2017 VOLVO V90 warning light

WHEELS AND TYRES
}}
* Option/accessory.495
IMPORTANT
Risk of overheating. The compressor must not run for more than 10 minutes.
5. Inflate the tyre to the pressure specified on
the tyre pressure label on the driver side door pillar. (Release air using the pressure reduc-ing valve if the tyre pressure is too high.)
6. Switch off the compressor. Detach the airhose and cable.
7. Refit the dust cap.
Related information
• Emergency puncture repair kit (p. 490)
• Approved tyre pressures (p. 574)
When changing wheels
The car's wheels can be changed, e.g. to winter wheels or a spare wheel.
Follow the relevant instructions for removing and fitting wheels.
When changing to another tyre
dimension
Check that the tyre dimension is approved foruse on the car. Contact an authorised Volvo workshop for updat- ing the software at each change of tyre dimen-sion. A software download may be necessaryboth when changing to larger and smaller dimen-sions, and also when switching between summerand winter wheels.
Related information
• Removing a wheel (p. 495)
• Fitting the wheels (p. 497)
• Tool kit (p. 500)
• Winter wheels (p. 499)
• Spare wheel
* (p. 498)
• Wheel bolts (p. 498)
Removing a wheel
Instructions for removing a wheel when chang- ing wheels.
1. Set up the warning triangle and activate the hazard warning lights if a tyre is being changed in a trafficked location.
2. Apply the parking brake and engage gear position P, or engage first gear if the car has
a manual gearbox. Applies to cars with
Leveling Control* : If
the car is equipped with air suspension, this must be disabled before the car is raised with a jack *.
Deactivate the function via the top view of the centre display by pressing
Settings
My CarSuspension and selectingDisable Leveling Control.

MAINTENANCE AND SERVICE
514
Opening and closing the bonnet
The bonnet can be opened using the handle in the passenger compartment and a handle underthe bonnet.
Open the bonnet
Pull the handle near the foot pedals to release the bonnet from its fully closed posi-tion.
Turn the handle under the bonnet anticlock- wise to release the bonnet from the lockcatches and lift the bonnet.
Warning - bonnet not closed
When the bonnet is released, the warn- ing symbol and the graphics in thedriver display will light up and anacoustic reminder will sound. If the car
starts rolling, an acoustic warning signal willrepeat. For more information on graphics, see section "Door and seatbelt reminder".
NOTE
If the warning symbol is lit or the warning sig- nal is heard despite the bonnet being closedproperly, contact an authorised Volvo work-shop.
Close the bonnet1. Push the bonnet down until it starts to fall from its own weight.
2. When the bonnet stops against the lock catch, push the bonnet to close it completely.
WARNING
Risk of crushing! Ensure that the closing path under the bonnet is not obstructed, otherwisethere is a risk of personal injury.
WARNING
Check that the bonnet locks properly when closed. The bonnet must engage at bothsides audibly.

MAINTENANCE AND SERVICE
520
Servicing the climate control system The air conditioning system must only be serv- iced and repaired by an authorised workshop.
Troubleshooting and repairThe air conditioning system contains fluorescent tracing agents. Ultraviolet light must be used dur-ing leak detection. Volvo recommends that you contact an author- ised Volvo workshop.
Cars with R134a refrigerant
WARNING
The air conditioning system contains pressur- ised refrigerant R134a. This system must onlybe serviced and repaired by an authorisedworkshop.
Cars with R1234yf refrigerant
WARNING
The air conditioning system contains pressur- ised refrigerant R1234yf. In accordance withSAE J2845 (Technician Training for SafeService and Containment of RefrigerantsUsed in Mobile A/C System), service andrepair of the refrigerant system must only beperformed by trained and certified techniciansin order to ensure the safety of the system.
Related information
•Volvo service programme (p. 506)
Bulb replacement
The bulb in the halogen headlamp, reversing lamp and rear fog lamp can be replaced by thedriver.
The bulb in the halogen headlamp can be replaced without the help of a workshop, but theplastic cover over the headlamp must be removedbefore a bulb can be replaced.
–Press down the pins into the plastic cover's four clips using a screwdriver or similar andlift away the cover.

