2018 FIAT 500 brake light

IN AN EMERGENCY
142
FuseAmpereDescription
F13 5 •
Left dipped headlight and headlight alignment control unit power supply
F36 15 Diagnosis socket, radio, climate control, EOBD
F37 5 Brake light switch, instrument panel node
F38 15 Central door locking
F43 15 Windscreen/rear window washer pump
F47 20 Driver’s side power window
F48 20 Passenger’s side power window
F49 5 Parking sensor, control backlighting, electric mirrors
F51 7.5 Climate control, brake lights, clutch, sunroof, electric mirrors
F53 5 Instrument panel node
•
For versions/markets, where provided
ENGINE COMPARTMENT
JUNCTION BOX
The fuse box is located on the right
side of the engine compartment.
To access the fuses, proceed as
follows:
❒ Fully press the screw A fig. 130;
❒ at the same time slowly rotate the
screw anticlockwise, until resistance
is encountered (do not overtighten);
❒ slowly release the screw;
❒ opening is indicated by the entire
screw head coming out of its
housing;
❒ remove cover B, sliding it upwards
on the side guides, as indicated in
the figure.
❒ after replacing the fuse, refit the
cover, making sure that it is closed
properly.
130DVDF0S0201c

Years4321SERVICING AND CARE
148
5109876
SCHEDULED SERVICING PLAN39) 21)
Thousands of kilometres7515013512010590
PETROL/LPG VERSIONS
IMPORTANT: When you have carried out the last intervention in the table, continue with the scheduled servicing,
maintaining the frequency indicated in the plan by marking each operation with a dot or dedicated note.
Warning: simply restarting maintenance from the beginning of the plan may cause the allowed interval to be exceeded for
some operations!
60453015
Thousands of miles4590817263543627189





 
 
 
 Check tyre condition/wear and adjust pressure, if necessary;
check the condition/expiry date of the “Fix&Go Automatic” repair kit (for versions/markets, where provided)
Check operation of lighting system (headlights, direction indicators,
hazard warning lights, boot, passenger compartment,
glove compartment, instrument panel warning lights, etc.)
Check and, if necessary, top up fluid levels (1)
Check exhaust emissions/smokiness
Use the diagnosis socket to check supply/engine management
systems, emissions and engine oil decay
(for versions/markets, where provided)
Visually inspect the conditions of: bodywork, underbody protection,
pipes and tubes (exhaust - fuel - brakes), rubber parts
(boots, sleeves, bushes, etc.)
Check windscreen/rear window wiper blade
position/wear (for markets/versions, where provided)
Check operation of windscreen washer system and adjust jets
if necessary
Check cleanliness of bonnet and luggage compartment locks,
cleanliness and lubrication of linkage
(1) Topping up must be carried out with the fluids indicated in this Use and Maintenance Booklet and only after checking that the system is
undamaged

151
43215109876
100200180160140120
DIESEL VERSIONS
IMPORTANT: When you have carried out the last intervention in the table, continue with the scheduled servicing, maintaining
the frequency indicated in the plan by marking each operation with a dot or dedicated note.
Warning: simply restarting maintenance from the beginning of the plan may cause the allowed interval to be exceeded for
some operations!
80604020
Check tyre condition/wear and adjust pressure, if necessary;
check the condition/expiry date of the “Fix&Go Automatic” repair kit
(for versions/markets, where provided)
Check operation of lighting system (headlights, direction indicators,
hazard warning lights, boot, passenger compartment,
glove compartment, instrument panel warning lights, etc.)
Check and, if necessary, top up fluid levels (1)
Check exhaust emissions/smokiness
Use the diagnosis socket to check supply/engine management
systems, emissions and engine oil decay (for versions/markets,
where provided)
Visually inspect the conditions of: bodywork, underbody protection,
pipes and tubes (exhaust - fuel - brakes), rubber parts
(boots, sleeves, bushes, etc.)
Check windscreen/rear window wiper blade position/wear
(for markets/versions, where provided)
Check operation of windscreen washer system and adjust jets
if necessary
Check cleanliness of bonnet and luggage compartment locks,
cleanliness and lubrication of linkage
(1) Topping up must be carried out with the fluids indicated in this Use and Maintenance Booklet and only after checking that the system is
undamaged




