2017 MINI Hardtop 2 Door Owner's Manual

Adding1.Let the engine cool.2.Turn the lid of the coolant reservoir slightly
counterclockwise to allow any excess pres~
sure to dissipate, then open it.3.If the coolant is low, slowly add coolant up
to the specified level; do not overfill.4.Close cap.5.Have the cause of the coolant loss elimi~
nated as soon as possible.
Disposal
Comply with the relevant environmen~tal protection regulations when dispos~ ing of coolant and coolant additives.
Seite 217CoolantMOBILITY217
Online Edition for Part no. 01 40 2 915 044 - X/16

MaintenanceVehicle
features
and
op

dealer

Replacing
componentsVehicle
features
and
op

6.Insert and latch a new wiper blade in re~verse order.7.Fold down the wiper arm.
Rear
wiper
blade
1.Fold up and hold the wiper arm firmly.2.Turn the wiper blade all the way back.3.Push the wiper blade out of the fasteningby continuing to turn it all the way.4.Insert the new wiper blade by following the
steps in reverse order. The wiper blade
must engage audibly.5.Fold down the wiper arm.
Light/bulb
replacement
General
information
Lights
and
bulbs
Lights and bulbs make an essential contribution
to vehicle safety.
The manufacturer of the vehicle recommends that you have appropriate work performed by a dealer

Headlight
glass
Condensation can form on the inside of the ex~
ternal lights in cool or humid weather. When driving with the lights switched on, the conden~
sation evaporates after a short time. The head~ light glass does not need to be changed.
If despite driving with the lights switched on,increasing humidity forms, e. g. water droplets
in the lamp, the manufacturer of your vehicle
recommends having it checked by a dealer

5.Remove the bulb from the headlight hous~ing.6.Insert the new bulb and install the cover in
the reverse order.
Turn
signal
Follow the general instructions on lights and
bulbs, refer to page 221.
Bulbs: PW24W
With white turn signal lights: PWY24W
1.Turn the steering wheel.2.Turn the lid counterclockwise, arrow 1, and remove.3.Unscrew the inner lid counterclockwise,and remove it.4.Pull bulb holder out of the bulb housing; ifneeded, loosen it with small tilting move~ments if possible.5.Pull the bulb out of the fixture.6.Insert the new bulb and install the cover in
the reverse order.
Parking
lights/fog
lights/daytime
running
lights
Follow the general instructions on lights andbulbs, refer to page 221.
Bulbs:
'

'