2016 YAMAHA SR400 Owners Manual

Periodic maintenance and adjustment
6-11
1
2
3
4
5
6
7
8
9
10
11
12
13
14
TIP
Skip steps 6–8 if the oil filter element is
not being replaced. 6. Remove the oil filter element cover by removing the bolts.
7. Remove and replace the oil filter element and O-rings.
TIP
Make sure that the O-rings are properly
seated. 8. Install the oil filter element cover by
installing the bolts, and then tight-
en the bolts to the specified torque.
9. Install the oil filter element drain bolt, and then tighten the bolt to the
specified torque.
10. Install the oil filter element cover bleed bolt and its gasket, and then
tighten the bolt to the specified
torque.
11. Install the engine oil drain bolts and their new gasket, and then
tighten the bolts to the specified
torques.
1. Engine oil drain bolt (oil tank)
2. Gasket
1. Oil filter element cover bolt
21
1
1. Oil filter element cover
2. O-ring
3. Oil filter element
Tightening torque:Oil filter element cover bolt: 10 Nm (1.0 m·kgf, 7.2 ft·lbf)
Tightening torque: Oil filter element drain bolt: 10 Nm (1.0 m·kgf, 7.2 ft·lbf)
Tightening torque: Oil filter element cover bleed bolt: 5 Nm (0.5 m·kgf, 3.6 ft·lbf)
2
1
3
2RD-28199-E1.book 11 ページ ２０１５年９月３日　木曜日　午後３時４２分

Periodic maintenance and adjustment
6-12
1
2
3
4
5
6
7
8
9
10
11
12
13
14 12. Add the specified amount of the
recommended engine oil, and then
install and tighten the oil filler cap.
TIP
Be sure to wipe off spilled oil on any
parts after the engine and exhaust sys-
tem have cooled down.
NOTICE
ECA11621
In order to prevent clutch slip-
page (since the engine oil also
lubricates the clutch), do not
mix any chemical additives. Do
not use oils with a diesel speci-
fication of “CD” or oils of a high-
er quality than specified. In
addition, do not use oils labeled
“ENERGY CONSERVING II” or
higher.
Make sure that no foreign mate-
rial enters the crankcase.
13. Start the engine, and then let it idle for several minutes while checking
it for oil leakage. If oil is leaking, im-
mediately turn the engine off and
check for the cause.
14. Turn the engine off, and then check the oil level and correct it if necessary.
NOTICE
ECA11232
After changing the engine oil, make
sure to check the oil pressure as de-
scribed below.
Loosen the bleed bolt.
Start the engine and keep it
idling until oil flows out. If no oil
comes out after one minute,
turn the engine off immediately
so it will not seize. If this occurs,
have a Yamaha dealer repair the
vehicle.
After checking the oil pressure,
tighten the bleed bolt to the
specified torque.
Tightening torques:
Engine oil drain bolt (crankcase):
30 Nm (3.0 m·kgf, 22 ft·lbf)
Engine oil drain bolt (oil tank): 16 Nm (1.6 m·kgf, 12 ft·lbf)
Recommended engine oil: See page 8-1.
Oil quantity:
Oil change:2.00 L (2.11 US qt, 1.76 Imp.qt)
With oil filter removal:
2.10 L (2.22 US qt, 1.85 Imp.qt)
1. Bleed bolt
Tightening torque:Bleed bolt:
18 Nm (1.8 m·kgf, 13 ft·lbf)
1
2RD-28199-E1.book 12 ページ ２０１５年９月３日　木曜日　午後３時４２分

Periodic maintenance and adjustment
6-13
1
2
3
4
5
6
7
8
9
10
11
12
13
14
EAU52031
Replacing the air filter element
The air filter element should be re-
placed at the intervals specified in the
periodic maintenance and lubrication
chart. Replace the air filter element
more frequently if you are riding in un-
usually wet or dusty areas.
To replace the air filter element 1. Remove panel A. (See page 6-7.)
2. Remove the air filter case cover by removing the screws.
3. Pull the air filter element out.
4. Insert a new air filter element into the air filter case. NOTICE: Make
sure that the air filter element is
properly seated in the air filter
case. The engine should never
be operated without the air filter element installed, otherwise the
piston(s) and/or cylinder(s) may
become excessively worn.[ECA10482]
5. Install the air filter case cover by in-
stalling the screws.
6. Install the panel.
1. Screw
2. Air filter case cover
1. Air filter element
1
2
1
1
2RD-28199-E1.book 13 ページ ２０１５年９月３日　木曜日　午後３時４２分

Periodic maintenance and adjustment
6-14
1
2
3
4
5
6
7
8
9
10
11
12
13
14
EAU44735
Checking the engine idling
speed
Check the engine idling speed and, if
necessary, have it corrected by a
Yamaha dealer.
EAU21386
Checking the throttle grip free
play
Measure the throttle grip free play as
shown.
Periodically check the throttle grip free
play and, if necessary, have a Yamaha
dealer adjust it.
Engine idling speed: 1200–1400 r/min
1. Throttle grip free play
Throttle grip free play:3.0–5.0 mm (0.12–0.20 in)
1
2RD-28199-E1.book 14 ページ ２０１５年９月３日　木曜日　午後３時４２分

