2016 NISSAN NOTE Display

AV
SYSTEMAV-135
< SYSTEM DESCRIPTION > [NAVIGATION]
C
D
E
F
G H
I
J
K L
M B A
O P
SYSTEM
System DescriptionINFOID:0000000012433013
SYSTEM DIAGRAM
AUDIO SYSTEM
The audio system consists of the following component:
• AV control unit
• Front door speakers
• Rear door speakers
• Steering wheel audio control switches
• USB interface and AUX in jack
• Antenna base (antenna amp. and satellite antenna)
• Rod antenna
When the audio system is on, AM/FM signals received by the rod antenna are amplified by the antenna amp.
and sent to the AV control unit. The AV control unit then sends audio signals to the front door speakers and
rear door speakers.
Refer to Owner's Manual for audio system operating instructions.
NAVIGATION SYSTEM
Description
• The navigation system can be operated by control panel of the AV control unit and display (touch panel) of
the AV control unit.
• Guide sound during the operation of the navigation system is output from AV control unit to front speakers.
AWNIA4136GB
Revision: August 2015 2016 Versa Note

cardiagn.com

AV-136
< SYSTEM DESCRIPTION >[NAVIGATION]
SYSTEM
• AV control unit calculates the vehicle location based
on the signals from GYRO (angle speed sensor), vehi-
cle sensor, and GPS satellite, as well as the map data from map SD-card. The vehicle location is displayed
on the AV control unit.
POSITION DETECTION PRINCIPLE
The navigation system periodically calculates the vehicle's current position according to the following three
signals:
• Travel distance of the vehicle as determined by the vehicle speed sensor
• Turning angle of the vehicle as determined by the gyroscope (angular velocity sensor)
• Direction of vehicle travel as determined by the GPS antenna (GPS information)
The current position of the vehicle is then identified by comparing the calculated vehicle position with map data
read from the map SD-card (map-matching), and indica ted on the screen as a vehicle mark. More accurate
data is judged and used by comparing vehicle position detection results found by the GPS with the result by
map-matching.
The current vehicle position will be calculated by detecting the dis-
tance the vehicle moved from the previous calculation point and its
direction.
• Travel distance Travel distance calculations are based on the vehicle speed sen-
sor input signal. Therefore, the calculation may become incorrect
as the tires wear down. To prevent this, an automatic distance cor-
rection function has been adopted.
• Travel direction
Change in the travel direction of the vehicle is calculated by a gyro-
scope (angular velocity sensor) and a GPS antenna (GPS informa-
tion). They have both advantages and disadvantages.
More accurate traveling direction is detected becaus e priorities are set for the signals from these two
devices according to the situation.
MAP-MATCHING
Map-matching compares a current location detected by the method
in the “Location Detection Princi ple” with a road map data from map
SD-card.
NOTE:
The road map data is based on data stored in the map SD-card.
The vehicle position may not be corrected under the foll owing circumstances and after driving for a certain
time when GPS information is difficult to receive. In this case, the vehicle mark on the display must be cor-
rected manually.
SEL684V
Type Advantage Disadvantage
Gyroscope
(angular velocity sensor) Can detect the vehicle's turning angle quite
accurately. Direction errors
may accumulate when vehicle is
driven for long distances without stopping.
GPS antenna
(GPS information) Can detect the vehicle's travel direction
(North/South/East/West). Correct direction cannot be detected when vehicle
speed is low.
SEL685V
Revision: August 2015
2016 Versa Note

