2017 LEXUS LS600H brake

5997-2. Steps to take in an emergency
7
When trouble arises
LS600h/LS600hL_EE(OM50G20E)
●Shift the shift lever to P.
●Turn the power switch off.
●Check that the parking brake indicator is off.
●Chock the tires.
Vehicles with a spare tire
Take out the parking brake release tool and the screwdriver from the
trunk. ( P. 568)
Replace the screwdriver head
with the parking brake release
tool.
Take out the spare tire. ( P. 571)
If the parking brake cannot be released
In the event that the 12-volt battery is discharged or switch operation
does not release the parking brake, the parking brake can be released
manually using the procedure below. This procedure should be per-
formed only if necessary, su ch as in an emergency.
If the switch cannot be operated ev en when the 12-volt battery is nor-
mal, the parking brake system may be malfunctioning. Have the vehicle
inspected by any authorized Lexus dealer or repairer, or another duly
qualified and equipped professional immediately.
Before releasing the parking brake manually
Releasing the parking brake manually
1
2
3

6007-2. Steps to take in an emergency
LS600h/LS600hL_EE(OM50G20E)
Remove the plug.
Insert the tool and press it down
firmly while turning it
counterclockwise until it stops.
Vehicles without a spare tire
Take out the parking brake release tool and the screwdriver from the
trunk. ( P. 581)
Check that the flathead end of
the screwdriver is exposed.
If the Phillips end is exposed, reinsert
the screwdriver shaft so the flathead
end is exposed.
4
5
1
Phillips end
Flathead end
2

6027-2. Steps to take in an emergency
LS600h/LS600hL_EE(OM50G20E)
Replace the screwdriver head
with the parking brake release
tool.
Insert the tool and press it down
firmly while turning it
counterclockwise until it stops.
■When installing the tool tray clips (vehicles without a spare tire)
■Manual operation of the parking brake
The parking brake cannot be set manually.
7
8
CAUTION
■When releasing the parking brake manually
●Shift the shift lever to P, turn the power switch off and chock the tires.
Failure to do so may cause the vehicle to move, resulting in an accident.
●Turn the power switch off and check that the parking brake indicator is off.
Failure to do so may cause the system to operate and turn the inserted parking
brake release tool, resulting in an injury.
Install the clips as shown in the illustration.

6057-2. Steps to take in an emergency
7
When trouble arises
LS600h/LS600hL_EE(OM50G20E)
Ensure that the shift lever is in P and depress the brake pedal.
Touch the Lexus emblem side of
the electronic key to the power
switch.
If any of the doors is opened or closed
after the key was touched to the
switch to start the vehicle, an alarm
will sound to indicate that the start
function cannot detect the key.
Press the power switch within 10 seconds of the buzzer sounding,
keeping the brake pedal depressed.
In the event that the hybrid system still cannot be started, contact any
authorized Lexus dealer or repairer, or another duly qualified and
equipped professional.
■Stopping the hybrid system
Shift the shift lever to P and press the power switch as you normally do when stop-
ping the hybrid system.
■Replacing the key battery
As the above procedure is a temporary measure, it is recommended that the elec-
tronic key battery be replaced immediately when the battery is depleted. ( P. 532)
■Alarm (if equipped)
Using the mechanical key to lock the doors will not set the alarm system.
If a door is unlocked using the mechanical key when the alarm system is set, the
alarm may be triggered.
■Changing power switch modes
Within 10 seconds of the buzzer sounding, release the brake pedal and press the
power switch.
The hybrid system does not start and modes will be changed each time the switch is
pressed. ( P. 248)
Starting the hybrid system
1
2
3

6167-2. Steps to take in an emergency
LS600h/LS600hL_EE(OM50G20E)
Stop the hybrid system. Set the parking brake and shift the shift lever to
P.
Remove the mud, snow or sand from around the rear wheels.
Place wood, stones or some other material under the rear wheels to
help provide traction.
Restart the hybrid system.
Shift the shift lever to D or R and release the parking brake. Then, while
exercising caution, depress the accelerator pedal.
■When it is difficult to free the vehicle
If the vehicle becomes stuck
Carry out the following procedures if the tires spin or the vehicle
becomes stuck in mud, dirt or snow:
Press to turn off TRC.
1
2
3
4
5

6308-1. Specifications
LS600h/LS600hL_EE(OM50G20E)
*: Minimum pedal clearance when depressed with a force of 500 N (51 kgf, 112 lbf)
while the hybrid system is operating.
When performing the brake pedal inspection, also be sure to check that the
brake system warning light is not illuminated when the hybrid system is operating
(If the brake system warning light is illuminated, refer to P. 555).
Brakes
Pedal clearance*147 mm (5.8 in.) Min.
Pedal free play1.0 - 2.0 mm (0.04 - 0.08 in.)
Fluid typeSAE J1703 or FMVSS No.116 DOT 3 or,
SAE J1704 or FMVSS No.116 DOT 4
Steering
Free playLess than 30 mm (1.2 in.)
Tires and wheels
Tire size245/45R19 102Y
Tire inflation pres-
sure
(Recommended
cold tire inflation
pressure)
Vehicle speedFront wheel
kPa (kgf/cm2 or
bar, psi)
Rear wheel
kPa (kgf/cm2 or
bar, psi)
More than 210 km/h
(132 mph)290 (2.9, 42)290 (2.9, 42)
210 km/h
(132 mph) or less250 (2.5, 36)250 (2.5, 36)
Wheel size19  8 J
Wheel nut torque140 N•m (14.3 kgf•m, 103 ft•lbf)

6468-2. Customization
LS600h/LS600hL_EE(OM50G20E)
■Vehicle customization
●When the smart entry & start system is off, the entry unlock function cannot be cus-
tomized.
●When the doors remain closed after unlocking the doors and the timer activated
automatic door lock function activates, signals will be generated in accordance
with the operational signal (Emergency flashers) function settings.
■When customizing using the Remote Touch
Stop the vehicle in a safe place, apply the parking brake, and shift the shift lever to P.
Also, to prevent 12-volt battery discharge, leave the hybrid system operating while
customizing the features.
CAUTION
■During customization
As the hybrid system needs to be operating during customization, ensure that the
vehicle is parked in a place with adequate ventilation. In a closed area such as a
garage, exhaust gases including harmful carbon monoxide (CO) may collect and
enter the vehicle. This may lead to death or a serious health hazard.
NOTICE
■During customization
To prevent 12-volt battery discharge, ensure that the hybrid system is operating
while customizing features.

650What to do if... (Troubleshooting)
LS600h/LS600hL_EE(OM50G20E)
●Did you press the power switch while firmly depressing the
brake pedal? ( P. 247)
●Is the shift lever in P? (P. 247)
●Is the electronic key anywhere detectable inside the vehicle?
( P. 153)
●Is the steering wheel unlocked? (P. 249)
●Is the electronic key battery weak or depleted?
In this case, the hybrid system can be started in a temporary
way. ( P. 605)
●Is the 12-volt battery discharged? (P. 607)
●Is the power switch in ON mode?
If you cannot release the shift lever by depressing the brake
pedal with the power switch in ON mode ( P. 259)
●It is locked automatically to prevent theft of the vehicle.
( P. 249)
If you think something is wrong
The hybrid system does not start
The shift lever cannot be shifted from P even if you depress the
brake pedal
The steering wheel cannot be turned after the hybrid system is
stopped