2018 FIAT 500 charging

KNOWING YOUR CAR
60
Radio passport
This document certifies ownership of
the system. The vehicle radio passport
shows the system model, serial
number and secret code.
WARNING Keep the vehicle radio
passport in a safe place so that you
can give the information to the relevant
authorities if the system is stolen.
In case of loss of the car radio
passport, contact the Fiat Dealership,
taking an ID document and the car
ownership documents.Important notes
In the event of a failure, the system
should only be checked and repaired at
a Fiat Dealership.
If the temperature is particularly low,
the display may take a while to reach
optimum brightness.
If the vehicle is stopped for a while and
the external temperature is very high,
the system may go into “thermal
protection” mode, suspending
operation until the temperature in the
passenger compartment returns to
acceptable levels.
Look at the screen only and when it is
necessary and safe.
If you need to look at the screen for a
long time, pull over to a safe place so
as not to be distracted while driving.
Immediately stop using the system in
the event of a fault. Otherwise the
system might be damaged. Contact a
Fiat Dealership as soon as possible to
have the system repaired.
USB SOURCE
To activate USB mode, insert an
appropriate device into the vehicle USB
port (fig. 61).
IMPORTANT After using a USB
recharging socket, we recommend
always disconnecting the device
(smartphone) by removing the cable
from the vehicle socket first, never
from the device (fig. 61).
Cables left flying or connected
incorrectly could compromise correct
recharging and/or the USB socket
condition.
61DVDF0S0188c

IN AN EMERGENCY
144
IF THE BATTERY IS
FLAT36)
IMPORTANT The battery recharging
procedure is provided for information
purposes only. You are advised to
contact a Fiat Dealership to have this
operation carried out.
IMPORTANT After turning the ignition
key to STOP and having closed the
driver’s side door, wait at least one
minute before disconnecting the battery
and then reconnecting the electrical
supply to the battery.
Charging should be slow at a low
ampere rating for approximately 24
hours. Charging for a longer time may
damage the battery.
Versions without Start&Stop
(for versions/markets, where provided)
To recharge, proceed as follows:
❒ disconnect the terminal from the
negative battery pole;
❒ connect the charger cables to the
battery terminals, making sure that
polarities are correct;
❒ turn on the charger;
❒ when you have finished, turn the
charger off before disconnecting the
battery;
❒ reconnect the terminal to the
negative battery pole.
Versions with Start&Stop
(for versions/markets, where provided)
To recharge, proceed as follows:
❒ disconnect the connector A fig. 132
(pressing the button B) from the
sensor C monitoring the battery
charge status, on the negative pole
D of the battery;
132DVDF0S0127c
❒ connect the positive cable of the
battery charger to the positive
battery pole E fig. 133 and the
negative cable to the terminal of
sensor D;
❒ turn on the charger. At the end of
the charging process, switch the
battery charger off;
❒ after having disconnected the
battery charger, reconnect
connector A to the sensor C as
shown in fig. 132.
133DVDF0S0128c

IMPORTANT INFORMATION AND RECOMMENDATIONS
198
PERSONAL SAFETY
(CONTINUED)
Do not use the jack for loads higher than the one shown on its
label. Never start the engine with vehicle raised. If the vehicle is
raised more than necessary, everything can become more
unstable, with the risk of the vehicle dropping violently.
Thus, lift the vehicle only as needed in order to access the
spare tyre.
33) FIX&GO QUICK TYRE REPAIR KIT
•The information required by the applicable regulation is
indicated on the Fix&Go kit package label. Carefully read the
label on the cartridge before use, avoid improper use. The kit
should be used by adults and cannot be used by children.
IMPORTANT: Do not exceed 80 km/h. Avoid sudden
acceleration or braking. The kit provides a temporary repair,
therefore the tyre must be examined and repaired by a
specialist as soon as possible. Before using the kit, ensure that
the tyre is not excessively damaged and that the rim is in good
condition, otherwise do not use it and call roadside assistance.
Do not remove foreign bodies from the tyre. Do not let the
compressor turned on for more than 20 consecutive minutes -
overheating hazard.
34) CHANGING A BULB
•Modifications or repairs to the electric system that are not
carried out properly or do not take the system technical
specifications into account can cause malfunctions leading to
the risk of fire.
•Halogen bulbs contain pressurised gas, in the case of
breakage they may burst causing glass fragments to be
projected outwards.
•Due to the high power supply voltage, gas discharge bulbs
(Xenon) should only be replaced by specialised personnel:
danger of death! Contact a Fiat Dealership.35) REPLACING FUSES
•If the replaced fuse blows again, contact a Fiat Dealership.
•Never replace a fuse with metal wires or anything else.
•Never replace a fuse with another with a higher amp rating; RISK
OF FIRE.
•If a general fuse (MEGA-FUSE, MIDI-FUSE,
MAXI-FUSE) blows contact a Fiat Dealership.
•Before replacing a fuse, make sure that the ignition key has
been removed and that all the other services are switched off
and/or disengaged.
•Contact Fiat Dealership if a safety system (airbags, brakes),
engine system
(engine, gearbox) or steering system general protection fuse
blows.
36) BATTERY RECHARGING
•Battery fluid is poisonous and corrosive:
avoid contact with your skin and eyes. The battery should be
charged in a well ventilated place, away from naked flames or
possible sources of sparks: danger of explosion and fire.
•Do not attempt to charge a frozen battery: it must be thawed
first, otherwise it may explode.
If freezing has occurred, the battery should be checked by skilled
personnel to make sure that the internal elements are not
damaged and that the body is not cracked, with the risk of leaking
poisonous and corrosive acid.
37) TOWING THE CAR
•Before tightening the ring clean the threaded housing thoroughly.
Make sure that the ring is fully fastened in the housing before
towing the car.
(CONTINUES)

