2016 Citroen C4 PICASSO instrument panel

41
C4-Picasso-II_en_Chap01_instruments-bord_ed01-2016
Engine oil level indicator*
On versions fitted with an electric oil level
indicator,  the   state   of   the   engine   oil   level   is  
d

isplayed in the instrument panel for a few
seconds,
  after   the   servicing   information.
The level read will only be correct if
the
  vehicle   is   on   level   ground   and   the  
e

ngine   has   been   off   for   more   than  
3

0 minutes.
Oil level correct
Oil level incorrect
This is indicated by the display of the message "Oil level incorrect" in the instrument panel
screen,
  accompanied   by   the   service   warning  
l

amp   and   an   audible   signal.
If
  the   low   oil   level   is   confirmed   by   a   check   using  
t

he   dipstick,   the   level   must   be   topped   up   to  
a

void   damage   to   the   engine.
For more information on Checking levels,
refer
  to   the   corresponding   section.
Oil level indicator fault
This is signalled by the display of the message "Oil level measurement invalid" in the
instrument
 pan

el.
Contact a CITROËN dealer or a qualified
workshop.
In the event of a fault with the electric indicator,
the
  oil   level   is   no   longer   monitored.
If
  the   system   is   faulty,   you   must   check   the  
e

ngine   oil   level   using   the   manual   dipstick  
l

ocated   under   the   bonnet.
For more information on Checking levels,
refer
  to   the   corresponding   section.
* Depending on version.
1
Instruments

42
C4-Picasso-II_en_Chap01_instruments-bord_ed01-2016
AdBlue® fluid range indicators
Once the AdBlue® tank is on reserve or after d
etection of a fault with the SCR emissions
control
 
system,
 
when   the   ignition   is   switched  
o

n, an indicator displays an estimate of the
distance
 
that
 
can
 
be   covered,   the   range,   before  
e

ngine
 
starting
 
is
 
prevented.
In the event of simultaneous system fault and
low AdBlue
® level, the shortest range figure is t
he
 
one
 
displayed. Range greater than 1 500 miles (2 400 km)
When
  the   ignition   is   switched   on,   no  
i

nformation   on   range   is   displayed   automatically  
i

n   the   instrument   panel.
With   the   type   2   instrument   panel,   pressing   this  
b

utton   temporarily   displays   the   driving   range.
In the event of the risk of non-starting related to a lack of AdBlue®
The engine start prevention system required   by   regulations   is   activated  
a

utomatically once the AdBlue
® tank is e
m pt y.
Instruments

46
C4-Picasso-II_en_Chap01_instruments-bord_ed01-2016
Lighting dimmer control
Allows the manual adjustment of the brightness of the instrument panel and touch screen tablet to suit   the   ambient   light   level.
Operates
  only   when   the   vehicle   lighting   is   on,   with   the   exception   of   the   daytime   running   lamps.
Tw o b u t t o n s
With the exterior lighting on, press button A
t o   increase   the   brightness   of   the   instruments  
a

nd   controls   and   the   interior   mood   lighting   or  
b

utton B   to   reduce   it.
As
  soon   as   the   lighting   reaches   the   required  
l

evel   of   brightness,   release   the   button.
Touch screen tablet
F In the Configuration menu, select
" Brightness ".
F
 
A
djust   the   brightness   using   the   arrows   or  
b

y   moving   the   cursor.
Instruments

47
C4-Picasso-II_en_Chap01_instruments-bord_ed01-2016
When driving at night, this function allows certain displays in the instrument panel to be
switched
  off   to   avoid   visual   fatigue   for   the   driver.
The essential information, such as the speed of
the vehicle or the cruise control or speed limiter
indications remains displayed in the instrument
panel.
Using the steering mounted
control
F With   the   vehicle   lighting   on,   press   this  b
utton   again   to   activate   the   black   panel.
F
 
P
ress   this   button   again   to   deactivate   it.
Black screen (touch screen
tablet)
Black panel (comfortable
night driving display)
F In the Configuration
menu, select "Dark". T
he   screen   of   the   touch   screen   tablet   goes  
o

f f.
 F

 
P
ress   the   screen   again   (anywhere   on   its  
s

ur face)   to   switch   it   on   again.
1
Instruments

48
C4-Picasso-II_en_Chap01_instruments-bord_ed01-2016
Tr i p c o m p u t e r
Type 1 instrument panel
System that gives you information on the journey in progress (range, fuel consumption…).
Information display in the touch screen tablet
Permanent display:
F Sel ect the " Trip computer " in the
Applications
 

menu.
The trip computer information is displayed in
tabs.
F

P
ress one of the buttons to display the
desired
 t

ab. The
  current   fuel   consumption   tab   with:
-  
t
he   range,
-
t
he current fuel consumption,
-  
t
he   Stop   &   Start   time   counter.
The trip "1"
 
