover from the (+)
terminal,
In the event of a breakdown

89
F Connect one end of the red cable to the (+ ) terminal of the flat battery A , then the
other end to the ( +) terminal of the back-up
battery
B .
F
C
onnect one end of the green or black
cable to the (-) terminal of the back-up
battery B .
F

C

onnect the other end of the green or black
cable to the earth point C of your broken
down vehicle. F

S
tart the engine of the vehicle with the good
battery and wait for a few minutes.
F
O
perate the ignition switch of your vehicle
until the "Ready" lamp comes on.
F
D
isconnect the jump cables in reverse
o r d e r.
F
R
efit the protective cover on the battery and
tighten the retaining nut.
If the "Ready" warning lamp does not come on,
proceed as follows:
F
L
eave the cables connected.
F
S
et the ignition switch of your vehicle to the
" LOCK " position.
F
C
harge the main battery, following the
normal charging procedure.
F
W
hen the charging indicator lamp comes on
constantly (fixed) in the instrument panel,
disconnect the cables.
F
A
llow the charging to continue for at least
o n e h o u r.
F
O
perate the ignition switch of your vehicle
until the "Ready" lamp comes on.
If the problem persists, contact a PEUGEOT
dealer or a qualified workshop.
Charging the battery using
a battery charger
F Remove the battery protective cover.
Make sure the electrolyte is not frozen.
Check the level and top up with distilled
water, if necessary.
For more information on Checking levels ,
refer to the corresponding section.
F

U
nscrew nut 1 and remove the retaining
clip.
8
In the event of a breakdown

90
F Disconnect the cable from the (-) terminal.
F L ift the protective cover from the (+)
terminal


2.
F

S
lacken the nut 3 .
F

D
isconnect the cable from the (+) terminal.
F

R
emove the battery.
F

C
harge the battery following the instructions
on use provided by the manufacturer of the
battery charger.
F

R
econnect the battery starting with the
cable on the (+) terminal.
Ensure that the terminals and connectors
are clean. If they are covered with
sulphate (whitish or greenish deposit),
remove and clean them. Do not charge the battery without first
disconnecting the terminals and removing
the battery from the front compartment.
Do not disconnect the terminals when the
"Ready" lamp is on, nor when the vehicle
is on charge.
Before disconnecting
Wait 2
minutes after switching off the
ignition before disconnecting the battery.
After reconnection
Following reconnection of the battery,
switch on the ignition and wait 1 minute
before starting, to permit initialisation of
the electronic systems. However, if minor
problems persist following this operation,
contact a PEUGEOT dealer or a qualified
workshop.
Remember to reinitialise the audio system
yourself.
Batteries contain harmful substances such as
sulphuric acid and lead. They must be disposed
of in accordance with local regulations and
must not, in any circumstances, be discarded
with household waste.
Take used remote control batteries and vehicle
batteries to a designated collection point.
Temporary puncture
repair kit
Scan the QR code on page 3 to view
explanatory videos.
Complete kit comprising a compressor and a
sealant bottle, which allows the temporary
repair of a tyre so that you can drive to the
nearest garage.
It is designed to repair most punctures which
could affect the tyre, located on the tyre tread
or shoulder.
Access to the kit
This kit is stored in the storage box located
under the rear bench seat, right-hand side.
Therefore, to access the kit you must remove
the rear seat.
In the event of a breakdown

103
Fuse No.Rating Functions
14 15 ARear wiper.
15 7. 5 AInstrument panel.
16 7. 5 AHeating.
17 20 AHeated seat.
18 10 AOption.
19 7. 5 ADoor mirrors defrosting.
20 20 AWindscreen wipers.
21 7. 5 AAirbags.
22 30 ARear screen defrosting.
23 30 AHeating.
24 -Not used.
25 10 ARadio.
26 15 APassenger compartment fuse. The fusebox is located in the front
compartment, under the heating system fluid
reser voir. Only these fuses can be replaced.
Replacement of the fuses in other boxes
(vacuum pump and ancillaries battery)
requires the involvement of a PEUGEOT
dealer or a qualified workshop.Fuses in the front
compartment
8
In the event of a breakdown

