2018 KIA STONIC lock

CAUTION
Make sure nothing is near the tail‐gate latch and striker while closingthe tailgate. It may damage the tail‐gate's latch.
WARNING
nExhaust fumes
If you drive with the tailgate open,you will draw dangerous exhaustfumes into your vehicle which cancause serious injury or death to vehi‐cle occupants.If you must drive with the tailgateopen, keep the air vents and all win‐dows open so that additional outsideair comes into the vehicle.The tailgate lid should be alwayskept completely closed while the ve‐hicle is in motion. If it is left open orajar, poisonous exhaust gases mayenter the car and serious illness ordeath may result.
WARNING
nRear cargo area
Occupants should never ride in therear cargo area where no restraintsare available. To avoid injury in theevent of an accident or suddenstops, occupants should always beproperly restrained.
WARNING
•For emergencies, be fully aware ofthe location of the emergency tail‐gate safety release lever in the ve‐hicle and how to open the tailgateif you are accidentally locked in theluggage compartment.
•No one should be allowed to occu‐py the luggage compartment ofthe vehicle at any time. The lug‐gage compartment is a very dan‐gerous location in the event of acrash.
•Use the release lever for emergen‐cies only. Use with extreme cau‐tion, especially while the vehicle isin motion.
Emergency tailgate safety
release
0:#%
Your vehicle is equipped with the emer‐
gency tailgate safety release lever lo‐ cated on the bottom of the tailgate.
When someone is inadvertently locked
in the luggage compartment.
The tailgate can be opened by doing as follows: 1. Input the mechanical key into the hole.
2. Push the mechanical key to the right (1).
3. Push up the tailgate.
Features of your vehicle
4-22

WINDOWS
1. Driver’s door power window switch
2. Front passenger’s door power win‐dow switch
3. Rear door (left) power window switch *
4. Rear door (right) power window switch *
5. Window opening and closing6. Automatic power window up *
/
down *
(Driver’s window)
7. Power window lock switch *
NOTICE
In cold and wet climates, power win‐
dows may not work properly due to
freezing conditions.
Power windows (if equipped)
The ignition switch must be in the ON
position for power windows to operate.
* if equipped

4-23
4
Features of your vehicle

Each door has a power window switch
that controls the door's window. The driver has a power window lock switch
which can block the operation rear pas‐
senger windows. The power windows can be operated for approximately
30 seconds after the ignition key is re‐
moved or turned to the ACC or LOCK position. However, if the front doors
open, the power windows cannot be
operated within the 30 second period after ignition key removal (if equipped).
If the window cannot be close because
it is blocked by objects, remove the ob‐
jects and close the window.
NOTICE
While driving with the rear windows
down or with the sunroof (if equip‐
ped) in an open (or partially open po‐
sition), your vehicle may demon‐
strate a wind buffeting or pulsation
noise. This noise is a normal occur‐
rence and can be reduced or elimina‐
ted by taking the following actions.
If the noise occurs with one or both
of the rear windows down, partially
lower both front windows approxi‐
(Continued)
(Continued)
mately one inch. If you experience
the noise with the sunroof open,
slightly reduce the size of the sun‐
roof opening.
WARNING
Do not install any accessories in thearea of windows. It may impact jamprotection.
Window opening and closing
The driver’s door has a master power
window switch that controls all the windows in the vehicle.
To open or close a window, press down
or pull up the front portion of the cor‐
responding switch to the first detent position (5).
Features of your vehicle
4-24

Auto up/down window (if equipped)
Pressing or pulling up the power win‐
dow switch momentarily to the second detent position (6) completely lowers
or lifts the window even when the
switch is released. To stop the window at the desired position while the win‐
dow is in operation, pull up or press and
release the switch to the opposite di‐
rection of the movement.
If the power window is not operated
correctly, the automatic power window
system must be reset as follows: 1. Turn the ignition switch to the ON position. 2. Close the window and continue
pulling up on the driver’s power
window switch for at least 1 sec‐
ond after the window is completely closed.
Automatic reversal
If the upward movement of the window
is blocked by an object or part of the
body, the window will detect the resist‐
ance and will stop upward movement.
The window will then lower approxi‐ mately 30 cm (11.8 in.) to allow the ob‐
ject to be cleared. If the window detects the resistance
while the power window switch is
pulled up continuously, the window will
stop upward movement then lower ap‐ proximately 2.5 cm (1 in.).
And if the power window switch is
pulled up continuously again within 5
seconds after the window is lowered by the automatic window reversal feature,
the automatic window reversal will not
operate.
NOTICE
The automatic reverse feature for
the driver’s window is only active
when the L