 
 
 

Thousands of kilometres
Thousands of miles6012010896847248362412
Years

SERVICING AND CARE
152
43215109876
Check soft top operation while closing and opening;
check of seals and lubrication of canvas sliding
side guide (convertible versions only)
Check handbrake lever travel and adjust, if necessary
Check conditions and wear of front/rear disc brake
pads (for versions/markets, where provided) and
operation of pad wear indicator
Visually inspect condition and wear of the rear drum brake lining
Inspect and if necessary adjust tensioning of accessory drive belt(s)
(for versions without automatic tensioner only)
Visually inspect condition of the accessory drive belt(s)
Change engine oil and replace oil filter (2)
Replace accessory drive belt(s) (3)
(2) The engine oil and filter change interval depends on driving conditions and is signalled by a warning light or message on the instrument
panel. In any case, it must never exceed 2 years. If the vehicle is mainly used in towns and cities, change the engine oil and filter every year.
(3) Areas that are not dusty: advised maximum distance 120,000 km. The belt must be replaced every 6 years, regardless of distance
travelled. Dusty areas and/or demanding use of the car (cold climates, town use, long periods of idling): advised maximum mileage
60,000 km. The belt must be replaced every 4 years, regardless of distance travelled.
(
❍) Recommended operations
() Mandatory operations





10020018016014012080604020Thousands of kilometres
Thousands of miles6012010896847248362412
Years

SERVICING AND CARE
154
REGULAR
INSPECTIONS
39) 22) 4)
Every 1,000 km or before long
journeys, check and, if necessary, top
up the following:
❒ engine coolant fluid level;
❒ brake fluid level;
❒ windscreen washer fluid level;
❒ tyre inflation pressure and condition;
❒ operation of lighting system
(headlights, direction indicators,
hazard warning lights, etc.);
❒ operation of the windscreen
wiper/washer system, position and
wear of the windscreen and rear
window wiper blades.
Every 3,000 km check and top up if
required: engine oil level.
You are advised to use PETRONAS
LUBRICANTS products, which have
been designed and produced
specifically for Fiat cars (see table
“Capacities” in the “Technical
specifications” section).
DEMANDING USE
OF THE CAR
If the vehicle is mainly used in one of
the following particularly harsh
conditions:
❒ trailer or caravan towing;
❒ dusty roads;
❒ short repeated distances (less than
7-8 km) and with external
temperatures below zero;
❒ engine often idling or driving long
distances at low speeds or long
periods of inactivity;
perform the following inspections more
frequently than shown on the
Scheduled Servicing Plan:
❒ check front disk brake pad
conditions and wear;
❒ Check cleanliness of bonnet and
luggage compartment locks,
cleanliness and lubrication of
linkage;❒ sight inspect the conditions of:
engine, gearbox, transmission,
pipes and hoses (exhaust -
fuel - brakes), rubber parts
(boots, sleeves, bushes, etc.);
❒ check battery charge and battery
fluid level (electrolyte);
❒ visually check the various drive belt
conditions;
❒ check and, if necessary, change
engine oil and replace oil filter;
❒ check pollen filter and replace it, if
required;
❒ check air cleaner and replace it, if
required.

161
BRAKES
Depending on the version/market, the
vehicle may be equipped with
mechanical wear detectors for the
brake pads: one for each wheel
assembly.
When the brake linings are close to
wearing out, pressing the brake pedal
will generate a slight squeal: this lasts
for about 100 km (the mileage varies
with the driving style and route).
In this case, it is still possible to
continue driving, with caution.
However, contact a Fiat Dealership as
soon as possible to have the worn
brake pads changed.
WINDSCREEN
WIPER REAR
WINDOW WIPER 41)
Replace the blades if the rubber edge is
deformed or worn. In any case, it is
advisable to replace them
approximately once a year.
LIFTING THE BLADES
WINDSCREEN WIPER
Lift the windscreen wiper arm and
position the blade so that it forms a 90°
angle with the arm;
REPLACING THE
WINDSCREEN WIPER
BLADES
Proceed as follows:
❒ lift the windscreen wiper arm;
❒ press the button A-fig. 144 and
extract the blade C from the arm B;
❒ insert the new blade making sure it
is locked.
REPLACING THE REAR
WINDOW WIPER BLADE
Proceed as follows:
❒ raise the cover A-fig. 145 and
remove the arm from the vehicle by
loosening nut B that fastens it to the
pivot pin;
❒ position the new arm correct and
tighten the nut;
144DVDF0S0129c