104
Access to the fuses
F Open the bonnet.
F U nclip the protective cover and remove it
completely by pulling it towards you.
F

C
hange the fuse.
F

W
hen you have finished, close the cover
very carefully to ensure correct sealing of
the fusebox. Fuse No.
Rating
Functions
1 -
Not used.
2 30 A
Internal fuse.
3 40 A
Electric motor.
4 40 A
Radiator fan.
5 40 A
Electric windows.
6 30 A
Vacuum pump.
7 15 A
Main battery control unit.
8 15 A
Third brake lamp.
9 15 A
Front foglamps.
10 15 A
Water pump.
11 10 A
On-board charger.
12 10 A
Direction indicators.
13 10 A
Horn.
14 10 A
Daytime running lamps.
15 15 A
Battery fan.
16 10 A
Air conditioning compressor.
17 20 A
Right-hand dipped beam headlamp.
18 20 A
Left-hand dipped beam headlamp, headlamps adjustment.
19 10 ARight-hand main beam headlamp.
20 10 ALeft-hand main beam headlamp.
In the event of a breakdown

106
Motor and main battery
Model code:1 N ZK Y Z
Electric motor Y51
Technology Synchronous with permanent neodymium magnets
Max power: EU standard (kW) 49
Max power motor speed (rpm) 4,000 to 8,800
Max torque: EU standard (Nm) 19 6
Max torque speed (rpm) 0 to 300
Main battery Lithium-Ion
Energy capacity when new (kWh) 14.5
Normal charge
Voltage (V) AC 230
Recharging time
(*)(**):
- 16 A
- 14 A
- 10 A
- 8 A Approximately 6
hours
6
hours
8
hours
11


h o u r s
Fast charge
Voltage (V) DC 300
Charging time (80% charge)** 30
minutes
Range varies depending on the exterior climatic conditions, the driver’s driving style, the use of electrical systems, the frequency of normal or rapid
charges, and ageing of the main battery. *

D

epending on the country's electricity grid.
**

T

ime measured for exterior temperatures between 20 and 25°C. Depending on the use of radio equipment and/or air conditioning, recharging time
may increase.
Technical data

107
Weights (in kg)
Electric motorY51
Main battery Lithium-Ion
Model code: 1 N ZK Y Z
Unladen weight 1,0 6 5
Kerb weight 1,14 0
Gross vehicle weight (GV W) 1,4 5 0
Gross train weight (GTW) 1,4 5 0
Maximum load on the roof (including the roof bars weight) 43
Your vehicle cannot be fitted with a towbar. It cannot tow a trailer.
9
Technical data

1
Bluetooth® audio system
Contents
First steps
1
R

adio 2
Media

3
T

elephone

6
Audio settings
8
C

onfiguration

8
Frequently asked questions

9
F

or safety reasons, the vehicle must
always be stationary for the driver to
perform operations that require close
attention.
When the engine is switched off and to
prevent discharging of the battery, the
system switches off after activation of
energy economy mode. After a battery disconnection, a code must
be entered to access the audio system
functions.
You can try five times at most. There is
approximately fifteen minutes waiting time
between each of the last two tries.
Go to the end of this document to recover
the label indicating the code:
First steps
On/Off, volume adjustment.
Adjust audio options: sound
ambience, treble, bass, loudness,
distribution, left/right balance, front/
rear balance, automatic volume.
Automatic search for a lower radio
frequency.
Select the previous CD, USB track.
Scroll in a list.
Press and hold: rewind.
Display the list of stations received,
the CD/USB tracks or folders.
Press and hold: update the list of
stations received.
Cancel the current operation.
Go up one level (menu or folder).
Automatic search for a higher radio
frequency.
Select the next CD, USB track.
Scroll in a list.
Press and hold: fast for ward.
Access to the main menu.
.
Bluetooth® audio system