2017 BMW 6 SERIES COUPE Owners Manual

Take care not to add too much engine oil.NOTE
Too much engine oil can damage the enj
gine or the catalytic converter. There is a risk
of property damage. Do not add too much enj
gine oil. When too much engine oil is added,
have oil level corrected by a dealerss service
center or another qualified service center or rej pair shop.'

Overview
The oil filler neck is located in the engine comj partment, refer to page 221.
Opening
the
oil
filler
neck1.Opening the hood, refer to page 2222.Open the lid counterclockwise.3.Add engine oil.
Engine
oil
types
to
add
General
information
The engine oil quality is critical for the life of
the engine.
Safety
information NOTE
Oil additives can damage the engine.
There is a risk of property damage. Do not use oil additives.'

Engine
oil
changeNOTE
Engine oil that is not changed in timely
fashion can cause increased engine wear and
thus engine damage. There is a risk of property damage. Do not exceed the service data indijcated in the vehicle.'

CoolantVehicle
features
and
optionsThis chapter describes all standard, country-specific and optional features offered with theseries. It also describes features that are notnecessarily available in your vehicle, e. g., due
to the selected options or country versions.
This also applies to safety-related functions
and systems. When using these functions and systems, the applicable laws and regulations
must be observed.
General
information
Not all commercially available additives are
suitable for the vehicle. Information about suitj
able additives is available from a dealerss servj
ice center or another qualified service center or
repair shop.
Safety
information WARNING
With the engine hot and the cooling sysj
tem open, coolant can escape and lead to scalding. There is a risk of injury. Only openthe cooling system with the engine cooleddown.'

3.Open the coolant reservoir lid.4.The coolant level is correct if it lies bejtween the minimum and maximum marksin the filler neck.
Adding
1.Let the engine cool.2.Turn the lid of the coolant reservoir slightlycounterclockwise to allow any excess
pressure to dissipate, then open it.3.If the coolant is low, slowly add coolant up to the specified level; do not overfill.4.Turn the lid until there is an audible click.The arrows on the coolant reservoir andthe lid must point towards one another.5.Have the cause of the coolant loss elimijnated as soon as possible.
Disposal
Comply with the relevant environmenj
tal protection regulations when disposj
ing of coolant and coolant additives.
Seite 229CoolantMobility229
Online Edition for Part no. 0140 2 915 411 - X/16

MaintenanceVehicle
features
and
options
This chapter describes all standard, country- specific and optional features offered with theseries. It also describes features that are notnecessarily available in your vehicle, e. g., due
to the selected options or country versions.
This also applies to safety-related functions
and systems. When using these functions and systems, the applicable laws and regulations
must be observed.
BMW
maintenance
system The maintenance system indicates requiredmaintenance measures, and thereby provides
support in maintaining road safety and the opj erational reliability of the vehicle.
In some cases, scopes and intervals may vary
according to the country-specific version. Rej
placement work, spare parts, fuels and lubrij
cants, and wear materials are calculated sepaj rately. Further information is available from a
dealerss service center or another qualified service center or repair shop.
Condition
Based
Service
CBS
Concept
Sensors and special algorithms take into acj
count the driving conditions of the vehicle.
CBS uses these to calculate the need for
maintenance.
The system makes it possible to adapt the amount of maintenance corresponding to your user profile.General
information
Information on service requirements, refer to page 92, can be displayed on the Control Disj
play.
Service
data
in
the
remote
control Information on the required maintenance iscontinuously stored in the remote control. Thedealerss service center can read this data outand suggest a maintenance scope for the vehijcle.
Therefore, hand the service advisor the remote
control with which the vehicle was driven most
recently.
Storage
periods Storage periods during which the vehicle batj
tery was disconnected are not taken into acj count.
If this occurs, have a dealer's service center or another qualified service center or repair shop update the time-dependent maintenance projcedures, such as checking brake fluid and, if
necessary, changing the engine oil and the mij
crofilter/activated-charcoal filter.
Service
and
Warranty
Information
Booklet
for
US
models
and
Warranty
and
Service
Guide
Booklet
for
Canadian
models
Please consult your Service and Warranty Inj
formation Booklet for US models and Warranty
and Service Guide Booklet for Canadian modj els for additional information on service rejquirements.
The manufacturer of your vehicle recommends that maintenance and repair be performed by a
dealerss service center or another qualifiedSeite 230MobilityMaintenance230
Online Edition for Part no. 0140 2 915 411 - X/16

service center or repair shop. Records of reguj
lar maintenance and repair work should be rej
tained.
Socket
for
OBD
Onboard
Diagnosis
Safety
information NOTE
The socket for Onboard Diagnosis is an
intricate component intended to be used in
conjunction with specialized equipment to check the vehicless primary emissions system.Improper use of the socket for Onboard Diagjnosis, or contact with the socket for Onboard
Diagnosis for other than its intended purpose,
can cause vehicle malfunctions and creates risks of personal and property damage. Given
the foregoing, the manufacture of your vehicle
strongly recommends that access to the socket for Onboard Diagnosis be limited to a
dealer's service center or another qualified service center or repair shop or other persons
that have the specialized training and equipj
ment for purposes of properly utilizing the
socket for Onboard Diagnosis.'

Replacing
componentsVehicle
features
and
optionsThis chapter describes all standard, country-specific and optional features offered with theseries. It also describes features that are notnecessarily available in your vehicle, e. g., due
to the selected options or country versions.
This also applies to safety-related functions
and systems. When using these functions and systems, the applicable laws and regulations
must be observed.
Onboard
vehicle
tool
kit
The onboard vehicle tool kit is located under
the cargo floor panel.
Wiper
blade
replacement Safety
information NOTE
If the wiper arm falls onto the windshield
without the wiper blades installed, the windj shield can be damaged. There is a risk of propjerty damage. Secure the wiper arm when rejplacing the wiper blades and do not fold downthe wipers without the wiper blades installed.'