Page 565 of 676

5657-2. Steps to take in an emergency
7
When trouble arises
LS600h/LS600hL_EE(OM50G20E)
■Warning message in radar cruise mode (if equipped)
In the following cases, the warning message may not be displayed even if vehicle-to-
vehicle distance decreases:
●When your vehicle and the vehicle ahead are traveling at the same speed or the
vehicle ahead is traveling more quickly than your vehicle
●When the vehicle ahead is traveling at a very low speed
●Immediately after cruise control speed is set
●At the instant the accelerator pedal is depressed
■The LKA (Lane-Keeping Assist) lane de parture warning function (if equipped)
In the following cases, the warning message will not be displayed even if a lane line is
crossed.
●When the vehicle speed deviates from the operating range of the LKA system
functions
●When the lane lines cannot be recognized
●When the steering wheel is turned as far as necessary to cause the vehicle to
change lanes
■System warning lights
The master warning light does not come on or flash in the following cases. Instead, a
separate system warning light will come on or flash along with the message shown
on the multi-information display.
●Malfunction of the brake system
The brake system warning light (red indicator) comes on. ( P. 555)
●Malfunction of the regenerative brake system, electronically controlled brake sys-
tem or electric parking brake
The brake system warning light (yellow indicator) comes on. ( P. 557)
●Malfunction of the ABS
The ABS warning light comes on. ( P. 556)
●Malfunction of the charging system
The charging system warning light comes on. ( P. 556)
●Indicates that a door or the trunk is not fully closed
The open door warning light comes on. ( P. 558)
●High engine coolant temperature
The needle of the engine coolant temperature gauge enters the red zone.
( P. 611)
Page 567 of 676
5677-2. Steps to take in an emergency
7
When trouble arises
LS600h/LS600hL_EE(OM50G20E)
●Stop the vehicle in a safe place on a hard, flat surface.
●Set the parking brake.
●Shift the shift lever to P.
●Stop the hybrid system.
●Turn on the emergency flashers. ( P. 546)
If you have a flat tire (vehicles with a spare tire)
Your vehicle is equipped with a spare tire. The flat tire can be replaced
with the spare tire.
For details about tires: P. 506
CAUTION
■If you have a flat tire
Do not continue driving with a flat tire.
Driving even a short distance with a flat tire can damage the tire and the wheel
beyond repair, which could result in an accident.
Before jacking up the vehicle
Page 568 of 676
5687-2. Steps to take in an emergency
LS600h/LS600hL_EE(OM50G20E)
Location of the spare tire, jack and tools
Parking brake release tool
Jack handle
Wheel nut wrench
Jack
Tools
Screwdriver
Spare tire
Towing eyelet
1
2
3
4
5
6
7
8
Page 573 of 676

