2017 BMW 5 SERIES GRAN TURISMO Owners Manual

Interior motion sensor and tilt alarm sensor
are not active, as doors, hood, or tailgate are not correctly closed. Correctly closedaccess points are secured.
When the still open access points are
closed, interior motion sensor and tilt alarm
sensor will be switched on.'yThe indicator lamp goes out after unlockj
ing:
The vehicle has not been tampered with.'yThe indicator lamp flashes after unlocking
until the engine ignition is switched on, but no longer than approx. 5 minutes:
An alarm has been triggered.
Tilt
alarm
sensor The tilt of the vehicle is monitored.
The alarm system responds in situations such
as attempts to steal a wheel or when the vehij
cle is towed.
Interior
motion
sensor
The windows and the glass sunroof must be
closed for the system to function properly.
Avoiding
unintentional
alarms
General
information
The tilt alarm sensor and interior motion senj
sor can trigger an alarm, although no unauthorj ized action occurred.
Possible situations for an unwanted alarm:
'yIn automatic vehicle washes.'yIn duplex garages.'yDuring transport on trains carrying vehij
cles, at sea or on a trailer.'yWith animals in the vehicle.
The tilt alarm sensor and the interior motion sensor can be switched off in such situations.
Switching
off
the
tilt
alarm
sensor
and
interior
motion
sensor
Press the remote control button again
within 10 seconds as soon as the vehicle
is locked.
The indicator lamp lights up for approx. 2 secj
onds and then continues to flash.
The tilt alarm sensor and interior motion senj
sor are turned off until the vehicle is locked
again.
Switching
off
the
alarm'yUnlock the vehicle with the remote control or switch on the ignition, if needed through
emergency detection of remote control, rej fer to page 37.'yWith Comfort Access:
If you are carrying the remote control on
your person, grasp the door handle on the driver's or front passenger door comj
pletely.
Power
windows
Safety
information WARNING
When operating the windows, body parts
and objects can be jammed. There is a risk of injury or risk of property damage. Make surethat the area of movement of the windows isclear during opening and closing.'

'yEngaging selector lever position N.'yUsing vehicle equipment.
There is a risk of accidents or injuries. Do notleave children or animals unattended in the vej
hicle. Take the remote control with you when exiting and lock the vehicle.'

Safety
switch
General
information
The following functions can be locked simultaj neously, using the switch:'yOpening and closing of the rear windowsusing the switches in the rear.'yOperation of the roller sunblinds using the
switches in the rear.'yAdjustment of the power rear seats.'yAdjustment of the power head restraints in the rear.
If an accident of a certain severity occurs, thesafety function is switched off automatically.
Switching
on
and
off Press button.
The LED lights up if the safety funcj
tion is switched on.
Roller
sunblinds
General
information The safety switch in the driver's door can be
used to prevent children, for example, from opj
erating the roller sunblinds using the switches
in the rear.
Press the safety switch in the driver's door. The LED lights up if the safety function is
switched on.
If you are no longer able to move the roller sunj blinds after having activated them consecuj tively a number of times, the system is blockedfor a limited time to prevent overheating. Letthe system cool.
The roller sunblinds cannot be moved at low interior temperatures.
Driver's
door
controls
Roller
sunblinds
for
rear
side
windows
Press button.
Rear
door
controls
Roller
sunblinds
for
side
windows Press button.
The roller blind can only be extended or rej tracted when the side window is closed.
Raising
and
lowering
the
roller
sunblinds
together
Press button.
Seite 51Opening
and
closingControls51
Online Edition for Part no. 01 40 2 972 554 - VI/16

Panoramic
glass
sunroof
General
information The glass sunroof and the sliding visor can be
operated together or separately using the
same switch.
The glass sunroof is operational when the ignij
tion is switched on.
Safety
information WARNING
Body parts can be jammed when operatj
ing the glass sunroof. There is a risk of injury.
Make sure that the area of movement of the
glass sunroof is clear during opening and closj ing.'

