2016 Hyundai Equus Owner's Manual

7-68
Maintenance
Engine compartment sub fuse panel
Fuse Name Fuse ratingCircuit Protected
ALT 200AAlternator, E/R Fuse & Relay Box (Fuse - I/P POWER RH,
EHPS, C/FAN, PDM (ACC), ECS, TRUNK, AMP,
POWER OUTLET FRT)
I/P POWER LH 80A Smart Junction Box LH (Fuse - PDM (B+), HAZARD, EPB,
RF RECEIVER, SMART KEY, P/HANDLE, TPMS,
STOP LAMP, SHIFT LEVER (B+), P/SEAT PASS,
RH SAFETY POWER WINDOW, MULTI MEDIA, LH SAFETY
POWER WINDOW, 1 MODULE, F/LID, ECS, O/S HDL DRV,
S/HEATER RR, O/S HDL RR, DR LOCK DRV,
S/HEATER DRV, DR LOCK PASS, P/TRUNK,
Leak Current Autocut Device)
I/P POWER RH 60A I/P Junction Box RH (Fuse - USB CHARGE, P/SEAT RR,
SUNROOF, O/S HDL RR, LEG SUPPORT RR,
S/HEATER PASS, O/S HDL PASS, S/HEATER RR)
C/FAN 70A C/FAN Relay EHPS 80A EHPS Module
ESC 1 40A ESC Module, Multipurpose Check Connector
ESC 2 40A ESC Module, Multipurpose Check Connector
PDM (IG1) 40A PDM (IG1) Relay
PDM (IG2) 30A PDM (IG2) Relay
P/SEAT (DRV) 30A Driver IMS Control Module, Driver Lumbar Support Valve ECS 40A ECS Relay
AMP 30A AMP
PDM (ACC) 30A PDM (ACC) Relay
STOP LAMP 15A Stop Signal Electronic Module B/UP LAMP 10A B/UP LAMP Relay
POWER OUTLET FRT 25A POWER OUTLET FRT Relay
TRUNK 10A TRUNK Relay

7-69
Maintenance07
L
LI
IG
G H
H T
T
B
B U
U L
LB
B S
S
Use only the bulbs of the specified
wattage.
Make sure to replace the burned-
out bulb with a new one of the
same wattage rating. Otherwise, it
may cause damage to a fuse or an
electric wiring system.
When you are not equipped with
necessary tools, the appropriate
bulbs and the expertise, consult an
authorized EQUUS dealer. In many
cases, it is difficult to replace vehi-
cle light bulbs, because some parts
of the vehicle must be disassem-
bled before getting to the bulb. This
is especially true when disassem-
bling to replace the headlamp
bulb(s). Removing/installing the
headlamp assembly may damage
your vehicle.
Information
After heavy rain or vehicle washing,
headlamp and taillight lenses may
appear to be frosty. This is caused by
the temperature difference between
the lamp inside and outside. This is
similar to the dew condensation on
your windows inside while raining.
This does not indicate a problem with
your vehicle. When water penetrates
into the lamp circuitry, have the vehi-
cle checked by an authorized EQUUS
dealer.
i
NOTICE
NOTICE
- Working on the lights
Before working on the light,
firmly set the parking brake,
turn the ignition switch to the
LOCK position, and turn OFF
the lights. These are to prevent
a sudden vehicle movement,
burning your fingers or an elec-
tric shock.
WARNING

7-70
Maintenance
Headlight, position light, turn
signal light, side marker light
and front fog light bulb
replacement
(1) Position light
(2) Headlamp (High)
(3) Headlamp (Low)
(4) Front side marker light
(5) Front turn signal light
(6) Front fog light
1. Open the hood.
2. Disconnect the negative batterycable.
3. Press the fastener to open the cover.
4. Open the cover. 5. Pull out the cover (if equipped).
6. Insert a screw driver into the hole
(1) and lift up the screw driver
while pulling out the cover (2).
7. Remove the fastener and screw under the wheel arch.
OVI075030N
OVI075179N
OVI075113N
if equipped
OVI075114N
if equipped
OVI075180N

7-71
Maintenance07
8. Pull out the bumper.
9. Remove 4 fasteners on the grilleand the bolt. 10. Remove the front bumper.
11. Be careful not to damage the
clips inside of the front bumper.
12. When replacing the headlamp on the right side, remove the bolts
and the air cleaner.
OVI075181N
OVI075182N
OVI075185N
OVI075183N
OVI075184N