tab   with:
-
t
he distance travelled,
-  
t
he   average   fuel   consumption,
-  
t
he   average   speed,  
 
f
or   the   first   trip.
The trip "2"  tab   with:
-

t
he distance travelled,
-
 
t
he   average   fuel   consumption,
-
 
t
he   average   speed,  
 
f

or   the   second   trip.
Trip reset
F When the desired trip is displayed, press the reset button or on the end of the wiper
control
  stalk.
Tr i p s "1" and "2" are independent but their use
is
  identical.
For
  example,   trip   "1" can be used for daily
figures,
  and   trip   "2"
 
for   monthly   figures.
The information is accessible in the Driving
 

menu.
Temporary
 
display
 
in
 
a
 
new
 
window:
F
 
P

ress
 
the
 
end
 
of
 
the
 
wiper
 
control
 
stalk
 
for
 
a

ccess to the information and display the
different
 
tabs.
Instruments

49
C4-Picasso-II_en_Chap01_instruments-bord_ed01-2016
Tr i p c o m p u t e r
Type 2 instrument panel
Information display in the instrument panel
F Press the button on the end of the wiper control stalk to display the various tabs in
succession. -
 
T
he   current   information   tab   with:
●  
t
he   range,
●  
t
he   current   fuel   consumption,
●  
t
he   Stop   &   Start   time   counter.
- Trip
"1"
 w
ith:
●  
t
he   average   speed,
●  
t
he   average   fuel   consumption,
●  t he   distance   travelled, f
or   the   first   trip.
-
Trip "2"
 w

ith:
●
 
t
he   average   speed,
●
 
t
he   average   fuel   consumption,
●
 
t
he   distance   travelled,
 f

or   the   second   trip.
Trip reset
F When the trip required is displayed, press the control for more than two seconds
or use the left hand thumbwheel of the
steering
  mounted   controls.
Tr i p s "1" and "2" are independent but their use
is
  identical.
For
  example,   trip   "1" can be used for daily
figures,
  and   trip   "2"
 
for   monthly   figures.
For
 
all
 
other
 
display
 
modes,
 
pressing
 
the
 
end
 
o

f
 
the
 
wiper
 
stalk
 
displays
 
this
 
information
 
in
 
a
 
n

ew
 
window.
The display of trip computer information is
permanent when you select the "Dials" or
"Personal"
 
display
 
mode.
1
Instruments

60
C4-Picasso-II_en_Chap02_ouvertures_ed01-2016
Manual central locking
Central locking
F Press this button to operate the central locking   of   the   vehicle   (doors   and   boot)   from  
i

nside   the   vehicle.
F
 
P
ressing   the   button   again   unlocks   the  
v

ehicle
 c
ompletely.
Automatic central locking
of doors (anti-intrusion
security)
The doors and boot lock automatically when driving,   as   soon   as   the   speed   exceeds   6   mph  
(

10   km/h).
To activate or deactivate this function (activated
by
  default):
F
 
w
ith   the   ignition   on,   press   this   button   until   a  
m

essage   appears   in   the   instrument   panel.
When locking / deadlocking from the
outside
If
 
the
 
vehicle
 
is
 
locked
 
or
 
deadlocked
 
f

rom the outside, the button is not
active.
F
 
A

fter
 
normal
 
locking,
 
pull
 
one
 
of
 t

he
 
interior
 
door
 
handles
 
to
 
unlock
 t

he vehicle.
F
 
A

fter
 
deadlocking,
 
you
 
have
 
to
 
use
 t

he remote control, the Keyless Entry
and
 
Starting
 
system
 
or
 
the
 
integral
 k

ey
 
to
 
unlock
 
the
 
vehicle. If one of the doors or the boot is
open,
  automatic   central   locking   does  
n

ot   complete:   the   sound   of   the   locks  
r

ebounding   can   be   heard.
Transporting long or voluminous
objects
If you want to drive with the boot open
but
  the   vehicle's   side   doors   locked,  
p

ress   the   central   locking   control   button  
t

o   lock   the   doors.
Driving
  with   the   doors   locked   may   make  
a

ccess   to   the   passenger   compartment  
b

y   the   emergency   services   more  
d

ifficult   in   an   emergency.
Access

61
C4-Picasso-II_en_Chap02_ouvertures_ed01-2016
Doors
Opening
From outside
F After  unlocking   the   vehicle   using   the  r
emote control or the Keyless Entry and
Starting
  system,   pull   the   door   handle.
From inside
F Pull the front or rear door lever to open the door. If
  a   door   is   not   properly   closed:
-
w
ith the engine running
, this
warning   lamp   and   a   message  
ap

pear in the instrument panel
(type 1) for a few seconds,
-
wh
en driving
(speed above
6   mph   (10   km/h)),   this  
w

arning   lamp   and   a   message,  
a

ccompanied by an audible
signal,   appear   in   the   instrument  
p

anel (type 1 and type 2) for a
few   seconds.
Closing
2
Access