MAINTENANCE AND SERVICE
}}
* Option/accessory.521
NOTE
Points to remember when the cover is refit- ted: •The pin in the clip needs to be pressed back fully before the clip is refitted in thecover.
• When the cover is refitted, the pin mustbe pressed in until the end surface islevel with the surface of the clip.
The reversing lamp bulb and the rear fog lamp bulb can be replaced without assistance from aworkshop. Contact a workshop 9
if there is a fault in bulbs
other than the bulbs in the halogen headlamps, the reversing lamp bulb or the rear fog lamp bulb. If a fault occurs in LED 10
lamps, the entire lamp
unit usually must be replaced.
WARNING
The car's electrical system must be in ignition position 0 when replacing bulbs.
IMPORTANT
Never touch the glass part of the bulbs with your fingers. Grease from your fingers isvaporised by the heat, coating the reflectorand then causing damage.
NOTE
If an error message remains after the broken bulb has been replaced then we recommendvisiting an authorised Volvo workshop.
NOTE
Outside lighting such as headlamps and rear lamps may temporarily have condensation onthe inside of the lens. This is normal, all exte-rior lighting is designed to withstand this.Condensation is normally vented out of thelamp housing when the lamp has beenswitched on for a time.
Lamps, front (car with halogen headlamps)
Dipped beam
Main beam
Daytime running lights/position lamps
Indicator
Front fog lamps/cornering lights * (LED 10
)
9An authorised Volvo workshop is recommended.
10 LED (Light Emitting Diode)

MAINTENANCE AND SERVICE
}}
549
Cleaning the exterior
The car should be washed as soon as it becomes dirty. This means that the car is easierto clean since the dirt does not attach as firmly.It also reduces the risk of scratches and keepsthe car fresh. Wash the car in a car wash with oilseparator. Use car shampoo.
Handwashing
• Remove bird droppings from the paintwork as soon as possible. Bird droppings containchemicals that affect and discolour paintworkvery quickly. For example, use soft paper orsponge soaked in plenty of water. An author-ised Volvo workshop is recommended for theremoval of any discoloration.
• Hose down the underbody.
• Rinse the entire car until the dissolved dirthas been removed so as to reduce the risk ofscratches from washing. Do not spray directlyonto the locks.
• If necessary, use cold degreasing agent onvery dirty surfaces. Note that in this case, thesurfaces must not be hot from the sun.
• Wash using a sponge, car shampoo andplenty of lukewarm water.
• Clean the wiper blades with a lukewarm soapsolution or car shampoo.
• Dry the car using a clean, soft chamois or awater scraper. If you avoid allowing drops ofwater to dry in strong sunlight, you reduce the risk of water drying stains which mayneed to be polished out.
WARNING
Always have the engine cleaned by a work- shop. There is a risk of fire if the engine is hot.
IMPORTANT
Dirty headlamps have impaired functionality. Clean them regularly, e.g. when refuelling. Do not use any corrosive cleaning agents but use water and a non-scratching spongeinstead.
NOTE
Outside lighting such as headlamps and rear lamps may temporarily have condensation onthe inside of the lens. This is normal, all exte-rior lighting is designed to withstand this.Condensation is normally vented out of thelamp housing when the lamp has beenswitched on for a time.
Automatic car washAn automatic car wash is a simple and quick way of washing the car, but it cannot reach every-where. Washing the car by hand is recommendedto achieve a good result, or to supplement auto-matic car washes with washing by hand.
NOTE
The car must only be washed by hand over the first few months. This is because the paintis more delicate when it is new.
IMPORTANT
Before driving the car into an automatic car wash, deactivate the functions for Automaticbraking when stationary (Auto Hold) andAutomatic application of parking brake. Ifthese functions are not deactivated, the brakesystem will jam when the car is stationary andthe car will not be able to move.
In car washes where the car is towed through with rolling wheels, the following applies:
1. Drive into the automatic car wash.
2. Deactivate the function for automatic braking
when stationary (Auto Hold) using the switch in the tunnel console.
3. Deactivate the function for automatic appli- cation of parking brake via the centre display.
4. Move the gear lever to position N.

