2017 MERCEDES-BENZ SPRINTER warning light

[x] Cancel search: warning light

Page 68 of 286

MERCEDES-BENZ SPRINTER 2017  MY17 Operator’s Manual Electrical closing assist
If your vehicle is equipped with electrical closing
assist, you will require less force to close the
sliding door.
Electrical step
Important safety notes
!
Always observe the

Page 69 of 286

MERCEDES-BENZ SPRINTER 2017  MY17 Operator’s Manual XPull R-clips;on both rods :on the under-
side of the step out of their respective pins.
XRemove washers =and detach both rods :.
XFold rods:into the housing in the step.
XPush the step into its housi

Page 74 of 286

MERCEDES-BENZ SPRINTER 2017  MY17 Operator’s Manual Useful information
This Operator's Manual describes all models as
well as standard and optional equipment of your
vehicle that were available at the time of going
to print. Country-specific variat

Page 76 of 286

MERCEDES-BENZ SPRINTER 2017  MY17 Operator’s Manual while driving, the restraint systems may not
be able to provide the intended protection.
There is an increased risk of injury, possibly
even fatal.
Engage the driver's and front-passenger seatsso

Page 82 of 286

MERCEDES-BENZ SPRINTER 2017  MY17 Operator’s Manual Useful information
This Operator's Manual describes all models as
well as standard and optional equipment of your
vehicle that were available at the time of going
to print. Country-specific variat

Page 83 of 286

MERCEDES-BENZ SPRINTER 2017  MY17 Operator’s Manual The daytime running lamps function must be
activated using the on-board computer:
Rvehicles with steering wheel buttons
(Ypage 168)
Rvehicles without steering wheel buttons
(Ypage 161)
XTo switch on:t

Page 85 of 286

MERCEDES-BENZ SPRINTER 2017  MY17 Operator’s Manual The headlamp range control is used to adapt the
downward angle of the headlamp beams in
accordance with the load on your vehicle. The
cone of light from the headlamps changes if
seats are occupied or

Page 86 of 286

MERCEDES-BENZ SPRINTER 2017  MY17 Operator’s Manual Highbeam Assist
General notes
You can use this function to set the headlamps
to change between low beam and high beam
automatically. The system recognizes vehicles
with their lights on, either approac