Periodic maintenance and adjustment
6-15
1
2
3
4
5
6
7
8
9
10
11
12
13
14
EAU21402
Valve clearance
The valve clearance changes with use,
resulting in improper air-fuel mixture
and/or engine noise. To prevent this
from occurring, the valve clearance
must be adjusted by a Yamaha dealer
at the intervals specified in the periodic
maintenance and lubrication chart.
EAU70280
Tires
Tires are the only contact between the
vehicle and the road. Safety in all con-
ditions of riding depends on a relatively
small area of road contact. Therefore, it
is essential to maintain the tires in good
condition at all times and replace them
at the appropriate time with the speci-
fied tires.
Tire air pressure
The tire air pressure should be checked
and, if necessary, adjusted before each
ride.
WARNING
EWA10504
Operation of this vehicle with im-
proper tire pressure may cause se-
vere injury or death from loss of
control.
The tire air pressure must be
checked and adjusted on cold
tires (i.e., when the temperature
of the tires equals the ambient
temperature).
The tire air pressure must be ad-
justed in accordance with the
riding speed and with the total
weight of rider, passenger, car-
go, and accessories approved
for this model.
2RD-28199-E1.book 15 ページ ２０１５年９月３日　木曜日　午後３時４２分

Periodic maintenance and adjustment
6-16
1
2
3
4
5
6
7
8
9
10
11
12
13
14
WARNING
EWA10512
Never overload your vehicle. Opera-
tion of an overloaded vehicle could
cause an accident.
Tire inspection
The tires must be checked before each
ride. If the center tread depth reaches
the specified limit, if the tire has a nail or
glass fragments in it, or if the sidewall is
cracked, have a Yamaha dealer re-
place the tire immediately.
TIP
The tire tread depth limit may differ
from country to country. Always comply
with the local regulations.
WARNING
EWA10572
Have a Yamaha dealer replace
excessively worn tires. Besides
being illegal, operating the mo-
torcycle with excessively worn
tires decreases riding stability
and can lead to loss of control.
The replacement of all wheel-
and brake-related parts, includ-
ing the tires, should be left to a
Yamaha dealer, who has the
necessary professional knowl-
edge and experience.
It is not recommended to patch
a punctured tube. If unavoid-
able, however, patch the tube
very carefully and replace it as
soon as possible with a high-
quality product.
Ride at moderate speeds after
changing a tire since the tire
surface must first be “broken
in” for it to develop its optimal
characteristics.
Tire information
This model is equipped with tube tires.
Tires age, even if they have not been
used or have only been used occasion-
ally. Cracking of the tread and sidewall
rubber, sometimes accompanied by
carcass deformation, is an evidence of
Tire air pressure (measured on cold
tires): Up to 90 kg (198 lb) load:Front:175 kPa (1.75 kgf/cm
2, 25 psi)
Rear: 200 kPa (2.00 kgf/cm
2, 29 psi)
90 kg (198 lb) to maximum load:
Front:200 kPa (2.00 kgf/cm
2, 29 psi)
Rear:
225 kPa (2.25 kgf/cm
2, 33 psi)
Maximum load*: 150 kg (331 lb)
* Total weight of rider, passenger, car- go and accessories
1. Tire sidewall
2. Tire tread depth
Minimum tire tread depth (front and
rear): 1.6 mm (0.06 in)
2RD-28199-E1.book 16 ページ ２０１５年９月３日　木曜日　午後３時４２分

Periodic maintenance and adjustment
6-17
1
2
3
4
5
6
7
8
9
10
11
12
13
14
ageing. Old and aged tires shall be
checked by tire specialists to ascertain
their suitability for further use.
WARNING
EWA10462
The front and rear tires should be of
the same make and design, other-
wise the handling characteristics of
the vehicle may be different, which
could lead to an accident.
After extensive tests,
only the tires list-
ed below have been approved for this
model by Yamaha.
EAU21944
Spoke wheels
WARNING
EWA10611
The wheels on this model are not de-
signed for use with tubeless tires.
Do not attempt to use tubeless tires
on this model.
To maximize the performance, durabil-
ity, and safe operation of your motorcy-
cle, note the following points regarding
the specified wheels.
The wheel rims should be checked
for cracks, bends, warpage or oth-
er damage, and the spokes for
looseness or damage before each
ride. If any damage is found, have
a Yamaha dealer replace the
wheel. Do not attempt even the
smallest repair to the wheel. A de-
formed or cracked wheel must be
replaced.
The wheel should be balanced
whenever either the tire or wheel
has been changed or replaced. An
unbalanced wheel can result in
poor performance, adverse han-
dling characteristics, and a short-
ened tire life.
Front tire: Size:90/100-18M/C 54S
Manufacturer/model:
BRIDGESTONE/BT-45F
Rear tire: Size:
110/90-18M/C 61S
Manufacturer/model: BRIDGESTONE/BT-45R
2RD-28199-E1.book 17 ページ ２０１５年９月３日　木曜日　午後３時４２分

Periodic maintenance and adjustment
6-18
1
2
3
4
5
6
7
8
9
10
11
12
13
14
EAU48293
Adjusting the clutch lever free
play
Measure the clutch lever free play as
shown.
Periodically check the clutch lever free
play and, if necessary, adjust it as fol-
lows. 1. Slide the rubber cover back at the clutch lever.
2. Loosen the locknut.
3. To increase the clutch lever free play, turn the clutch lever free play
adjusting bolt in direction (a). To
decrease the clutch lever free play,
turn the adjusting bolt in direction
(b).
4. Tighten the locknut and then slide the rubber cover to its original po-
sition.
TIP
If the specified free play cannot be ob-
tained as described above or if the
clutch does not operate correctly, have
a Yamaha dealer check the internal
clutch mechanism.
1. Clutch lever free play
2. Rubber cover
3. Locknut
4. Clutch lever free play adjusting bolt
Clutch lever free play:5.0–10.0 mm (0.20–0.39 in)
324
(a)
(b)
1
2RD-28199-E1.book 18 ページ ２０１５年９月３日　木曜日　午後３時４２分