cardiagn.com

AV-138
< SYSTEM DESCRIPTION >[NAVIGATION]
SYSTEM
SPEED SENSITIVE VOLUME SYSTEM
• Volume level of this system goes up and down aut
omatically in proportion to the vehicle speed.
• The control level can be selected by the customer.
HANDS-FREE PHONE SYSTEM
• Bluetooth® control is built into AV control unit.
• The connection between cellular phone and AV control unit is performed with Bluetooth
® communication.
• The voice guidance signal is input from the AV cont rol unit and output to the front speakers when operating
the cellular phone.
When A Call Is Originated
• Spoken voice sound output from the microphone (microphone signal) is input to AV control unit.
• AV control unit outputs to cellular phone with Bluetooth
® communication as a TEL voice signal.
• Voice sound is then heard at the other party.
When Receiving A Call
• Voice sound is input to own cellular phone from the other party.
• TEL voice signal is input to AV control unit by establishing Bluetooth
® communication from cellular phone,
and the signal is output to front speakers.
AROUND VIEW MONITOR FUNCTION
• This system is equipped with wide-angle cameras on the front, rear and right and left door mirrors.
• Images from front view, rear view, front-side view ( RH side), and birds-eye view are displayed to monitor the
vehicle surroundings.
• Around view monitor control unit expands the image received from each camera to create each view.
• In front view and rear view, the vehicle width, dist ance lines and predictive course lines are displayed.
• In front-side view, the vehicle distance guiding line and vehicle width guiding line are displayed.
• Birds-eye view converts the images from the camera s into an overhead view and displays the status of the
vehicle on the display. The vehicle icon that is displayed in the birds-eye view is depicted by the around view
monitor control unit.
Display
The around view monitor combines and displays travel direct ion view (front or rear), front-side view and birds-
eye view.
Operation
• The around view monitor operates by pressing the CAMERA switch on the AV control unit or by shifting the
selector lever to the R (reverse) position.
• When the selector lever is in any position other than R (reverse) and the CAMERA switch is pressed, the
screen displays front travel direction view and bird s-eye view. Pressing the CAMERA switch again changes
birds-eye view to front-side view
• When the selector lever is placed in R (reverse), the screen displays rear travel direction view and birds-eye view. Pressing the CAMERA switch changes birds-eye view to front-side view
JSNIA3982GB
Revision: August 2015 2016 Versa Note

cardiagn.com

AV
SYSTEMAV-139
< SYSTEM DESCRIPTION > [NAVIGATION]
C
D
E
F
G H
I
J
K L
M B A
O P
• In birds-eye view, the blind spot area is displayed in black to show the border of the camera images. In addi- tion, red fixed lines are displayed in the 4 corners of the vehicle icon. After pressing the CAMERA switch for
the first time or placing the selector lever in R (rever se) for the first time, the blind spot area is highlighted in
yellow for 3 seconds and the red fixed lines blink five times.
• With the selector lever in any position other than R (reverse), the around view monitor screen display is can- celled 3 minutes after pressing the CAMERA switch. The screen returns to the AV control unit display.
• With the selector lever in R (reverse) position, the around view monitor screen display remains on con- stantly. To return to the AV control unit display, place the selector lever is in any position other than R
(reverse).
• If camera image calibration is incomplete, the applicable camera position is indicated as an error on the birds-eye view display.
NOTE:
Calibration is necessary when replacing each camera or when replacing around view monitor control unit.
Around view monitor screen transition
Front View
• The front view image improves the visibility of obstacles in front of the vehicle and assists driving by display-
ing images from birds-eye view and front-side view.
• The front view image displays the vehicle width guiding line and vehicle distance guiding line, in addition to the predictive course line according to the steering angle.
• If the steering angle is within approximately 90 degrees, t he predictive course lines on the left/right side are
displayed. If the steering angle exceeds approximat ely 90 degrees, only the predictive course line on the
outside is displayed (opposite side of steering direction).
• The around view monitor control unit receives the steering angle signal from steering angle sensor via CAN
communication, and controls the direction and distance of the predictive course line.
• ON/OFF setting of predictive course line can be performed using CONSULT.
JSNIA4607GB
Revision: August 2015 2016 Versa Note