IMPORTANT INFORMATION AND RECOMMENDATIONS
208
1) KEYS - REMOTE CONTROL
Used batteries should be disposed of, as specified by law, in
the special containers, otherwise take them to a Fiat
Dealership, which will deal with their disposal.
2) CLIMATE CONTROL SYSTEM
The system uses R1234yf coolant, which is compatible with
the laws in force in the countries where the vehicle is sold.
When charging, only use the gas indicated on the plate in the
engine compartment. The use of other coolants affects the
efficiency and condition of the system. The lubricant used for
the compressor is also strictly linked to the refrigerant gas type,
refer to the Fiat Dealership.
3) SERVICING - CHECKING FLUID LEVELS
• Used engine oil and oil filters contain substances which are
harmful to the environment. To change the oil and filters, we
advise you to contact a Fiat Dealership.
• Used transmission fluid contains substances that are harmful
to the environment. It is advisable to have the oil changed by a
Fiat Dealership where it will be disposed of respecting the
environment and according to legal requirements.
•Batteries contain substances which are very dangerous for the
environment. It is advisable to contact a Fiat Dealership for
battery replacement.
ENVIRONMENTAL PROTECTION
4) MAINTENANCE - BODYWORK
Detergents pollute the environment. Only wash your vehicle in
areas equipped to collect and treat wastewater from this type of
activity.

217
– Suitability of passenger seats for use with i-Size......... 110
Supplementary restraint system (SRS) - airbag..............114
– Front airbags .............................................................114
– Passenger airbag deactivation....................................117
– Side bags ..................................................................117
STARTING AND DRIVING
Engine starting..............................................................119
Handbrake ...................................................................120
Using the manual gearbox ............................................120
Using the Dualogic gearbox ..........................................121
– Operating mode .........................................................121
– MANUAL logic.......................................................... 121
– AUTO logic............................................................... 121
– Shift paddles..............................................................122
Speed limiter............................................................... 123
– Enabling the device................................................... 123
– Speed limit programming........................................... 124
– Device activation/ deactivation................................... 124
– Exceeding the programmed speed............................ 124
– Flashing of programmed speed................................. 124
– Disabling the device................................................... 124
Electronic cruise control ............................................. 125
– Enabling the device................................................... 125
– Setting the desired speed.......................................... 126
– Increasing the speed................................................. 126
– Decreasing speed...................................................... 126
– Recalling the speed................................................... 126
– Deactivating the device.............................................. 126
– Disabling the device................................................... 126
IN AN EMERGENCY
Jump starting................................................................127
Bump starting...............................................................128
Changing a wheel .........................................................128
– Jack......................................................................... 128
– Raising with a jack and replacing a wheel ...................128
– Refitting the wheel......................................................130
Fix&Go Automatic fast tyre repair kit.......................131-133
Changing a bulb ...........................................................134
– General information ..................................................134
– Bulb types .................................................................135
– Front light clusters .....................................................136
– Dipped beam headlights ............................................137
– Main beam headlights ................................................137
– Side lights/brake lights................................................138
– Direction indicators.....................................................138
– Front fog lights ..........................................................139
– Rear light clusters ......................................................139
– Reverse/rear fog light..................................................140
– Third brake light .........................................................140
– Number plate lights ...................................................141
Fuse replacement .........................................................141
– Dashboard fuses .......................................................141
– Engine compartment fuses.........................................142
Recharging the battery .................................................144
Towing the car .............................................................145
– Attaching the tow ring.................................................145
SERVICING AND CARE
Scheduled servicing plan .......................................147-153
Regular checks ............................................................154