||
MAINTENANCE AND SERVICE
* Option/accessory.
550 5. Switch off the engine by turning the start
knob in the tunnel console to STOP. Hold
the knob in STOP position for at least
4 seconds.
> The car is ready for the automatic car wash.
IMPORTANT
The system will automatically switch to P
mode unless the above step is followed. The wheels are locked in P mode, which they
should not be when putting the car through an automatic car wash.
High-pressure washingWhen using high-pressure washing, use sweep- ing movements and make sure that the nozzledoes not come closer than 30 cm to the surfaceof the car. Do not spray directly onto the locks.
Testing the brakesLightly depress the brake pedal now and thenwhen driving long distances in rain or slush. Theheat from the friction causes the brake linings towarm up and dry. Do the same thing after startingin very damp or cold weather.
WARNING
Always test the brakes after washing the car, including the parking brake, to ensure thatmoisture and corrosion do not attack thebrake linings and reduce braking perform-ance.
Wiper bladesAsphalt, dust and salt residue on wiper blades, as well as insects, ice etc. on the windscreen, impairthe service life of wiper blades. When cleaning, set the wiper blades in service position.
NOTE
Wash the wiper blades and windscreen regu- larly with lukewarm soap solution or carshampoo. Do not use any strong solvents.
Exterior plastic, rubber and trim components
A special cleaning agent available from Volvo dealers is recommended for the cleaning andcare of coloured plastic parts, rubber and trimcomponents, e.g. glossy trim mouldings. Whenusing such a cleaning agent the instructionsmust be followed carefully. The frames around the side windows, the car's roof rails and the door frames at the windows *
are produced in anodised aluminium. This means that they should only be washed using a cleaning agent with a pH value between 3.5 and 11.5.This is in order to avoid discolouration.
Parts that should be washed using a cleaning agent with a pH value between 3.5 and 11.5.
IMPORTANT
Avoid waxing and polishing on plastic and rubber. When using degreasant on plastic and rubber, only rub with light pressure if it is necessary.Use a soft washing sponge. Polishing glossy trim mouldings could wear away or damage the glossy surface layer. Polishing agent that contains abrasive must not be used.

MAINTENANCE AND SERVICE
}}
553
Interior plastic, metal and wood partsA fibrillated fibre or microfibre cloth, lightly mois- tened with water, available from Volvo dealers, isrecommended for cleaning interior parts and sur-faces. Do not scrape or rub stains. Never use strong stain removers.
SeatbeltsUse water and a synthetic detergent. A specialtextile cleaning agent is available from Volvodealers. Ensure that the seatbelt is dry beforeallowing it to retract.
Inlay mats and floor matRemove inlaid carpets for separate cleaning ofthe floor carpet and the inlaid carpets. Use a vac-uum cleaner to remove dust and dirt. Each inlaymat is secured with pins. Remove the inlay mat by taking hold of the inlay mat at each pin and lifting the mat straight up. Fit the inlay mat in place by pressing it in at each pin.
WARNING
Only use one inlaid mat at each seat, and check before setting off that the mat by thedriver's seat is firmly affixed and secured inthe pins so that it does not get caught adja-cent to and under the pedals.A special textile cleaner is recommended for stains on the floor mat after vacuuming. Floormats should be cleaned with agents recom-mended by Volvo dealers.
Related information
•
Cleaning the centre display (p. 553)
Cleaning the centre display
Dirt, stains and grease from fingers can affect the centre display's performance and readability.Clean the screen frequently with a microfibrecloth.
Home button for the centre display.
1. Turn off the centre display with a long press on the home button.
2. Wipe the screen with the microfibre cloth supplied or use another microfibre cloth of equivalent quality. The screen should bewiped with a clean and dry microfibre clothwith small circular movements. If necessary,lightly moisten the microfibre cloth with cleanwater.
3. Activate the display with a short press on the home button.

ALPHABETICAL INDEX
578Automatic car washes 549 Automatic engine stop
auto-stop 396
Automatic gearbox 390 trailer 428
Automatic relocking 242
Automatic speed limiter 281AUX jack for connecting media 448
Auxiliary heater 215
AWD, All Wheel Drive 405
B
Backrest front seat, adjusting 121, 122, 124
rear seat, lowering 130
Bag holder 228
Battery 388, 530 jump starting 388
maintenance 530
overload 415
start 530
support 533
symbols on the battery 533
warning symbols 533
Bi-Fuel introduction 54
BLIS 340, 342, 343 Bluetooth connect 447
connect car to Internet 464
phone 456
settings 463
Bonnet, opening 514
Book service and repair 506Brake assist after collision 408
Brake fluid grade 570
Brake functions 406
Brake light 143
Brakes 406 Anti-lock braking system, ABS 406
automatic when stationary 412
brake assist system, BAS 408
brake light 143
brake system 406
emergency brake lights 408
handbrake 409, 410, 411
bulbs, specifications 526C
Camera sensor 337
Car care 549 Leather upholstery 552
Car functions in centre display 47
Cargo area 226 electrical socket 220
lighting 146
mounting points 228
protective net 232
Cargo cover 230
Cargo grille 233
Car holiday 415
Car key battery low 257Car modem connect car to Internet 464
settings 468
Car status 506 Tyre pressure 487
Car upholstery 552
Car washing 549Catalytic converter Recovery 432
CD player 446
central locking 245