cardiagn.com

AV-140
< SYSTEM DESCRIPTION >[NAVIGATION]
SYSTEM
Front view guiding lines
Rear View• The rear view image improves the visibility of obstacles in the rear of the vehicle and assists backing and
parking by displaying images from birds-eye view and front side view.
• The rear view image displays the vehicle width guiding line and vehicle distance guiding line, in addition to the predictive course line according to the steering angle.
NOTE:
The predictive course line is not di splayed at the steering neutral position.
• The around view monitor control unit receives the steering angle signal from steering angle sensor via CAN
communication, and controls the direction and distance of the predictive course line.
• ON/OFF setting of predictive course line can be performed using CONSULT.
Rear view guiding lines
Front-Side View• The front-side view image improves the visibility of ob stacles in the front RH side of the vehicle and assists
backing and parking.
• The front-side view image displays the vehicle distance guiding line and vehicle width guiding line.
JSNIA0770GB
JSNIA4567GB
Revision: August 2015 2016 Versa Note

cardiagn.com

AV
SYSTEMAV-141
< SYSTEM DESCRIPTION > [NAVIGATION]
C
D
E
F
G H
I
J
K L
M B A
O P
Front-side view area and guiding line
Birds-Eye View• The birds-eye view image improves the visibility of obstacles all around the vehicle and assists backing and
parking.
• The images from the four cameras are converted in to an overhead view, and the surroundings of the vehicle
are displayed.
• The blind spot area is displayed on the image to specify the boundary of the four cameras.
Birds-Eye view display image
JSNIA0771GB
AWNIA3141GB
Revision: August 2015 2016 Versa Note

cardiagn.com

AV-142
< SYSTEM DESCRIPTION >[NAVIGATION]
SYSTEM
Birds-Eye view display area
AWNIA3142GB
Revision: August 2015
2016 Versa Note

cardiagn.com

AV
DIAGNOSIS SYSTEM (AV CONTROL UNIT)AV-143
< SYSTEM DESCRIPTION > [NAVIGATION]
C
D
E
F
G H
I
J
K L
M B A
O P
DIAGNOSIS SYSTEM (AV CONTROL UNIT)
DescriptionINFOID:0000000012433014
The AV control unit on board diagnosis performs the functions listed in the table below:
Perform CONSULT diagnosis if the AV control unit on board diagnosis does not start or the screen does not
display anything.
On Board Diagnosis FunctionINFOID:0000000012433015
METHOD OF STARTING
1. Turn the ignition ON.
2. Turn the audio system OFF.
Mode ItemContent
Ve r s i o n —Version data of the AV control unit is dis-
played.
User Configuration Touch Display Calibration
—Calibration of the touch panel display
can be performed.
Screenshot to USB —A screenshot of the display can be
saved to USB memory.
Time Interval —Destination time interval can be select-
ed.
Radio FM monitor
—
Monitors the dynamic values of the cur-
rent tuner
AM monitor —
SXM monitor —Version data is displayed.
System State Running System Status • SD card slot acces.
• Power Supply
• Speed Signal
• Direction Signal
• Illumination Signal
• GPS Antenna
• GPS tracking
• Satellites visible
• Satellites tracked
• Microphone Current
• Steer. wheel key
• Radio Antenna
• SXM Antenna
• USB Device
• iPod firmware ver.
• BT Status The current system status is displayed.
Sp ea ke r Tes t 4 kH z —This activates a sequence of test tone
outputs to the audio circuits one after the
other for 1 second.
Speaker Test 100Hz
Display-Test
—This provides a test sequence where
test displays (plain colored display: e.g.
white, black, red, blue, green) are shown
one after the other.
The respective color is shown for an in-
dicated period of time (parameter). After
the display test, the design of the display
previously available is stored. While the
screen shows a plain colored display, a
pixel malfunction may be detected.
Self Test • SD Card Access
• BT Module Access
• GPS Antenna
• Radio Antenna
• SXM Antenna A system self test is executed and the
results are stored into the error memory.
Revision: August 2015
2016 Versa Note

cardiagn.com