The sliding visor opens automatically. If thesliding visor is already fully open, the glasssunroof opens automatically.
The glass sunroof closes automatically. If the glass sunroof is already closed or in the
tilted position, the sliding visor closes auj
tomatically.
Pressing the switch upward stops the moj tion.
Opening/closing
the
glass
sunroof
and
sliding
visor
together
Briefly press the switch twice insuccession in the desired direcj tion past the resistance point.
The glass sunroof and sliding vij
sor move together. Pressing the
switch upward stops the motion.
Convenient opening via the remote control, rej
fer to page 35.
Closing by means of Comfort Access, refer to page 39.
Comfort
position
If the glass sunroof is not completely opened
automatically, the comfort position has been
attained. In this position the wind noises in the
interior are the least.
If desired, continue the movement by pressing
the switch.
Pinch
protection
system
General
information If the closing force when closing the glass sunj
roof exceeds a certain value, the closing movej ment is stopped, beginning at approximately
the middle of the opening in the roof, or from
the tilted position during closing. The glass
sunroof reopens slightly.
Closing
from
the
open
position
without
pinch
protection
If there is an external danger, proceed as folj
lows:1.Press the switch forward beyond the rej
sistance point and hold.
The pinch protection is limited and the
glass sunroof reopens slightly if the closing
force exceeds a certain threshold.2.Press the switch forward again beyond the resistance point and hold until the glass
sunroof closes without jam protection. Make sure that the closing area is clear.
Closing
from
the
raised
position
without
pinch
protection
If there is an external danger,
push the switch forward past the
resistance point and hold it.
The glass sunroof closes withj
out jam protection.
Initializing
after
a
power
interruption
General
information After a power failure during the opening orclosing process, the glass sunroof can only be
operated to a limited extent.
The system can be initialized when the vehicle
is stationary and the engine is running.
During the initialization, the glass sunroof
closes without jam protection.
Make sure that the closing area is clear.
Seite 53Opening
and
closingControls53
Online Edition for Part no. 01 40 2 972 554 - VI/16

Initializing
the
systemPress the switch up and hold ituntil the initialization is comj
plete:
Initialization begins within
15 seconds and is completed
when the glass sunroof and sliding visor are completely closed.Seite 54ControlsOpening
and
closing54
Online Edition for Part no. 01 40 2 972 554 - VI/16

SettingsVehicle
features
and
options
This chapter describes all standard, country- specific and optional features offered with theseries. It also describes features that are notnecessarily available in your vehicle, e. g., due
to the selected options or country versions.
This also applies to safety-related functions
and systems. When using these functions and systems, the applicable country provisions
must be observed.
Sitting
safely
The ideal seating position meeting the needs
of the occupants can make a vital contribution to relaxed, fatigue-free driving.
The seating position plays an important role in
an accident in combination with:'ySafety belts, refer to page 60.'yHead restraints, refer to page 62.'yAirbags.
Front
seats
Safety
information WARNING
Seat adjustments while driving can lead
to unexpected movements of the seat. Vehicle
control could be lost. There is a risk of an accij
dent. Only adjust the seat on the driver's side
when the vehicle is stationary.'

Seat
tilt
Move switch up or down.
Forward/backward
Pull the lever and slide the seat in the desired direction.
After releasing the lever, move the seat forj
ward or back slightly making sure it engages
properly.
Height
Push switch up or down.
Backrest
tilt
Move switch forward or backward. Electrically
adjustable
seats
Overview
1Thigh support2Forward/back, height, tilt3Shoulder support4Backrest width5Lumbar support6Backrest, head restraint
General
information
The seat setting for the driver's seat is stored
for the profile currently used. When the vehicle
is unlocked via the remote control, the position
is automatically retrieved if the Function is actij
vated for this purpose.
Seite 56ControlsSettings56
Online Edition for Part no. 01 40 2 972 554 - VI/16