(Continued)
juries or vehicle damage. If an objectless than 4 mm (0.16 in.) in diameteris caught between the window glassand the upper window channel, theautomatic reverse window may notdetect the resistance and will notstop and reverse direction.
WARNING
The automatic reverse featuredoesn't active while resetting powerwindow system.Make sure body parts or other ob‐jects are safely out of the way be‐fore closing the windows to avoid in‐juries or vehicle damage.
Power window lock button (if
equipped)
• The driver can disable the power win‐dow switches on the rear passenger
doors by pressing the power window lock button located on the driver’s
door to the LOCK position (pressed).
•
When the power window lock buttonis in the LOCK position (pressed), thedriver’s master control can operateall power windows. Also, the frontpassenger’s control can operate thefront passenger’s power window.
CAUTION
•To prevent possible damage to thepower window system, do notopen or close two windows ormore at the same time. This willalso ensure the longevity of thefuse.
•Never try to operate the mainswitch on the driver's door and theindividual door window switch inopposite directions at the sametime. If this is done, the windowwill stop and cannot be opened orclosed.
WARNING
nWindows
•NEVER leave the ignition key in thevehicle with unsupervised children,when the engine is running.
(Continued)
Features of your vehicle
4-26

(Continued)
•NEVER leave any child unattendedin the vehicle. Even very youngchildren may inadvertently causethe vehicle to move, entanglethemselves in the windows, orotherwise injure themselves orothers.
•Always double check to make sureall arms, hands, head and otherobstructions are safely out of theway before closing a window.
•Do not allow children to play withthe power windows. Keep the driv‐er’s door power window lock but‐ton in the LOCK position (pressed).Serious injury can result from un‐intentional window operation bythe child.
•Do not extend a face or arms out‐side through the window openingwhile driving.
Manual windows (if equipped)
To raise or lower the window, turn the
window regulator handle clockwise or counterclockwise.
WARNING
When opening or closing the win‐dows, make sure your passenger'sarms, hands and body are safely outof the way.

4-27
4
Features of your vehicle

Closing the hood
1. Before closing the hood, check thefollowing:• All filler caps in engine compart‐ ment must be correctly installed.
• Gloves, rags or any other com‐ bustible material must be re‐
moved from the engine compart‐ment.
2. Return the support rod to its clip to prevent it from rattling.
3. Lower the hood until it is about 30 cm above the closed position and
let it drop. Make sure that it locks
into place.
4. Check that the hood has engaged properly. If the hood can be raised
slightly, it is not properly engaged.
Open it again and close it with a lit‐
tle more force.WARNING
•Before closing the hood, ensurethat all obstructions are removedfrom the hood opening. Closing thehood with an obstruction presentin the hood opening may result inproperty damage or severe per‐sonal injury.
•Do not leave gloves, rags or anyother combustible material in theengine compartment. Doing somay cause a heat-induced fire.
WARNING
•Always double check to be surethat the hood is firmly latched be‐fore driving away. If it is not latch‐ed, the hood could fly open whilethe vehicle is being driven, causinga total loss of visibility, whichmight result in an accident.
(Continued)
(Continued)
•The support rod must be insertedcompletely into the hole providedin the hood whenever you inspectthe engine compartment. This willprevent the hood from falling andpossibly injuring you.
•Do not move the vehicle with thehood raised. The view will beblocked and the hood could fall orbe damaged.

4-29
4
Features of your vehicle

FUEL FILLER LID
Opening the fuel filler lid
0:##
The fuel-filler lid must be opened from
inside the vehicle by pulling up on the fuel-filler lid opener located on the
front floor area on the driver’s seat.
NOTICE
If the fuel filler lid will not open be‐
cause ice has formed around it, tap
lightly or push on the lid to break the
ice and release the lid. Do not pry on
the lid. If necessary, spray around
the lid with an approved de-icer fluid
(do not use radiator anti-freeze) or
move the vehicle to a warm place
and allow the ice to melt.
0:#%
1. Stop the engine. 2. To open the fuel filler lid, pull up the
fuel filler lid opener.
3. Pull the fuel filler lid (1) out to fully open.
4. To remove the cap, turn the fuel tank cap (2) counterclockwise.
5. Refuel as needed.
Closing the fuel filler lid
1. To install the cap, turn it clockwise until it L