181
Fuel tank (litres): 35 35
Including a reserve of (litres): 5 5
Engine cooling system
(litres): 6.3 6.3
Engine sump (litres): 2.8 3.7
Engine sump and filter (litres): 3.0 3.9
Gearbox
casing/differential: 1.55 (kg) 1.55 (kg)
Hydraulic brake circuit (kg): 0.55 0.55
Hydraulic clutch controls
(RH drive versions): – –
Hydraulic clutch controls
(RH drive versions): 2.5 2.5
When the vehicle is used in particularly harsh weather conditions, we recommend using a 60% mixture of PARAFLUUPand 40% of
demineralised water.
Diesel versions1.3 16V Multijet
95 HP EURO 51.3 16V 78 HP / 95 HP
EURO 6Prescribed fuels and
original lubricants
Diesel for motor vehicles (EN590
specifications)
Mixture of distilled water and
PARAFLU
UPat 50% 
SELENIA WR P.E.
TUTELA TRANSMISSION GEARFORCE
TUTELA TOP 4 or TUTELA TOP 4/S
Mixture of water and
PETRONAS DURANCE SC35
Maximum refuelling capacity (including reserve): 30.5 litres of LPG
The figure already takes into account the 80% tank filling limit and the residual fluid required for priming; this figure
represents the maximum permitted capacity. There may be slight variations to this figure as a result of:
differences between the network pump supply pressures, pumps having different supply/locking features,
tank not completely run out of fuel.
LPG versions

PERSONAL SAFETY
187
IMPORTANT INFORMATION AND
RECOMMENDATIONS
3) ADJUSTMENTS
Any and all adjustments to seats, head restraints, steering wheel or
rear view mirrors must be performed exclusively with the
vehicle stationary and the engine off.
4) SEATS
•If a side bag is fitted, it is dangerous to use
seat covers not available from Lineaccessori MOPAR
®.
•Once you have released the adjustment lever, always check that
the seat is locked on the guides by trying to move it back and
forth. If the seat is not locked into place, it may unexpectedly slide
and cause the driver to lose control of the car.
5) HEAD RESTRAINTS
• All adjustments must be carried out only with the car stationary
and engine off. The head restraints should be adjusted to support
the back of your head and not your neck. Only in this position do
they exert their protective action.
• To make the best use of the protective action of the head
restraints, adjust the backrest so that you are sitting upright and
keep your head as close as possible to the head restraint.
6) REAR VIEW MIRRORS
As door mirrors are curved, they may slightly alter the perception
of distance. When driving, these mirrors must always be in the
open position.
We recommend you carefully read the following environmental information.
In an emergency we recommend that you call the toll-free phone number found in the Warranty Booklet.
Go to the www.fiat500.com website to locate the Fiat Dealership closest to you.
(CONTINUES)
1) THE KEYS
Press button B fig. 9 only with the key away from your body,
especially your eyes and from objects which could get damaged
(e.g. your clothes).
Do not leave the key unattended to avoid the button being
accidentally pressed while it is being handled, e.g. by a child.
2) STARTING DEVICE
• Never remove the key while the car is moving.
The steering wheel will automatically lock as soon as it is turned.
This holds true for cars being towed as well.
• It is absolutely forbidden to carry out any after-market operation
involving steering system or steering column modifications
(e.g. installation of anti-theft device) that could adversely affect
performance and safety, invalidate the warranty and also result in
non-compliance of the vehicle with type-approval requirements.
•If the ignition device has been tampered with
(e.g. an attempted theft), have it checked over by a Fiat
Dealership before driving again.
•Always remove the key when you leave your car to prevent
someone from accidentally operating the controls.
Remember to engage the handbrake.
If the car is parked on a slope uphill, engage the first gear; if the
car is facing downhill, engage the reverse gear. Never leave
children unattended in the vehicle.