5737-2. Steps to take in an emergency
7
When trouble arises
LS600h/LS600hL_EE(OM50G20E)
Remove the wheel ornament by
pushing from the reverse side.
6
CAUTION
■Replacing a flat tire
●Observe the following precautions.
Failure to do so may result in serious injury:
• Do not try to remove the wheel ornament by hand. Take due care in handling
the ornament to avoid unexpected personal injury.
• Do not touch the disc wheels or the area around the brakes immediately after
the vehicle has been driven.
After the vehicle has been driven the disc wheels and the area around the
brakes will be extremely hot. Touching these areas with hands, feet or other
body parts while changing a tire, etc. may result in burns.
●Failure to follow these precautions could cause the wheel nuts to loosen and the
tire to fall off, resulting in death or serious injury.
• Never use oil or grease on the wheel bolts or wheel nuts.
Oil and grease may cause the wheel nuts to be excessively tightened, leading
to bolt or disc wheel damage. In addition, the oil or grease can cause the
wheel nuts to loosen and the wheel may fall off, causing a serious accident.
Remove any oil or grease from the wheel bolts or wheel nuts.
• Have the wheel nuts tightened with a torque wrench to 140 N•m (14.3 kgf•m,
103 ft•lbf) as soon as possible after changing wheels.
• Do not attach a heavily damaged wheel ornament, as it may fly off the wheel
while the vehicle is moving.
• When installing a tire, only use wheel nuts that have been specifically designed
for that wheel.
• If there are any cracks or deformations in the bolt screws, nut threads or bolt
holes of the wheel, have the vehicle inspected by any authorized Lexus dealer
or repairer, or another duly qualified and equipped professional.
Page 579 of 676
5797-2. Steps to take in an emergency
7
When trouble arises
LS600h/LS600hL_EE(OM50G20E)
●Stop the vehicle in a safe place on a hard, flat surface.
●Set the parking brake.
●Shift the shift lever to P.
●Stop the hybrid system.
●Turn on the emergency flashers. ( P. 546)
●Check the degree of the tire damage.
A tire should only be repaired
with the emergency tire punc-
ture repair kit if the damage is
caused by a nail or screw passing
through the tire tread.
• Do not remove the nail or
screw from the tire. Removing
the object may widen the
opening and disenable emer-
gency repair with the kit.
• To avoid sealant leakage, move
the vehicle until the area of the
puncture, if known, is posi-
tioned at the top of the tire.
Before repairing the vehicle
Page 581 of 676
5817-2. Steps to take in an emergency
7
When trouble arises
LS600h/LS600hL_EE(OM50G20E)
*: Use of the jack (P. 571)
Location of the emergency tire puncture repair kit, jack and tools
Wheel nut wrench
Jack handle
Parking brake release tool
Towing eyelet
Jack*
Screwdriver
Tools
Emergency tire puncture repair
kit
1
2
3
4
5
6
7
8
Page 594 of 676

5947-2. Steps to take in an emergency
LS600h/LS600hL_EE(OM50G20E)
CAUTION
■When fixing the flat tire
●Stop your vehicle in a safe and flat area.
●Do not touch the wheels or the area around the brakes immediately after the
vehicle has been driven.
After the vehicle has been driven, the wheels and the area around the brakes may
be extremely hot. Touching these areas with hands, feet or other body parts may
result in burns.
●Connect the valve and hose securely with the tire installed on the vehicle.
●If the hose is not properly connected to the valve, air leakage may occur or seal-
ant may be sprayed out.
●If the hose comes off the valve while inflating the tire, there is a risk that the hose
will move abruptly due to air pressure.
●After inflation of the tire has completed, the sealant may splatter when the hose is
disconnected or some air is let out of the tire.
●Follow the operation procedure to repair th e tire. If the procedure is not followed,
the sealant may spray out.
●Keep back from the tire while it is being repaired, as there is a chance of it burst-
ing while the repair operation is being performed. If you notice any cracks or
deformation of the tire, turn off the comp ressor switch and stop the repair opera-
tion immediately.
●The kit may overheat if operated for a long period of time. Do not operate the
compressor continuously for more than 35 minutes.
●Parts of the kit become hot during operation. Be careful handling the kit during
and after operation. Do not touch the metal part around the connecting area
between the bottle and compressor. It will be extremely hot.
●Do not attach the vehicle speed warning sticker to an area other than the one
indicated. If the sticker is attached to an area where an SRS airbag is located,
such as the pad of the steering wheel, it may prevent the SRS air bag from operat-
ing properly.
Page 598 of 676

5987-2. Steps to take in an emergency
LS600h/LS600hL_EE(OM50G20E)
One of the following may be the cause of the problem:
●One or both of the 12-volt battery terminals may be disconnected.
●The 12-volt battery may be discharged. (P. 607)
Contact any authorized Lexus dealer or repairer, or another duly qualified and
equipped professional if the problem cannot be repaired, or if repair procedures
are unknown.
When the hybrid system does not start, the following steps can be used as
an interim measure to start the hybrid system if the power switch is func-
tioning normally:
Turn the power switch to ON mode ( P. 248) and check that the
parking brake is set.
Shift the shift lever to P.
Turn the power switch to ACCESSORY mode.
Press and hold the power switch for about 15 seconds while depressing
the brake pedal firmly.
Even if the hybrid system can be star ted using the above steps, the system
may be malfunctioning. Have the vehicle inspected by any authorized
Lexus dealer or repairer, or another duly qualified and equipped profes-
sional.
The interior lights and headlights do not turn on, or the horn does
not sound.
Emergency start function
1
2
3
4