7-72
Maintenance
13. Remove the mounting bolts.
14. Pull the headlamp assembly out from the vehicle.
15. Remove the clips.
16. Disconnect the power connec- tor(s) from the back of the head-
lamp assembly.
Headlight (HID type) bulbreplacement (if equipped)
When the headlamp does not oper-
ate, have the vehicle checked by an
authorized EQUUS dealer.
Your High Intensity Discharge
(HID) headlamp, equipped with
your vehicle, contains mercury.
When scrapping your vehicle, the
HID Headlamp should be properly
disposed of in advance. The
removed HID headlamp should be
recycled, re-used or disposed as
hazardous waste.
NOTICE
OVI075186N
OVI075187N
OVI079110L
- HID Headlamp low beam
(if equipped)
Do not attempt to replace or
inspect the low beam (XENON
bulb) to avoid an electric shock
danger. When the low beam
(XENON bulb) does not operate,
have your vehicle checked by
an authorized EQUUS dealer.
WARNING

7-73
Maintenance07
Information
HID lamps have superior perform-
ance in comparison to halogen bulbs.
HID lamps are estimated to last twice
as long as halogen bulbs, or longer, by
the manufacturer, depending on the
usage hours. HID lamps needs to be
replaced at some point within the
vehicle life. Frequent turning the
headlamps ON and OFF shortens the
HID lamps life. HID lamps do not
blow out in the same manner as halo-
gen incandescent lamps. When a
headlamp blows out after a period of
operation, the lamp light gradually
fades away after being turned ON.
Even when the lamp is turned ON by
turning ON the switch, it needs to be
replaced. The HID lamp components
are more complex than the ones of
conventional halogen bulbs. Thus, the
repairing costs are more expensive.
Headlight (bulb type), front turnsignal, position, side markerand fog light bulbs
When a bulb is out, have the vehicle
checked by an authorized EQUUS
dealer.
Headlamp bulb i
OKH073081N.
- Halogen bulbs
Halogen bulbs contain pres-
surized gas. Thus, if broken, it
produced fragments of glass.
bulbs to avoid scratches and
abrasions. If the bulbs are lit,
avoid contact with liquids.
Never touch the glass with bare hands. Any remaining oil
may cause the bulb to over-
heat and explode upon being
lit.
When a bulb is damaged or cracked, immediately replace
it. Then, carefully dispose of it.
Wear eye protection while replacing a bulb. If hot, cool
down the bulb before han-
dling it.
WARNING

7-74
Maintenance
17. Remove the headlamp cover by turning it in a counterclockwise
direction.
18. Disconnect the headlamp bulb socket connector.
19. Loosen the wire, which holds the headlamp, by depressing the end
and pushing it upward.
20. Remove the bulb from the head- lamp assembly.
21. Install a new headlamp, and fas- ten the headlamp wire by align-
ing it with the groove.
22. Connect the headlamp socket connector.
23. Close the headlamp cover by turning it in a clockwise direction.
24. Connect the power connector(s) to the back of the headlamp
assembly.
25. Reinstall the headlamp assembly to the vehicle.
Information
Always readjust the headlamp angle,
after an accident or the headlamp
installment by an authorized EQUUS
dealer. When the headlamp (Low) does
not operate, have the vehicle
checked by an authorized EQUUS
dealer.
Turn signal light - bulb type
When the light bulb does not oper-
ate, have the vehicle checked by an
authorized EQUUS dealer.
Position light, Front fog light
When the light bulb does not oper-
ate, have the vehicle checked by an
authorized EQUUS dealer.
Side repeater light bulb
replacement (if equipped)
If the light bulb is not operating, have
the vehicle checked by an authorized
EQUUS dealer.
NOTICE
i
OVI075111N
OVI075031N

7-75
Maintenance07
Rear combination light bulb
replacement
(1) Stop, tail light and side marker
(2) Rear turn signal light
(3) Back-up light
Rear back-up light
When the light bulb does not oper-
ate, have the vehicle checked by an
authorized EQUUS dealer.
Turn signal, stop and tail light
When the light bulb does not oper-
ate, have the vehicle checked by an
authorized EQUUS dealer.
A skilled technician should check
or repair the rear combination
light. Otherwise, it may damage
related parts of the vehicle.
High mounted stop light
1. Remove the rear seat
5 Seater
1.Disconnect the negative batterycable.
2.Remove the rear seat cushion.
NOTICE
OVI075032NOVI075035N
OVI075120N